查询词典 boundary condition

The result shows that the mixed boundary condition can greatly reduce the calculation area without affecting accuracy of the solution.It is followed by the higher accuracy of Dirichlet boundary condition which makes the boundary error greater when measured points is near the boundary, so we must take a sufficiently large border region.The homogeneous boundary condition has relatively large error, but the use of non-triangle poles devices makes apparent resistivity calculation error become small, because of elimination of the effect on potential difference for the infinite boundary. In inversion, in order to save computing time, homogeneous boundary conditions are often used to perform finite element forward calculation.

结果表明，混合边界条件精度最高，可大大缩小求解区域而不影响计算精度，其次是Dirichlet边界条件精度较高，但测点越靠边界误差会越大，必须取足够大的边界区域，齐次边界条件的误差比较大，但如果采用非二极装置，通过电位差计算得到的视电阻率，由于无穷远边界对电位差的影响基本消除，视电阻率计算误差与混合边界条件下的接近，在反演中，为了节省计算时间，经常使用齐次边界条件进行有限元正演。

We have also presented the ω-circulant boundary condition and compared it with the helix boundary condition. Furthermore, we can also get another new boundary condition: the mixed boundary condition.

由此我们提出了ω循环型边界条件并将其与普通循环型及螺旋型边界条件作了分析和比较；进一步地，得到了一种新的边界条件：混合型边界条件。

Compared with the known results,the nonlinearity is allowed to change sign and is involved with the first-order derivative explicitly.In particular,the boundary condition includes the Dirichlet boundary condition and Robin boundary condition.

与现有工作相比，我们所考虑的动力方程不但非线性项可变号，而且包含一阶导数项，所考虑的边值条件更具一般性，比如可以包含Dirichlet及Robin边值条件等。

We can not apply Galerkin methods with radial basis functions to the first boundary value problem (the Dirichlet boundary value problem) of the second-order elliptic equation, because it requires that the approximate functions should fit the essential boundary condition, while the spaces spanned by the radial basis functions fails to satisfy this kind of boundary condition, and it is the same for the higher-order elliptic equation.

我们不能直接应用这样的无网格算法求解二阶椭圆型方程的第一类边值问题(Dirichlet边值问题)，因为第一类边界条件是本质边界条件(对二阶椭圆型方程为Dirichlet边界条件)，而径向基函数的支集通常是全空间，由它们所生成的近似函数空间一般不满足这样的条件。

Second order incident boundary condition on fixed incident boundary is derived for numerical simulations, based on the cnoidal or sinusoidal motions of wave maker paddle, which shows that the prediction with second order incident boundary condition is more accurate than the prediction with first order incident boundary condition. 2 The analytical solution for higher-order Boussinesq equations is derived and its applicable range is discussed. 3 A 2-D fully non-linear numerical model using boundary element method is developed to obtain wave forces acting on rectangular obstacle. 4 The three-dimensional fully non-linear waves are studied in a numerical wave tank using finite element method.The studies on the coupled numerical model combined Boussinesq equations with Laplace equation are following.

非耦合非线性波浪计算模型：1 根据造波板做椭圆余弦运动或正弦运动速度，推导出数值模拟波浪水槽时固定入射边界上的二阶波浪入射边界条件，数值计算结果和实验结果的对比表明采用二阶入射边界条件对波面升高的预报比采用一阶入射边界条件对波面升高的预报更为精确；2 推导了波浪水槽造波板做正弦运动所产生波浪的高阶Boussinesq方程摄动展开解析解，讨论了该解析解的适用范围；3 对整个波浪水槽应用边界元方法数值模拟了波浪对物体的非线性作用；4 用有限元法求解三维Laplace方程模拟了三维完全非线性波浪水槽。

The modal tests of PCB and PCB assembly (free boundary condition and fixed boundary condition) were carried out. The equivalent elastic modulus and damping parameters of PCB can be gained, and the fixed boundary condition of finite element model was also determined. These will help to the following work.Second, drop impact tests of three different heights were carried out. Strains and acceleration responses of PCB were measured. Failed BGA packages of different test conditions were dyeing, and cross section analysis of failed solder joints was conducted.

针对JEDEC标准试件的局限性，提出了设计便于统计学研究焊点可靠性的试验试件的构想，利用有限元模态分析方法确定并验证了用圆形PCB组件替代JEDEC标准试件的可行性；通过一系列模态试验和有限元模态分析，确定了圆形PCB组件的相关试验参数，这不仅为跌落碰撞下PCB组件有限元模拟确定了较为合理准确的有限元模型，而且为正确地评价跌落碰撞下PCB组件的可靠性问题奠定了基础。2。

The modal tests of PCB and PCB assembly (free boundary condition and fixed boundary condition) were carried out. The equivalent elastic modulus and damping parameters of PCB can be gained, and the fixed boundary condition of finite element model was also determined. These will help to the following work. Second, drop impact tests of three different heights were carried out. Strains and acceleration responses of PCB were measured. Failed BGA packages of different test conditions were dyeing, and cross section analysis of failed solder joints was conducted. It was found in our drop tests that the root cause of lead-free solder joints under drop impact was the combined effect of mechanical shock and PCB bending vibration.

针对JEDEC标准试件的局限性，提出了设计便于统计学研究焊点可靠性的试验试件的构想，利用有限元模态分析方法确定并验证了用圆形PCB组件替代JEDEC标准试件的可行性；通过一系列模态试验和有限元模态分析，确定了圆形PCB组件的相关试验参数，这不仅为跌落碰撞下PCB组件有限元模拟确定了较为合理准确的有限元模型，而且为正确地评价跌落碰撞下PCB组件的可靠性问题奠定了基础。

Assign the Boundary conditions 5,设置边界条件 A natural air cooling heat Boundary condition will be applied all around the sand box, a velocity Boundary condition will be applied and a temperature Boundary condition will be imposed to some nodes of the top surface of the down sprue.

砂型周围是一个自然空气冷却的热边界条件。一个速度边界条件和一个温度边界条件将被设置到直浇口的上平面的一些节点上。

Chapter 3 emphasizes on the case that the considered systems contain not only impulse but also time delay. We mainly investigate impulsive parabolic systems with time delay and neutral impulsive parabolic systems. Section 3.1 discusses the oscillation of impulsive parabolic systems with time delay under Robin boundary condition and obtains some useful criteria via first order impulsive differential inequalities with time delay. Section 3.2 studies the oscillation of neutral impulsive parabolic systems under Neumann boundary condition and Robin boundary condition, respectively, and obtains some sufficient conditions for oscillation and strong oscillation via first order neutral impulsive differential inequalities.

第三章针对于"脉冲"与"时滞"共存的复杂情形，仍采用反证法讨论了含时滞的脉冲偏微分系统的振动理论，具体研究了脉冲时滞抛物系统和中立型脉冲时滞抛物系统。3.1节考虑了脉冲时滞抛物系统的振动理论，借助于一阶脉冲时滞微分不等式的解的性质，得到了满足Robin边界条件的脉冲时滞抛物系统的若干振动准则；3.2节考虑了中立型脉冲时滞抛物系统的振动理论，借助于一阶中立型脉冲时滞微分不等式的解的性质，分别给出了满足Neumann边界条件和Robin边界条件的中立型脉冲时滞抛物系统的若干振动和强振动准则。

This method allows for a more accurate processing of boundary condition on the semiconductor layer in XLPE cable of stator winding than the standard finite element, so that the interlaminated issue of boundary condition on interface can be avoided. A general algorithm is applied to deal with both the Dirichlet and the periodic boundary condition in 2D or 3D magnetic field problem.

提出了用有限元法计算磁场问题时周期性边界条件和第一类边界条件的统一处理方法，利用该方法在不改变代数方程组阶数、保持系数矩阵性质不变和带宽基本不变的条件下，使两种强加边界条件能同时处理，简化了程序编制，并与寻址方法相结合，提高了计算速度。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了