查询词典 bottom-line

The bottom hem can be cinched tight by elastic shock cord, also located beside the main zipper instead of at the bottom sides as on the PCU. They're no longer exposed and won't snag.

底部的卷边可以使用收缩绳来系得更紧一点，绳子位于住拉链的后面，而不是像PCU那样位于底部，并且绳子也不会露出来，也不会被划破。

Assuming the initial shape of a skirt to be an n-sided cylinder, the shape of its bottom edge can be modified by changing the distance between each edge and the centroid of bottom plane according to the amplitude of sine curve at corresponding angle.

所显示是一个n支持的圆筒，它的下缘形状可以被改变每个边缘和底下飞机之间矩心的距离修改根据高度正弦曲线在对应的角度。

Results show that amplitude of displacement excited by vertical incidence wave is larger than that excited by inclined incidence wave and not influenced greatly by the incidence angle. In vertical incidence, amplitudes of displacement of two points at the same altitude along each cavern are basically identical and maximum relative displacement occurs between top and bottom point of the cavern. While in the case of inclined incidence, displacement amplitude on sides meeting the wave is larger than that on leed sides, and maximum relative displacement occurs on left skewback and bottom of the cavern.

结果表明，位移幅值受入射角度的影响不敏感，竖直入射比斜入射情况要大；竖直入射时，各洞室两侧同一高程处的位移幅值基本相同，相对位移差最大部位为洞顶与洞底，而斜入射时迎波面比背波面一侧位移大，且相对位移差最大部位为洞室迎波面的左拱座与洞底。

If you follow what I've tried to explain, the weight will sit on the bottom with the skipjack about 3" or 4" above the bottom.

如果你搞明白了的话继续，鱼饵" skipjack "在离底8-10厘米拖动。

General requirements at the bottom of the handing of resin Edition font on the slide Lee, should not be sticky, but there is not enough because of the exposure of radiofrequent-stick at the bottom of the font soft state, it's easy to adhereto inks, ink accumulated and dry up in light-weight.

凡是给求树脂版字体底部手感上有滑利不收觉，不答不收粘，但由于曝光不敷，字体底部呈粘软状况，很便当粘住油不朱，油不朱越积越众并潮燥在细线本质。

If leather sandal sole is accumulated have mud, should brush bottom of; copy skin or balata bottom to dip in with the brush with dry brush bath is clean.

皮凉鞋鞋底如积有污泥，要用干刷子刷；仿皮底或橡胶底则用刷子蘸水洗净。

In the light of structure and operation behavior of oil tank, an overall investigation on the bottom plate corrosion of oil tank is made. The paper analyses the corrosion mechanism of bottom plate of oil tank located in pumping station, puts forward some protection measures including improving the technology design of oil tank, applying available steel material and utilize the CP technology.

针对原油罐的构造和运行特点，对罐底板腐蚀的情况进行了全面调查，分析了输油站内原油罐底板的腐蚀机理，提出了改进油罐工艺设计、选用合适的材料以及利用阴极极化原理的阴极保护等多项防护措施。

The properties of TCC with ATS were as good as the TCC with HTS, better that the requirement of standard GB8744-88 for semi-graphitic carbon block. As good as TCC with HTS in industrial cells, the TCC with ATS also reduces the sodium penetration to cathodic lining, no tear-off of the coating was found after starting up of the cells. As compared with reference cells, the operation of coating cells with ATS was also improved to keep good shape of cell chamber, reduce the formation of sludge on the cell bottom, and gain more uniform current distribution. The ohmic drop of TCC cell bottom was lessened by 11. 5mV. The current efficiency was increased by about 1. 48% in average. It was estimated that the TCC life could be 44 months. Obviously, the TCC with ATS could also improve the performance of industrial cells, save energy, and increase the cell life.

对常温固化涂层槽的考核表明，与高温固化涂层槽一样，阴极内衬对钠的吸收减少，钠渗透速度减缓，从而减小钠膨胀危害，减少了铝电解槽早期破损的几率；启动后，常温固化涂层不脱落，同样具有良好的粘接性能；与对比槽相比较，常温固化涂层槽正常生产后，阴极表面干净、光洁，无沉淀或结壳，炉膛规整，阴极、阳极电流分布均匀，炉底压降降低（平均降低11.5mV），电流效率提高（平均提高1.48％）；涂层在电解槽内存在的时间可达到44个月以上；常温固化涂层同样可以起到改善电解槽工作状态、节能降耗、延长槽寿命的作用。

The properties of TCC with ATS were as good as the TCC with HTS, better that the requirement of standard GB8744-88 for semi-graphitic carbon block.AbstractAs good as TCC with HTS in industrial cells, the TCC with ATS also reduces the sodium penetration to cathodic lining, no tear-off of the coating was found after starting up of the cells.As compared with reference cells, the operation of coating cells with ATS was also improved to keep good shape of cell chamber, reduce the formation of sludge on the cell bottom, and gain more uniform current distribution. The ohmic drop of TCC cell bottom was lessened by ll.SmV. The current efficiency was increased by about 1 .48% in average. It was estimated that the TCC life could be 44 months.Obvi

对常温固化涂层槽的考核表明，与高温固化涂层槽一样，阴极内衬对钠的吸收减少，钠渗透速度减缓，从而减小钠膨胀危害，减少了博士学位论文摘要铝电解槽早期破损的几率；启动后，常温固化涂层不脱落，同样具有良好的粘接性能；与对比槽相比较，常温固化涂层槽正常生产后，阴极表面干净、光洁，无沉淀或结壳，炉膛规整，阴极、阳极电流分布均匀，炉底压降降低(平均降低11.smv)，电流效率提高(平均提高1.48%)；涂层在电解槽内存在的时间可达到44个月以上；常温固化涂层同样可以起到改善电解槽工作状态、节能降耗、延长槽寿命的作用。

The trenches of the trenched isolation regions can include narrow bottom portions and upper wide portions over the bottom portions.

所述带沟槽隔离区的沟槽可包含较窄底部和位于所述底部上方的较宽上部。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失