查询词典 bordeaux mixture

A steel plate having a tensile strength of at least about 930 MPa (135Ksi), a toughness as measured by Charpy V-notch impact test at least about 120 joules (88 ft-lb), and a microstructure comprising at least about 90 volume percent of a mixture of fine-grained lower bainite and fine-grained lath martensite, wherein at least about 2/3 of said mixture consists of fine-grained lower bainite transformed from unrecrystallized austenite having an average grain size of less than about 10 microns and comprising iron and specified weight percentages of the additives: carbon, silicon, manganese, copper, nickel, niobium, titanium, aluminum, calcium,rare earth metals, and magnesium, is prepared by heating a steel slab to a suitable temperature; reducing the slab to form plate in one or more hot rolling passes (10) in a first temperature range in which austenite recrystallizes; further reducing said plate in one or more hot rolling passes (10) in a second temperature range in which austenite does not recrystallize, quenching (12) said plate to a suitable quench stop temperature (16); and stopping said quenching and allowing said plate to air cool (18) to ambient temperature.

一种钢板，其抗拉强度至少约930MPa135ksi），在－40℃（－40°F）下，采用夏氏V型缺口冲击试验测定的韧性至少约120焦耳（88英尺－磅），并且其显微组织包含至少约90％体积的细晶粒的下贝氏体和细晶粒的板条马氏体的混合物，其中该混合物的至少约2／3由从平均粒径小于约10微米的未再结晶奥氏体转变而来的细晶粒的下贝氏体组成，而且，其中所述的钢板包含铁和特定重量百分比的添加元素：碳、硅、锰、铜、镍、铌、钛、铝、钙、稀土金属和镁，所述钢的制备过程为：将一钢板坯加热至一个适当的温度；在奥氏体可发生再结晶的第一个温度范围内，采用一个或多个热轧道次（10），将所述板坯轧制成板材；在奥氏体不发生再结晶的第二个温度范围，采用一个或多个热轧道次（10）进一步轧制所述板材；将所述板材淬火处理（12）至一个适当的淬火终止温度（16）；停止所述淬火处理并将所述板材空冷（18）至室温。

Using New Zealand rabbit ears cartilage makes chondrocyte suspension, Fibrinogen was mixed with D-hank's makes a final fibrinogen concentration of 50mg/ml mixture solution, then chondrocytes resuspend with fibrinogen solution, chondrocytes-seeded fibrinogen was mixed with thrombin (25U/ml in 40mM calcium choride) to make chondrocytes/fibrin glue polymer. Pluronic F-127 was mixed with D-hank's makes a final Pluronic F-127 concentration of 400mg/ml mixture solution, then chondrocytes resuspend with Pluronic F-127 solution to make chondrocytes/Pluronic F-127 polymer. The chondrocyte concentrations was 10 million chondrocyte/ml of polymer.

为确定纤维蛋白凝胶与Pluronic F-127在注射方式形成组织工程化软骨过程中的优劣，我们进行了如下实验：应用新西兰大白兔耳软骨获取软骨细胞并体外培养，纤维蛋白原应用D-hank's液配制为50mg/ml，然后以纤维蛋白原溶液重悬软骨细胞，再与40mM的氯化钙配制的25U/ml凝血酶混合形成软骨细胞—纤维蛋白凝胶复合物；Pluronic F-127应用D-hank's液配制为400mg/ml，同样用PluronicF-127溶液重悬软骨细胞而形成软骨细胞—Pluronic F-127凝胶复合物。

The 4# mixture with major ingredients of ,4chyranthes bidentata and Sanguisorba officinalis and the 8# mixture with major ingredient of Houttuynia cordata have the best inhibitory effect on P.

2组方抑菌实验结果表明，虽然单药黄连、五倍子、石榴皮、牛膝、地榆等的抑菌效果比较明显，但是按照不同的比例配伍后，并非所有实验组方均能表现突出的抑菌作用能力。

The method adopts the following steps: after mixed, phosphorus source, silicon source, aluminum source, an organic template agent, water and a precursor of the SAPO molecular sieve are hydrothermally crystallized for at least 0.1 hour at the temperature ranging from 110 to 260 DEG C to obtain the SAPO molecular sieve; wherein, the preparation method for the precursor of the SAPO molecular sieve has the following steps:, the molar ratio is 0.03 to 0.6 R:(Si0.01 to 0.98: Al 0.01 to 0.6: P0.01 to 0.6): 2 to 500 H2O; wherein, R stands for mixture solution of raw materials which is blended by the phosphorus source, the silicon source, the aluminum source, the an organic template agent and water of the template agent;, the mixture solution of raw materials prepared in step reacts at the temperature which is at least 50 DEG C lower than the crystallization temperature for at least 0.1 hour.

本发明通过采用包括以下步骤：将磷源、硅源、铝源、有机模板剂、水和SAPO分子筛前驱体混合后在110～260℃的温度下水热晶化至少0.1小时获得SAPO分子筛；其中SAPO分子筛的前驱体的制备包括以下步骤：将摩尔配比为0.03～0.6R∶(Si0.01～0.98∶Al0.01～0.6∶P0.01～0.6)∶2～500H 2 O，式中R代表模板剂的磷源、硅源、铝源、有机模板剂和水混合成原料混合液；将步骤制备的原料混合液在低于晶化温度至少50℃的温度下反应至少0.1小时的技术方案较好地解决了该问题，可应用于含氧化合物制烯烃催化剂的制备过程。

Firstly, a simple fluid-mixture type PPM algorithm for multicomponent flow, which combines the fluid-mixture model of Saurel/Shyue and the classical ParabolicPiecewise-Method , is developed to simulate the compressible high density-ratio multi-fluid flows.

首先本文发展了一套简单实用的混合型多介质PPM方法，结合Saurel/Shyue的计算模型和经典的PPM方法数值模拟高密度比的多介质可压缩流动问题。

The bioassays showed that the inhabitation rate of the mixture of two isomers, Z isomer and E isomer were reached 95%, 100% and 97% against Sphaerotheca fuliginea at 50 mg/L. The inhabitation rate of them was similar, so the mixture of the two isomers can be used without separation.

结果表明，当处理剂量为50 mg/L时，氯苯肟唑、Z-氯苯肟唑和E-氯苯肟唑的防效分别为95%、100%和97%，三者活性基本相当，故在实际中无须将两个异构体分离，混合体可直接应用。

The mixture of Galpi plus sucrose appeared to protect phospholipid vesicles during dehydration and rehydration to the same degree as did raffinose or the stachyose plus sucrose mixture.

甲基肌醇半乳吡喃糖和蔗糖混合对人工脂囊膜保护作用，其结果与棉子糖和蔗糖混合之保护作用相同。

However, if the two tastable substances comprising a taste mixture are sufficiently strong, they cannot mutually suppress each other to produce a tasteless mixture.

然而，如果组成一种混合物的两种可口的物质非常强烈的话，他们不会相互抑制以产生一种无味的混合物。

Polyester nanofiber can be prepared by electrospinning process from PET chips separately dissolving in three kinds of solvents,namely,the mixture solvent of phenol and tetrachloroethane ,trifluoroacetic acid and the mixture solvent of trifluoroace- tic acid and dichlormethane.

利用静电纺丝法制备聚酯纳米纤维，选择苯酚和四氯乙烷，三氟乙酸，三氟乙酸和二氯甲烷3种溶剂分别溶解PET切片进行静电纺丝，通过扫描电子显微镜对纤维表面形态进行观察，结果表明：三氟乙酸和二氯甲烷混合溶剂溶解PET制备的电纺纤维较好。

Preparation of trifluoroacetaldehyde and trifluoroacetic acid by trifluoroethanol catalytic oxidation;2. Polyester nanofiber can be prepared by electrospinning process from PET chips separately dissolving in three kinds of solvents,namely,the mixture solvent of phenol and tetrachloroethane, trifluoroacetic acid and the mixture solvent of trifluoroace- tic acid and dichlormethane.

利用静电纺丝法制备聚酯纳米纤维，选择苯酚和四氯乙烷，三氟乙酸，三氟乙酸和二氯甲烷3种溶剂分别溶解PET切片进行静电纺丝，通过扫描电子显微镜对纤维表面形态进行观察，结果表明：三氟乙酸和二氯甲烷混合溶剂溶解PET制备的电纺纤维较好。

More direct, directer ; most direct, directest

径直的，笔直的

Do you know how to use a chain saw?

你知道如何使用链锯吗？