查询词典 bit error ratio

Integrating trellis-coded modulation with threaded algebraic space–time block code, trellis-coded modulation space-time block code is presented, which has the advantage of full-diversity and small detection delay. Based on TCM pre-processing, the minimum distance between different codeword matrixes of the TCMST block code is maximized, so the average bit error rate of the TCMST block code is lower than that of the TAST block code at the same signal noise ratio.

TCMST分组码具有满发送分集度和检测延迟小等优点；由于采用了TCM预处理，使得不同TCMST分组码码字矩阵间的最小距离达到了最大化，因此在相同信噪比情况下，TCMST分组码具有比TAST分组码更低的平均误比特率。

Performance analysis and plenty of numerical simulation shows that the robust multiuser detector and its adaptive version have excellent performance of output signal-to-interference-plus-noise ratio, bit error rate, asymptotic multiuser efficiency and robustness even existing stronger MAI.

理论分析和仿真实验表明，即使在较强的多址干扰条件下，稳健的盲线性多用户检测及其自适应实现展示了优异的误码率、信干噪比以及渐进多用户有效性性能，对特征波形失配具有较强的稳健性，且自适应算法能快速收敛至稳态解。

Simulation results show that the proposed algorithm has a faster convergence rate and much less computational complexity, and the output bit error rate and signal-to interference-plus noise ratio performance are superier to the PASTd blind multiuser detection algorithm and close in on the singular value decomposition group blind multiuser detection algorithm.

仿真结果表明，所提算法收敛速度快，输出信干噪比和误码率性能优于PASTd盲多用户检测，逼近奇异值分解(singular value decomposition， SVD)群盲多用户检测，并保持了较低的计算复杂度。

Lecturing the technical requirements and constitution of light transmitter and receiver; the theory of noise of light receiver; analytic theories of signal/noise ratio and bit error rate for digital light receiver; technique of coding and decoding of line.

讲授光发送机和光接收机的组成及其技术要求；光接收机的噪声理论；数字光接收机的信噪比和误码率分析理论；线路编解码技术。

For the problem that the suppression of co-channel interference and suppression of noise can't be balanced in signal-to-jamming and noise ratio maximization method for the linear precoding of multiuser multiple-input multiple-output downlink systems, an improved scheme that the term of noise variance is modified as a piecewise linear function is proposed, in which the balance between suppression of co-channel interference and suppression of noise can still be maintained even when the noise variance is a small value through piecewise modifying the term of noise variance, and thus the bit error rate and capacity of the systems are further improved.

针对多用户多输入多输出系统下行链路线性预编码的信干噪比最大化方法中，共信道干扰抑制和噪声抑制不能有效平衡的问题，提出将其中的噪声方差项修正为以噪声方差为变量的分段线性函数的改进方案。该方案通过对噪声方差项的分段修正，在噪声方差的值较小时依然能够保持共信道干扰抑制和噪声抑制间的平衡，从而使系统的误比特率性能和容量得到进一步提高。

The error bit ratio performance formula for the block precoded OFDM system with zero forcing and squared error receivers in Rayleigh Raying channels is deduced in this paper.

推导了在瑞利衰落信道下的分组预编码正交频分多址调制系统，接收机采用迫零均衡和最小均方误差均衡的系统误码率公式。

Given bit error rate and signal to noise ratio and other parameters.

给出了误码率和信噪比等参数。

In the intersatellite coherent optical communication, the vibration of a satellite will lead to a pointing error of transmitting and receiving antennas, which will decrease the signal-to-noise ratio and increase the bit error rate. In this paper, the Rayleigh distribution is taken as the pointing error model caused by satellite vibration, and PSK homodyne communication scheme is used as an example to analyze the influence of the satellite vibration on the system instantaneous BER and average BER. The simulation calculation result of BER is given.

针对星间相干激光通信中卫星平台的振动造成发射天线和接收天线的瞄准角误差，使系统信号信噪比下降，误码率增加，该文以瑞利分布作为振动造成的瞄准角误差模型，结合高斯本振光和艾里信号光外差检测模型，以PSK零差通信体制为例分析卫星振动对系统的瞬时误码率和平均误码率的影响，给出误码率仿真计算结果。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐