查询词典 bio-science

In addition this paper,"Bio-Rad method," two parasitic wasps of the post-embryonic development the process of protein accumulation in young bees and the host Plutella xylostella in this process in vivo haemolymph protein content were measured and found that over time, was gifuensis parasitic larvae of the diamondback moth haemolymph protein content showed an upward trend in nearly a straight line, Ichneumonidae parasitic For example, in the early parasitic diamondback moth haemolymph protein content also showed the trend of slow growth, but in the mid-and late parasitic young bee about to be completed in the development of the host body when to stop feeding, a significant downward trend却呈, and significantly lower than the third day of its own protein content; on the same day of the different species of the diamondback moth parasitic wasp hemolymph protein content compared Ichneumonidae Parasitism of diamondback moth have hemolymph protein content than in the third and fourth day after the parasitic Braconidae hemolymph content to be high, but very different in the case of the fifth day, as evidenced by her side after the parasitic bee moth haemolymph protein content is cocoon of the parasitic bee hemolymph protein content of 0.7 times.

另外本文采用&Bio-Rad法&对两种寄生蜂胚后发育过程中幼蜂蛋白积累及寄主小菜蛾在此过程中体内血淋巴蛋白含量进行了测定，结果发现随时间的推移，被茧蜂寄生小菜蛾幼虫的血淋巴蛋白含量是呈近直线增加趋势，而对于姬蜂寄生来说，在寄生初期小菜蛾血淋巴蛋白含量也呈缓慢增长趋势，但在寄生中后期，幼蜂即将完成在寄主体内的发育取食停止时，却呈大幅下降趋势，且明显低于其自身第三天的蛋白含量；对同一天的被不同种寄生蜂寄生的小菜蛾血淋巴蛋白含量进行比较，姬蜂寄生过的小菜蛾血淋巴蛋白含量在第三天和第四天均比茧蜂寄生后的血淋巴含量要高，但在第五天的情况大不相同，表现为被姬蜂寄生后的小菜蛾血淋巴蛋白含量是被茧蜂寄生的血淋巴蛋白含量的0.7倍。

Objective: To determine the inhibitory effects of BIO-1211, a very late antigen-4 (vla-4) antagonist, on bronchoconstriction and neutrophil adhesion in rats.

目的：研究迟缓抗原－4(very late antigen-4， VLA-4)拮抗剂BIO-1211对大鼠支气管收缩和白细胞黏附反应的影响。

Autogenous bone powder collected when drilling hole, Bio-Oss implant materials and their mixture at 1:1 were implanted in artificial bone defect at bucca side, respectively, while non-implanted bone was served as blank control.

用种植转孔时收集的自体骨碎末、Bio-Oss骨移植材料及两者1∶1混合骨碎末恢复种植体颊侧单壁人为骨缺损，以未植骨作空白对照。

According to my knowledge, no one had yet used the BIO-RAD165-2110 type of eletrotransformation apparatus to transform Chlamydomonas reinhardtii.

根据文献查询，未见有关使用BIO-RAD165-2110 型电击仪对莱茵衣藻进行转化的报道。

(1)PAL is better entrapped by PAG with a T∶C ratio of 8∶30.(2)PAL immobilized by glutaric dialdehyde on Bio-Gel P-300 is better than by CDC.(3)The best one is the dehydration and redehydration method.(4)Immobilized and permeated PAL active yeast cells are resistant to trypsin digestion and retain its PAL activity.

(1)固定化酶活性采用T∶C比为8∶30明显高于8∶19；(2)以戊二醛将PAL固定于Bio-GelP300优于用DCD固定化的酶；(3)质脂体包被中以脱水再加水法对酶活性影响较少，脂类组成以磷脂酰胆碱：胆固醇：磷脂酰丝氨酸比值7∶2∶1最好；(4)固定化PAL活性酵母细胞能较好地抵抗人工肠液中胰蛋白酶的水解作用，亦能明显降低苯丙氨酸的浓度。

Results: No fiber layer and inflammatory tissues around any inserted implants were founded. New-grown osteoid tissue appeared faster in Bio-Ti implants than pure titanium and matured bone tissues comprise bone trabecula and Haversian canals appeared in 6 weeks, while at least 12 weeks needed to form matured bone tissue in control groups.

结果：所有种植体周围没有发现明显炎症组织或形成纤维层，Bio-Ti种植体组新生类骨组织生长较快，并于6w时已形成含有骨小梁及哈弗氏小管结构的较成熟骨组织，对照组12w时新生骨组织基本成熟。

In the field of x＜0.3, the breathing-mode distortions of BiO〓 octahedra create two kinds of inequivalent Bi atoms.

当x＜0.3时，BiO〓八面体的呼吸模式形变形成了两种不等价的铋原子。

Little is known about iZumi Bio, and this exacerbates Japanese fears.

对iZumi Bio的知之甚少加剧了日本人的忧虑。

Kazuhiro Sakurada, who led the research arm of drug company Bayer Yakuhin in Kobe, is now chief scientific officer of iZumi Bio in San Francisco, California, a company set up to commercialize iPS cells.

原本是神户拜耳yakuhin制药公司的研究领队的Kazuhiro Sakurada现在成为了加利福尼亚州旧金山的iZumi Bio公司的首席科学家，这家公司就是为了将iPS细胞商品化而成立的。

Therefore, BIO treatment reduces the MSC-stimulated proliferation of MM cells and may enable MSCs to repair existing osteolytic lesions.

因此，BIO处理降低了MSC刺激的MM细胞增殖，从而使得MSC能够修复溶骨性病变。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。