查询词典 bet

The downshift of diffraction angle of XRD indicates some precious metals enter crystal lattice of LaMnO3, the crystal sizes of catalysts become larger after precious metal loading; BET and SEM results show sintering happened to catalysts after catalytic reaction.

XRD衍射角向低角度出现了少许偏移，显示负载在表面的贵金属部分进入钙钛矿LaMnO3的晶格结构中，使其晶粒增大；BET和SEM结果表明催化剂在反应后出现了轻微团聚现象。

The phase, particle shapes, particle size and specific surface area of the doped ceria powders were characterized by XRD, TEM and BET.

利用XRD、TEM和BET等现代物理测试方法对氧化铈纳米粉体的物相、颗粒度、分散性、颗粒形貌和比表面积等性能进行了表征，650℃焙烧的粉体呈现出良好的结晶状态，为立方萤石结构，粉体的比表面积在56.134－27.354

First, from room temperature to 500oC, the shell structure is amorphous with crinkly and airtight character. The shell structure begins to change into γ-Al2O3 and α-Al2O3 at 900oC. The surface of shells shows nano-sized pores at 900oC from SEM and BET analyses. When heated to 1000oC and 1100oC, the shell forms stable α-Al2O3 structure with smooth surface. Cracks often occur at the triple grain junctions. The specific surface area and the total pore volume of the hollow spheres increase with the calcination temperature.

首先，将锻烧温度由室温提升至500℃时，球壳属非晶相皱褶状致密结构；在900℃时开始有γ-Al2O3相及些许的α-Al2O3相出现，由SEM及BET结果得知，900℃之球壳表面有许多奈米级孔洞出现；当加热至1000℃和1100℃时，球壳形成稳定相之Al2O3结构，壳层表面趋於平滑，且球壳在晶界处有微裂缝存在；由BET 结果得知，比表面积及总孔洞体积会随锻烧温度之增加，有增加之趋势。

For finding a suitable sorbent for a-methylstyrene in the process of producing phenol from cymene, the pore structure and pore size distribution of four coconut-shell activated carbon were analyzed and characterized by different methods (BET, t-plot and BJH) according to their nitrogen adsorption isotherms.

为了筛选在异丙苯法生产苯酚工艺中吸附分离α-甲基苯乙烯的吸附剂，测定了4种椰壳活性炭材料的氮吸附等温线，并用BET模型、t图法、BJH理论等方法对孔结构进行分析与表征。

Emphasis has been put on changes of structure properties such as crystallization, crystal cell parameter, BET surface area, average pore diameter and pore volume with addition amount of FCC decant oil under conditions that the ratios of toluene to FCC decant oil are 1∶1 and 2∶1 respectively.

结果表明，当剂油比为1∶1时，分子筛的结晶度和晶胞参数随催化油浆添加量的变化呈现先增加后减小趋势，当noil/nCTMAB=0.34时，其晶胞参数最大可以达到5.95 nm；当剂油比为2∶1时，随添加剂量的增加，分子筛结晶度降低，BET表面积成先增大后减小，而孔容和平均孔径呈逐渐增加趋势。

New contributions of this work are as follows:(1). Preparation of Spherical MgCl_2-Supported Late-Transition Metal Catalysts for Ethylene PolymerizationFacile and effective immobilization of late-transition metal catalysts. 2,3-bis-(2,6-diisopropylphenyl) butane diimine nickel dibromide (1) and 2,6-bis-[1-(2,4,6-trimethylphenylimino)ethyl]pyridine iron dichloride (2), for ethylene polymerization has been achieved, using spherical MgCl_2 supports obtained by thermal dealcoholization of MgCl_2·2.56C_2H_5OH, and the effects of dealcoholization temperature on supported late-transition metal catalysts and the properties of resultant polymers were studied, the results indicated that:1.Supports with appropriate mechanical strength, high surface area and high porosity could be prepared by thermal dealcoholization of spherical MgCl_2·2.56C_2H_5OH supports; 2.BET, XRD, IR, SEM, GPC and DSC analyses indicate that the activities of the supported late-transition metal catalysts and the properties of resultant polymers are strongly dependent on the dealcoholization temperature.

本工作的新贡献如下：(1)、球形氯化镁负载后过渡金属催化荆催化乙烯聚合本文将配合物2，3-双(2，6-二异丙基苯亚胺)丁烷二溴化镍(1)和配合物2，6-二[1-(2，4，6-三甲基苯亚胺)乙基]吡啶二氯化铁(2)分别直接负载于经不同热脱醇温度处理的球形氯化镁载体上，研究了氯化镁载体的脱醇温度对负载化后过渡金属催化剂及其聚合物的影响，研究表明：1、通过对球形MgCl_2·2.56C_2H_5OH载体进行热脱醇处理，可以获得合适机械强度、较高比表面积和较高孔隙度的球形氯化镁载体；2、BET，XRD，IR，SEM，GPC和DSC研究表明，脱醇温度极大地影响负载后过渡金属催化剂的活性和聚合物的性能。

We used BET,FT-IR,XRD,TPR techniques to investigate the compression strength, the BET and the pore structure of catalysts by changing some factors such as the glutinousness and concentration of adhesive ,the ageing time and temperature and so on.

为解决催化剂侧压强度的不足，我们在实验室进行了超细镍基负载型催化剂实验室小试成型工艺条件研究，用硅溶胶及Ni~(2+)-硅溶胶两种不同的胶粘剂进行挤条成型，通过BET、FT-IR、XRD、TPR等技术考察了催化剂在成型过程中，胶粘剂的浓度、粘度，湿／干粉比，催化剂老化时间，以及焙烧温度等因素对催化剂的强度以及催化剂的比表面积和孔结构的影响。

Even against hyperaggressive opponents, who would always bet if you checked, you should consider betting, because they might be skeptical, or brazen, enough to raise.

即使对窪切┚尴不？bet的，你都应该 bet，他们可能怀疑，也可能不知道天高地厚 raise你。

The flotation effect of BET was compared with that of the commonly used reagents GF and FS202. The result shows that although the usage of BET is only 1/10 and 1/100 of GF and FS202 respectively, the collectability and selectivity for pyrite and coal gangue is obviously better than that of using GF and FS202. In addition, it will not be influen...

结果表明：尽管 BET的用量分别是 GF，FS2 0 2用量的 1 /1 0和 1 /1 0 0 ，但对黄铁矿、煤矸石等捕收性和选择性明显优于 GF，FS2 0 2 ，且不受 p H条件的影响；与其它 3种同系物(AET，DET，HET)在脱硫降灰方面综合比较表明，BET的效果最好，具有用量少、选择性强等优点，是一种应用前景良好的煤炭浮选药剂。

RESULTS: Bet stimulated the activation of, or generation of Ca2+-independent activity of, this kinase, in a concentration (0.0001 - 1 mmol·L-1) and time (5 - 300 s)-dependent manner; with Bet of 100 μmol ·L-1, Ca2+-independent activity increased from an unstimulated level of 4.5 ± 0.3 (n = 4) to 8.9±1.3 (n =4, P.05) at 5 s.

结果：Bet对该激酶的活化是时间(5-300 s)和浓度0.0001-1 mmol·L~(-1依赖性的，并可被阿托品所阻断。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。