查询词典 bending

It is different with the manual exhaust Slurry pumps valve is not required to run the wind man, it must be installed on the location of gas pipeline set point, the so-called water gas gathering point is the top horizontal tube of the highest point, this horizontal pipe 3 ‰ gradient requirements, does not allow for local conditions such as depression and bending, when the air into the valve, the valve automatically opens, the air removed, the water level rose, it will automatically close the valve, hot water can not spill, from a virtually eliminating Manual exhaust is not timely, easy to form a "vapor lock" effect caused by hot water heating effects and huge loss of the state.

它与手动排气闸阀不同点是不需要人为跑风，它安装的位置一定要在管路集气点上，所谓集气点就是顶层供水横管的最高点处，对此横管有3‰倾斜度要求，不允许出现局部凹陷和弯曲等情况，当空气进入阀体后，阀门会自动开启，调节阀空气排除后水位上升，它会自动关阀，热水不能外溢，从根本上消除了手动排气不及时，易形成"气阻"影响供热效果和造成热水大量流失的弊端。

The changing rule of the deformed zone and non-deformed zone in the process of bending the vee parts is analyzed.

分析了V形件弯曲过程中变形区与非变形区的变化规律，建立了计算凹模最小深度的公式，并通过数值实例，讨论了工件尺寸与凹模圆角半径对弯曲凹模最小深度的影响。

The experimental result shows that system can veraciously test the variety of bending degree for the fiber .

实验表明，该系统能准确检测出光纤弯曲程度的变化。

In the case of a small deformation, the relation between the displacement of the vertex and the pre-bending angle is analyzed.

分析了在较小变形量的情况下，突起角度与顶点位移量的关系。

Development of special type belt conveyor, such as bending belt conveyor, the angle or vertical conveyor machine.

开发特殊型带式输送机，如弯曲带式输送机、大倾角或垂直提升输送机等。

Verticality and the main structure of the overall total deviation should be allowed to meet the plane bending norms.

主体结构的整体垂直度和整体平面弯曲的允许偏差应符合规范的规定。

Because of the Vickers hardness and elongation of Vitallium 2000 and Vitallium 2000 plus are better than traditional dental alloys, so the RPD with Vitallium 2000 has good bending control, deformation rebound and fracture resistance.

Vitallium 2000在材料性能上有所改进，相对传统的常用铸造合金具有支架变形较小、折断的可能性低、卡环较易调改等优点。

He was having a wash, bending over the basin and splashing his face

他正俯身就着脸盆往脸上泼水洗脸。

Asked the boy, bending over the wash basin.

那少年问着，在洗脸池前弯下了腰。

This paper explores a way of analyzing the transformation of the cross section of thinwall structures while they are bending, gives the result of analysis for circular thin-wall structures.

本文对薄壁构件弯曲时横截面的变形提出一种分析，并对圆型薄壁构件给出了分析结果，说明其不应忽视的影响

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。