查询词典 bellows

Flap valve pin and WA44C Type Pound-Grade Balance Bellows Spring-Loaded Safety Valvevalve shaft axial clearance between the bearing face not less than 0.25mm.

阀瓣轴销与阀体支承端面之间的轴向间隙不应小于0.25mm。

Flap valve pin and WA44C Type Pound-Grade Balance Bellows Spring-Loaded Safety Valve valve shaft axial clearance between the bearing face not less than 0.25mm.

阀瓣轴销与阀体支承端面之间的轴向间隙不应小于0.25mm。

Bellows Gate Valves However, in large differential pressure operating conditions, evaporation pressure has eased, the evaporator load requirements of the fluid volume decreased, but the actual situation the contrary, in the suction superheat unchanged, due to evaporation pressure has eased, the evaporator outlet pressure be reduced accordingly, pressure changes above and below the diaphragm, causing the main valve opening increases for increased fluid; but in a small pressure operating conditions, evaporation pressure rise, evaporator load demand for fluid volume increased, but the reality is that in the suction gas superheat unchanged, due to evaporation pressure rise, a corresponding increase in the evaporator outlet pressure, pressure difference above and below the diaphragm smaller, so that the main valve opening decreased for the reduction of liquid volume; in variable load is all about.

但在大压差工况下，蒸发压力降低，蒸发器负荷需求的液量减少，但实际情况相反，在吸气过热度不变的情况下，由于蒸发压力降低，蒸发器出口压力相应降低，膜片上下的压差变大，使主阀开度增大，供液量增加；但在小压差工况下，蒸发压力上升，蒸发器负荷需求的液量增多，但实际情况是在吸气过热度不变的情况下，由于蒸发压力上升，蒸发器出口压力相应提高，膜片上下的压差变小，使主阀开度减小，供液量减少；在变负荷下亦如此。

Bellows Compensator Product Safety through the National Register pressure pipelines, the company in 1997 through ISO9000 quality system certification.

波纹管补偿器产品通过国家压力管道安全注册，公司于1997年通过ISO9000质量体系认证。

The rugged design of bellows seal to ensure zero stem leakage, to provide the conditions for maintenance.

坚固耐用的波纹管密封设计，保证阀杆的零泄漏，提供无需维护的条件。

Solenoid valve nominal Bellows Seal Valves pressure should exceed the maximum working pressure tube.

电磁阀公称压力应超过管内最高工作压力。

Another ambient temperature sensor is the vapor-filled bellows.

另一种空气温度传感器是充气波纹管。

On the basis of API standards and relevant Chinese standards, the dynamic characteristics of the homemade gas lift valves used in Wendong Oilfield are tested and analyzed. The dynamic characteristic parameters tested include debuging opening pressure, bellows bearing capacity, travel of valve rod, flow rate and valve leakage.

以API11V2—1995标准和国内3项与气举采油相关的石油行业标准为基础，依靠已建成的气举阀动态特性测试试验室，对文东油田使用的国产气举阀进行了调试台打开压力、波纹管承载率、阀杆行程、流量参数和气举阀漏失量等5项动态特性参数研究和现场测试。

The results of finite element analysis are also coincident with experimental test results. It has been proved that the prsent vacuum vessel's bellows, ports and lower rigid supports are feasible.

最后专门设计了一套力学性能测试平台，运用实验力学方法，对真空室的关键部件进行了力学性能测试，获得了一些相关的实验数据，综合评价真空室的支撑结构和波纹管的力学性能并验证了有限元仿真分析结果。

From the beginning of the 1990s has so far developed more than 100 specifications of the products presses are the main bellows production lines, large-diameter PVC drainage, sewerage lines, PE large-diameter gas supply, drainage pipe production lines, plate production line, granulation production lines, Plum of the production line, PP-R pipe production lines, one-to two-pipe production lines and 240 T, 180T Profile production line, plastic extrusion machines, high-speed mixer, mixed plastics and various auxiliary units and exported to the Philippines, Vietnam, Thailand , Malaysia, Russia, Iran and other places.

从90年代初起至今共开发了100多个规格的塑机产品，主要有波纹管生产线、大口径PVC排水、排污生产线、PE大口径煤气、供、排水管材生产线、板材生产线、造粒生产线、梅花管生产线、PP-R管生产线、一模双出管材生产线及240T、180T异型材生产线、塑料挤出机、高速混合机、混合机组以及各种塑料辅机，并远销菲律宾、越南、泰国、马来西亚、俄罗斯、伊朗等地。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。