查询词典 be verified

The cells full of crystals observed in orient tobacco were verified to be crystal idioblasts. The crystals observed by SEM were multiangle.

研究表明，香料烟株内结晶细胞是一类特化的含晶细胞，细胞内充满晶体，晶体形状似角锥状，质体等被挤到细胞边缘。

Telexes were sent to the consulate in Sydney, and for the first hour's wait, I was certain I would be cleared, verified, and on my way to begin a Pleiadian teaching tour in the land down under.

电报被送到悉尼领事馆，而且在第一时间等候中，而且在游历一个昴宿星人教导开始新西兰大陆途中，我确定我将被净化，核实。

Based on the study of model test of post-tensioned prestressed concrete box-shaped beam, the feasibility and correctness of this structure being applied for pillar wharf with bridge crane is tested and verified, which provides reference for calculation of post-tensioned prestressed box-shaped beam of bridge crane design This structure can be applied for port construction at large water amplitude area rationally

港口桥吊后张预应力起重机梁的模型试验研究重庆交通学院王多银陈嘉勤摘要通过对后张预应力混凝土箱梁模型试验研究，验证该结构用于桥吊墩式码头的可行性，寻求预应力桥吊箱梁的理论计算依据，并验证其正确性，为后张预应力桥吊箱梁的设计提供参考计算方法，使该结构能科学

An intelligent optimization system based on the above has been developed, and it is verified to be effective and practive through a great deal of numerical examples.

根据本文提出的方法及理论，在计算机上建立了一个能自动执行的智能优化系统，实际计算表明这一系统是有效的，实用的。

Thirty-ninth article of the evidence by the parties verified, the arbitral tribunal should be identified as the basis for truth.

第三十九条当事人提供的证据经查证属实的，仲裁庭应当将其作为认定事实的根据。

The main research tasks and results are as follows:(1) Through comparing the stress intensity factor of compact tension specimen calculated by finite element software with the theoretical value, the feasibility of calculating fracture parameters of crack tip in ABAQUS software was verified.(2) The relationship between the elastic modulus of the material and research scale was studied based on deriving the cohesive stress theory and other relevant theories. And the elastic modulus of the material on meso-scale was determined.(3) Global model and sub-model of the finite element were built in th...e macro-scale, and stress-strain field nearby the crack tip was analyzed, and the results show that the detailed stress-strain in the crack tip could be obtained by using the sub-model technique.(4) In meso-scale, the crack growth model was also established by assuming the crack propagating along the grain boundary, and the detailed stress-strain field in the crack tip was obtained.(5) The effect of crack length on Von Mises stress, and maximum principal stress and strain was analyzed in meso-scale when equivalent KI equals 30MPa.m1/2. And the results show that except for crack tip area, the stress-strain distribution in whole specimen is not affected.

主要完成研究内容和取得成果如下：(1)利用有限元软件计算出紧凑拉伸试样的裂纹尖端应力强度因子KI值，其结果与理论值一致，从而验证了利用ABAQUS计算裂纹尖端相关断裂参量的可行性；(2)在研究内聚应力等相关理论的基础上，推导出了研究尺度与材料弹性模量的近似关系，并确定了介观尺度上的弹性模量；(3)在宏观尺度上建立了全局有限元计算模型和子模型，得到了裂纹尖端应力应变场分布，结果表明利用子模型技术获得比较准确的裂纹尖端应力应变场分布是可行的；(4)在介观尺度上利用平均晶粒尺度的方式建立了裂纹沿晶扩展模型，得到了裂纹尖端断裂过程区的微观应力应变场；(5)当应力强度因子为30MPa.m1/2时，分析了介观尺度上在裂纹沿晶扩展过程中裂纹长度对Mises应力、最大主应力和应变的影响，结果表明，裂纹扩展长度对试样整体应力应变分布影响不大，而对裂纹尖端区域有较大影响；(6)介。。。

The rationality of the total heat transfer in enelosures can be divided into two single wall's heat transfer has been further verified.

研究结果确认，近角区的换热由于水平挡板的影响明显减弱，并且进一步验证了封闭空间的换热可以分解为两个单壁换热的合理性。

There should be management procedures for the ongoing management and review of these actions and the effectiveness of these procedures verified during self-inspection.

应有相应的管理程序持续管理和审核这些行为并在自检过程中确认该程序的有效性。

The generating algorithm is derived.It is verified that the GMW PC sequences have balance,optimal auto/cross correlation functions,and very large linear spans and can be used in the CDMA spread spectrum communication and cryptography.

给出了GMW相控序列的生成算法，证明了GMW相控序列均满足平衡性，具有优良的相关特性和极大的线性复杂度，可适用于CDMA扩频通信和保密通信系统中。

The following main results are obtained: The TiO_2 photocatalyst with small crystallite size, high surface area, narrow and uniform pore size distribution, and microporous frameworks could be prepared out by applying MW radiation in the preparation process. The microwave-induced fluorescence technique verified for the first time that microwave enhanced the formation rate of hydroxyl radical, leading to the increase in the photocatalytic efficiency. Compared with the conventional catalyst, TiO_2 prepared by MW dielectric heating owns a higher UV absorption ability, and its optical absorption edge and photovoltaic response are shifted toward the short wavelength region, resulting in increase of photooxidation efficiency. The photocatalytic conversion and the mineralization ratio of acetaldehyde are increased respectively by 30% and 40% over the TiO2 prepared by MW radiation when compared to the TiO2 prepared by the conventional heating. For the MW-assisted photocatalytic reaction over the MW-prepared TiO2, production of hydroxyl radicals is enhanced by 22.5%, and the photocatalytic conversion is accordingly increased by 20%. Similarlly, applying MW also increased the photocatalytic conversion and the mineralization ratio of acetaldehyde over TiO2/Al2O3 sample.

论文得到如下主要结果和结论：(1)微波介电加热TiO_2 溶胶可得到晶粒度小、光催化活性高、比表面积大和孔径分布窄而均一，且微孔发达的TiO_2光催化剂；在溶胶干燥处理过程中微波可使催化剂表面缺陷增加，进而导致光催化反应过程有更多的活性羟基自由基产生；(2)微波制备能显著增强TiO_2 样品的紫外光吸收率，并使其光吸收和光伏响应阈值发生蓝移，从而提高TiO_2的氧化还原能力；(3)与常规加热法所制TiO_2比较，微波法制备的TiO_2对乙醛的光催化降解转化率提高30%，CO_2生成率提高40%以上；(4)与未加微波辐射时相比，发现在光催化反应过程中施加微波，TiO_2 的羟基自由基生成速率提高了22.5%，相应CH_3CHO 光催化降解转化率提高了20%；对Al_2O_3/TiO_2催化剂，CH_3CHO 光催化降解转化率甚至提高了33%，同时CO_2 的生成率也都大幅度提高；(5)微波辐射可改变光催化降解乙醛的产物分布，推断施加微波时乙醛光催化降解按照羟基自由基引发的链式反应机理进行，微波&非热效应&起主要作用。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。