查询词典 be light-headed

The influence of different assembled condition such as assembly method, concentration of zirconium source and pH value on the effectiveness of assembly were evaluated via DSC-TG, FT-IR, Uv-vis and SAXRD et al. It showed that the assembly effectivness of uncalcined 3 Si/Zr_10# sample was best.c The optical characteristic, which including light-conduction in infrared band and polarity in visible band, of dip-coating film and membrane assembled zirconia after processing parameters of assembly optimized were observed via FT-IR and Uv-vis. The polarity was characterized by polarizing angle through calculation from light-transmittance, light-reflectance and fresnel coefficient. qualitative analysis showed that the polarity of Si/Zr_10 # dip-coating film assembled was best.d Adopting zirconium oxychloride as zirconium source, CTAB as template, employing different CTAB adding sequence, two mesoporous zirconia samples were prepared. The template effect of two samples was discussed. It showed that the effect of the sample which CTAB adding sequence was same as mesoporous silica film was better. The light-conduction in infrared band of these samples was also studied, which offered comparison to the polarity of zirconium dioxide assembled within mesopore.

结果显示：组装条件优化后的uncalcined 3 Si/Zr_10#厚膜样组装效果最好，其组装液对应的pH值最利于该锆源离子模板交换组装； c选用FT-IR、Uv-vis对组装条件优化后纳米氧化锆/介孔氧化硅厚膜、纳米氧化锆/介孔氧化硅薄膜包括红外导光性、可见光区内的偏光性在内的光学特性进行了分析，其中偏光性以膜层透光性、反光性及菲涅耳系数计算出的偏振角即布儒斯特角表征，定性分析显示，Si/Zr_10#ZrO_2/介孔氧化硅厚膜偏光性最好； d以氧氯化锆ZrOCl_2·8H_2O为锆源，CTAB为模板剂，采用不同的模板剂加入顺序，探索性地制备两介孔氧化锆样，分析了两介孔氧化锆样的模板效果，得出模板剂加入顺序同介孔氧化硅薄膜时介孔氧化锆样的模板效果较好，并分析了所得样品的导光性，为锆氧粒子引起的附加光学特性分析提供了参考和对比。

7 Prismatic Light Light Pris Light Inflicts 25 points of damage plus 1 per point of skill in Light Magic on all creatures in sight.

7 死亡之光 Light 死亡之光可以对视野范围内所有怪物发动攻击。攻击力为25点加上自身魔法等级。

Research on the theory of structure light sensor Originating from the principles of projective and perspective transformation, for the first time, the models of coordinate transformation between workpiece and camera with arbitrary angle of laser light and camera are presented. The model give some very important rules for the design of structure light sensor, and is very important to the design of structure light sensor, the sensor designed based on the theory above is used in automatic welding.

结构光传感器的理论研究依据透视变换理论给出了光源倾斜照射和摄象机倾斜接收情况下，被检测物体与摄象机之间的一般坐标变换数学模型，该模型揭示出结构光传感器设计时应遵循的一些原则，对结构光传感器的设计具有非常重要的指导意义，基于该模型设计的结构光传感器已在自动焊接实验中获得了成功的应用。

An oxygen-bubble and white-light speckle velocimetry method is presented.Instead ofpulsed laser and commonly used particle,a sheet like-bubble mass generated from anade wire byeletrolysing water is used as particle tracer,a white light flash set controlled by digital time delaycircuit is used as double pulsed light source,and 2-D velocity distribution in a sectional planewithin flow field can be obtained without using light sheet technique.

提出了一种氧气泡粒子白光散斑测速技术，与以往散斑测速方法不同的是，采用电解水时电解阳极丝上产生的氧气泡做为流场示踪粒子，用两个闪光时间间隔由数字延时电路控制的普通闪光灯做为散斑底片拍摄时的双脉冲光源，并且勿需片光技术，即可获得流场内部一个截面上的二维速度分布。

Main products : Moving Heads, Scanners, Follow Spot Light, Laser Lights, Strobe Lights,flash lights, Effect Lights, Projectors,intelligent lights, disco lights,smaze machine,Outdoor Lights,search light,sky rose,city color light, Fog Machine, Bubble Machine, Snow Machine, Flame Machine,Stage Light,stage lighting,dimmer,Dmx lighting Controller,parcans,mirror ball,black lights,LED lights and so on .

主要产品有：电脑摇头灯、电脑扫描灯、电脑追光灯、激光灯、频闪灯、图案花灯、程序效果灯、户外灯、烟雾机、泡泡机、雪花机、喷火机、舞台灯、各种控制台、专业 LED 等。专业提供：舞台配置方案、方案说明、舞台布置平面图、效果图、标书制作、工程安装调试指导、技术问题解答、技术人员培训等支持；承接：灯光音响工程、租赁、国内外ODM、OEM加工。

The stable and reliable operation voltage of the probe can be given by the following methods:(1) 20% light coupling efficiency is obtained by direct coupling of LD-optical fiber.(2) The light power is transmitted by multi-model optical fiber.(3) The largest photo-electric conversion efficiency is achieved by selecting the transformer regulation of step-up transformer.(4) The stable light intensity is achieved by using LD light feedback of driving circuit and refrigeration.

通过下述方法可提供稳定、可靠的探头工作电压：LD—光纤的直接耦合方式，可实现20％左右的光耦合效率；采用多模光纤传输功率；选择升压变压器最佳变比提高光电转换效率；采取LD驱动电路光反馈以及致冷措施使其发光幅值稳定。

Light propagation in the light-collimator is based on total internal reflection towards a light-exit window (4) of the light-collimator.

光准直器中的光传播基于朝向光准直器的光出射窗(4)的全内反射进行。

In order to obtain symmetry and parallel polarized light,the double Wollaston prism is amended. After getting symmetric polarized light at a big splitting beam angle,an ordinary triangular prism is added so that the symmetric light beam can be divided into parallel light beams.

为了获得对称且平行分束的偏振光，对双Wollaston棱镜进行了修正，在获得大分束角的对称偏振光后，配合普通玻璃三棱镜，使对称分束光变成平行分束光，通过改变三棱镜与双Wollaston棱镜间的距离来改变平行光的剪切距离。

However, the image-retrieving environment is so complicated, such like from a nature object to a variety of objects, from a light environment to a dark environment, or from a nature light to a daylight in office, the properties of objects, and the varieties of light sources and light intensities. These complex external image-retrieving environments let users can not get an accordant image quality. Such under a tungsten lamp, the image appears yellowish and reddish; under daylight in office, the image becomes greenish and bluish.

CCD Camera面对的是复杂的取像环境，从自然景物到各式各样的景物，从光亮环境到灰暗环境，或从自然光到办公室日光灯、景物的特性、光源的种类及光线的强弱，这些外在复杂的取像条件及变因往往让使用者无法得到相当一致的影像品质，如在钨丝灯下拍摄的影像，将产生偏黄、偏红效果的影像；在办公室的日光灯下将产生偏绿、偏蓝效果的影像。

According to the international standard ISO7027,we can know that the measurement of turbidity mainly use the optical turbidimeter measurement,it contains the scattering-light method and transmitted-light method. The scattering-light method has application in measurement for low turbidity water and also can used in high turbidity water.On the other hand,the transmitted-light method is more suitable for high turbidity measurement.

根据国际标准ISO7027可知，现今测量水的浊度主要以光学浊度仪测量法为主，主要包括散射光法和透射光法两种，散射光法主要用于测量低浊度水，但也可用于高浊度水的测量；而透射光法更适合于测量高浊度水。

As of Tuesday, Google's results were still censored in China.

截至周二，谷歌的搜索结果仍受中国审查。

In order to make the positive action increase and negative one decrease, the sub-forces of the social factors must be adjusted to form a centripetal force.

在这一过程中，人的主体性发挥是社会有机体健康发展的灵魂。