英语人>网络例句>be in error 相关的网络例句
be in error相关的网络例句

查询词典 be in error

与 be in error 相关的网络例句 [注:此内容来源于网络,仅供参考]

For the all classes of dies, if we analyse the fluctuate, tendency of increase and decrease and law which appeared in the die's whole life, we will find that the master of the error are changeless; the error that because the abrade of the cutter and impression will be as the cutter grinding times increased at the same time. And that will cause the error oversize gradually; and also have another part error are unconventional , unforeseen.

对各类冲模冲件误差在冲模整个寿命中出现的波动、增减趋向及规律等进行全面分析便可发现:冲件误差的主导部分是不变的;因刃口或型腔的自然磨损而出现的误差增量随冲模刃磨冲数增加而使这部分误差逐渐加大;还有部分误差的增量是非常规的、不可预见的。

In theory, there is no error for the refractive seismic exploration by permuting the focus and the cymoscope. In some especial condition, it would be the only choice because that refractive seismic exploration is needed, but the error can not be neglected be cause of various factors.

在理论上,用源检互换的方法进行折射地震勘探是没有误差的,在某些特殊条件下无法铺设检波器而又必须进行折射地震勘探时它也是唯一的选择,然而,在实际工作中,由于各种因素的影响,其误差是不可忽略的。

The error source of CMM is complex, and the current main research is its geometric error. In the paper, 21 items of geometric error are measured accurately, simply and fast with the 2-D laser interferometer and four quadrants photo detector. The measurement gets rid of measuring so many lines and several diagonal lines in linear displacement method, and also solves the question that error measure of large-scale CMM can not be measured with 1-D ball array and ball plate conveniently.

坐标测量机的误差源纷繁复杂,当前主要研究的是其几何误差,课题中研究了一种采用二维激光干涉仪和四象限光电探测器相结合的测量方法,对三坐标测量机的21项几何误差进行了准确、简便、快速的测量,摆脱了线位移法测量直线过多且包含多条对角线测量的弊端,同时也解决了一维球列和球板不方便检测的大型测量机的误差检测问题。

Besides, we have studied deeply error of two kinds which appeared frequently in the hypothesis testing (error of the first kind and error of the second kind), including the relations to error of two kinds and its effect to the result of hypothesis testing and the effective control of error of two kinds so as to be satisfying and etc.

另外,对假设检验中经常出现的两类错误(第一类错误和第二类错误)也作了深入的探讨,其中涉及到了两类错误之间的关系,两类错误对假设检验结果的影响以及如何有效的控制两类错误使之达到令人满意的程度等。

The article studied the intercept of tactical missile defense hands in meeting horn to restrain a problem, put forward a kind of kinematic geometry to analyse a method, derivation the analytic impact that the transverse error that the initiative position error of TBM causes and intercept make meeting part, analysed intercept to hand in meeting horn to be opposite end control and guide paragraph the influence of correct an error, decided can hit the target the intercept that the target allows makes meeting role range.

本文探究了战术导弹防御的拦截交会角约束新问题,提出了一种运动学几何分析方法,推导了TBM的初始位置误差引起的横向偏差和拦截交会角的解析关系,分析了拦截交会角对末制导段纠偏的影响,确定了可命中目标答应的拦截交会角范围。

Observational error is difficult to avoid, but this doesn't mean the observational subject is full helpless in front of the observational error. If observational subject continuously optimizes hisself qualities, wipe out the localization of subject to the best us the activity that observational negative impact result in, at the same time, recognize the complexity of observational object well, the respect observational environmental role, select the pooropriate method and instruments, and form the good observational habit, observational error is to may be prevented.

观察错误虽然是难以避免的,但这并不意味着观察主体在观察错误面前,是完全无能为力的,观察主体如能不断优化其自身素质,尽量消除主体局限性对观察活动造成的负面影响,同时,充分认识观察客体的复杂性,重视观察环境的作用,选择适当的观察方法和观察仪器,养成良好的观察习惯,观察错误是有可能被避免的。

The author made an analysis of the ratchet gearing used let-off mechanism in the K251 type loom and of the effect to loomage, and came to the conclusion that is: 1. The long length of the loom cause bigger LO, which reduce weaving defects caused by let-off error. 2. At the same status of the loom, the possibility of appearing weaving defects is relative to the characteristic of the loomage, namely, if the stiffness coefficient of the loomage and organzine has lesser difference, the possibility of appearing weaving defects will be lesser, contrarily will bebiggish. 3. The displacement error AL affects the value of the weavingdefects directly, besides wind error, it is a effective method to reduce let-off error.

通过对K251丝织机棘轮送经机构及其对织物影响的分析,得出以下结论:1、丝织机的长机身使Lo较大,有效地降低了由送经误差造成档疵的可能。2、在织机状况相同的情况下,档疵出现的可能性与织物的特性有关,即织物与经丝的刚性系数相差较小的,档疵出现的可能较小,反之较大。3、织口位移误差△L,对档疵有着直接的关系,除了卷取误差,减少送经误差是减少档疵出现的有效的方法。

A measuring system which mainly consists of a high precision motorized translation stage of one dimension, POINT GREY Flea2-14S3 CCD camera and LED light source was designed and constructed. Based on a detailed analysis for experiment results, the periodic changing law of system error of LED facula centroid location in this measuring system was found. The results indicate that based on Flea2-l4S3 CCD camera, the random error of facula centroid location is about 0.018 pixels, the system error is about 0.06 pixels, and the total error is about 0.063 pixels (1/15 pixels). According to the total error above, this CCD imager can be widely used in many measuring systems which count on facula centroid subpixel detection.

利用高精度一维电动平移台、POINT GREY Flea2-14S3 CCD相机和LED光源构建了测试系统,对测试结果进行研究和讨论,发现了测试系统LED光斑质心定位系统误差的周期性变化规律,计算得到了基于Flea2-14S3 CCD相机的光斑质心定位随机误差为0.018pixels,系统误差为0.06pixels,总体误差为0.063pixels(约1/15pixels),能够应用于以光斑质心检测为手段的测量系统中。

It is pointed out that the error of indication E0 for the calibrated test length which are measured when the offset length between the ram axis and the stylus tip is zero shall neither exceed the maximum permissible error MPEE0 nor exceed 1/3 of the probe error,that the repeatability of E0 shall neither exceed the maximum permissible error MPE Rnor exceed the repeatability error of the probe,and that if the measuring data is rejected in acceptance and reverification,measurement must be carried at least 5 times at the same position for reducing the possibility of misjudgement.

提出探测轴探针针头零偏置长度的校准测试长度的示值误差E0应不超过最大允许校准测试长度的示值误差MPEE0,且不应超过测头误差的1/3;E0的重复性误差R不应超过最大允许重复性误差MPER,且不应超过测头的重复性误差。建议验收校准测量数据超差剔除后,必须在相应位置重复测量5次以上,以减小误判的可能性。

A commutation error is then considered in addition to the conventional residual error to generate the innovative residual error. Such an error is applied into cost functions to derive finite impulse response and infinite impulse response filter-based adaptive algorithms for ANC applications, referred to as FxRLS/CE and FuRLS/FRE+CE algorithms, respectively. Convergence analyses based on Lyapunov stability criteria for time-varying discrete-time systems can be carried out for the FxLMS/CE, FxRLS/CE and FuRLS/ FRE+CE algorithms to ensure stability. Computer simulations and experiments demonstrate that the innovative residual error-based adaptive algorithms can free the restriction of the slow-adaptation assumption in the conventional ANC approaches.

本文中也定义一交换误差并且加入到传统残留误差行形成新残留误差来改善适应性演算法的收敛速度,使用新残留误差推导出了有限脉冲响应滤波器与无限脉冲响应滤波器之适应演算法的新适应性演算法分别为: FxLMS/CE、 FxRLS/CE 和 FuRLS/FRE+CE 演算法,并且以离散时间的 Lyapunov 稳定性准则来证明演算法的收敛性,电脑模拟与实验也显示新演算法免除以往滤波器的参数必须缓慢更新的条件。

第4/43页 首页 < 1 2 3 4 5 6 7 8 9 ... > 尾页
推荐网络例句

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸,那乌黑、忧郁的眼睛,她便会相信,他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失

But because of its youthful corporate culture—most people are hustled out of the door in their mid-40s—it had no one to send.

但是因为该公司年轻的企业文化——大多数员工在40来岁的时候都被请出公司——一时间没有好的人选。