查询词典 be born in the lap of luxury

The experimental results show that the maximum SNCF of the joint occurs at the through brace saddle near the lap brace under axial loading out-of-plane bending, and at the lap brace crown heel under in-plane bending.

随后，研究了完全叠接管节点试件在复合荷载作用下的热点应力，结果表明在复合荷载作用下最大热点应力可能出现在介于鞍部和冠部之间的任一位置。

However, had we known at the time that Rubens Barrichello had changed onto inters as early as lap 16 and immediately gone two seconds a lap faster, we might have thought differently

但是，如果我们知道Rubens Barrichello在第16圈就换了中性胎并且之后每圈可以快两秒的话，说不定我们就会做出不同的选择了

Based on cooling condition,considering potential heat of phase transformation,the temperature field of lap joint and non-lap joint of high carbon steel wire on STELMOR cooling line are calculated.

根据高碳钢线材的冷却条件，考虑了相变过程的相变潜热，计算出线材搭接点与非搭接点在斯太尔摩冷却线上的温度分布，计算结果与实测结果吻合较好。

The Baker model and elasto-plastic finite element method are applied to investigate the thermal stress distribution in over lap zone of the single lap joint.

利用Baker模型和弹塑性有限元方法研究了胶接接头搭接区残余应力的分布。

By analyzing the influence of hemisphere pits with different dimension and ellipsoid pits with different aspect ratio on stress and strain distribution of lap joint, the possible propagation of fatigue crack was discussed, and the effects of localized pitting corrosion on the structural integrity of lap joints were discussed.

通过分析不同尺寸的半球形蚀坑和不同长短半轴比值的半椭球形蚀孔应力应变分布的影响，探讨搭接件疲劳裂纹的可能扩展方向，讨论局部孔蚀对搭接件结构完整性的影响。

Since the lap joint is a key part which greatly influences the fatigue life of aircraft structure,a two-stepped riveted lap joint in an integral panel structure is presented,and finite element analysis is performed for it.

纵向连接接头是影响机身整体壁板结构的安全疲劳寿命的关键部位，因此本文设计了一种适用于机身整体壁板纵向连接的阶梯状两台阶铆接接头结构。

Thermo-mechanical coupling finite element method is used to calculate the six inherent strain components and the angular distortion of the lap joint, and each inherent strain component is mapped into the model in the form of boundary condition for linear elastic analysis, the angular distortions of the lap joint are got.

采用热弹塑性有限元法计算出搭接接头的六个固有应变分量和角变形，并以各个固有应变分量作为边界条件，对搭接接头的有限元模型进行弹性分析，计算出各个固有应变分量对应的角变形。

In this paper, a 4-node plate element combined with rivet element and contact element is employed to analyze two typical rivet joint structures, i.e., lap joint and butt joint. The penetration between two sub-plates in the lap zone or butt zone is avoided by introducing contact element in the proposed FE model. Bending deformation and its effect on in-plane displacement of the two typical rivet joint structures are studied.

本文采用四节点板单元，结合铆钉单元、接触单元，建立了针对铆接搭接及铆接对接两种典型结构的有限元模型，并考虑了搭接或对接区内的接触问题，通过参数分析研究了铆接搭接和对接结构在拉伸载荷下的弯曲效应及其对面内位移的影响。

The machine has two drafting zones to have the slivers to be further double and drawn to improve the fibers to be more straight and parallel. The 4 calendars make up a "S-type" mechanism, which can adjust the pressure to the lap, ensuring a perfect lap winding up on the two big calendars, having the best fiber arrangement and best fiber evenness.

采用两区牵伸对预并后的棉条进一步并合牵伸，提高纤维的平行度及伸直度，经过排列为S形的四根压辊轧光合可调的棉卷加压装置，保证了在两个大成卷罗拉上形成的棉卷，具有的最佳的纤维分布和最优的均匀结构。

Phelps swam the 100-meter lead-off lap, in 47.51 seconds, a new personal and U.S. record for that lap.

菲尔普斯游100米带头小康立，在47.51秒，一个新的个人和美国的纪录为一圈。

Why are you poking about among my papers?

你为什么乱翻我的文件？

Grapes are one of the few fruits to contain tartaric acid, the major wine acid and the most important source of acidity in wine.

葡萄是少数含有酒石酸的水果的一种，（酒石酸是酒中主要的酸性物质，同时也是酒的酸度的最重要来源）。