查询词典 axis

Due to the most of particle size are smaller than critical particle diameter Dp at 1 nm CoPt, the effect of superparamagnetism causes the decrease of coercivity. Approximately, the orientation of magnetic easy axis of CoPt thin films is random.

当CoPt厚度为1 nm时，由於大部分的颗粒尺寸小於临界直径Dp，因此产生超顺磁效应，造成整体薄膜之矫顽磁力的下降，大致上，於700℃退火30分钟之CoPt单层薄膜的易磁化轴方向呈现random orientation。

From the microstructure analysis of XRD and TEM, it is found that the Pt underlayer possess (111) preferred orientation. The magnetic easy axis of Co3Pt film is transferred from in-plane to out-of-plane as Pt (111) under layer is added, due to the epitaxy between Pt (111) and CoPt (002) films.

经XRD及TEM微结构分析结果，Pt底层具有很强的(111)从优取向，经由磊晶作用能诱发Co3Pt磁性层之CoPt (002)从优取向，而Co3Pt薄膜也由水平转为垂直磁异向性。

In aircraft engine, because bearing rotate speed is extremely high, produce mighty centrifugal power from this, rupture because of what this axis corbel expects tenacity is attached most importance to especially should.

在飞机发动机中，由于轴承转速极高，并由此产生强大的离心力，因此轴承材料的断裂韧性尤为重要。

The rectangle shaped member mentioned by this article is a prefabricated one for the internal construction of circular tunnel, and is located along tunnel axis line, to be lifted into place by a dedicated crane onboard the shield machine in synchronised manner, followed by placement at both sides of tunnel, of ballast block, or in-situ cast members, corbel, pavement slab and the like.

由于隧道比较长，为节约工期，在盾构机推进的同时，隧道的内部结构也跟进施工，本文所叙述的口字型构件是圆隧道内部结构中的预制构件，它位于圆隧道的中心轴线位置，在同步施工中由盾构机上的专门起重机吊放入位，再于两侧施工压重块、牛腿、路面板等现浇结构。

There was a significant difference in coronal alignment between the preoperative and postoperative mechanical axis action point.

术前和术后的机械轴活动点在冠状序列上有明显的差别。

Coronal image may be used as a complement for axis image.

冠状位重建可作为横轴位的补充。

This technique uses a spiral phase plate with a small central aperture placed on the Fourier plane of so imaging system. If the spiral phase filter is rotated by a certain angle around its central axis, a phase shift between the zero-order spatial frequency component and the remaining of the object is produced, and the magnitude of this phase shift is proportional to the rotation angle. Using this property, we can record a sequence of intensity distribution of the output beams corresponding to different rotation angles, and then digitally reconstruct the objects by using a phase-shifting algorithm. Both the theoretical analysis and simulation experiment results demonstrate the feasibility of this approach.

在成像系统的频谱面上放置中心带有一通光孔径的螺旋相位板，在输出面上记录输入物体经螺旋相位滤波后的输出像；将螺旋相位滤波器绕轴旋转一定角度，通过中心光孔的零频成份与其他高频成份间会产生与旋转角度成正比的相移；利用这一特点，通过记录多幅对应不同旋转角度的输出光场强度分布图，然后再用一定的相移算法实现被记录物体相位分布的数字再现。

This technique uses a spiral phase plate with a small central aperture placed on the Fourier plane of an imaging system. If the spiral phase filter is rotated by a certain angle around its central axis,a phase shift between the zero-order spatial frequency component and the remaining of the object is produced,and the magnitude of this phase Shift is proportional to the rotation angle. Using this property,we can record a sequence of intensity distribution of the output beams corresponding to different rotation angles,and then digitally reconstruct the objects by using a phase-shifting algorithm. Both the theoretical analysis and simulation experiment results demonstrate the feasibility of this approach.

在成像系统的频谱面上放置中心带有一通光孔径的螺旋相位板，在输出面上记录输入物体经螺旋相位滤波后的输出像；将螺旋相位滤波器绕轴旋转一定角度，通过中心光孔的零频成份与其他高频成份间会产生与旋转角度成正比的相移；利用这一特点，通过记录多幅对应不同旋转角度的输出光场强度分布图，然后再用一定的相移算法实现被记录物体相位分布的数字再现。

And sliding in the direction of axis, the corrugation appears on specimen surface in laboratory wear test.

滑差≤2.5%和轴向滑动时，在实验室磨损试样上出现了波浪磨耗现象。

The tapered cottar, sells the axis, the insulating clamp, the clamp, the card hat, the copper fastener, the hot-water heat fitting, the fastener half-finished product, the fastener generation of purchase production and the service.

圆锥销、销轴，线夹，卡帽，铜紧固件，水暖配件，紧固件半成品，紧固件代采购的生产及服务。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。