查询词典 axial

The R/C frame structures were modeled with bar system and the column was modeled with multi-springs. The concrete and steel bars in column were considered as springs in order to reflect the coupling influence between the axial force and the moment-rotation relationship, the hysteresis of springs is based on the material properties and the rotation of column section is followed the plane assumption. The moment-rotation of beam section was modeled with trilinear hysteresis model.

混凝土框架分析模型采用杆系模型，其中柱采用多弹簧模型，柱端的混凝土和钢筋作为弹簧考虑以便反映柱轴力与弯矩－曲率的耦合关系，弹簧的滞回关系根据材料特性确定，柱截面的转动符合平截面假定，梁截面弯矩－转角关系采用三折线滞回关系模型。

Finally, the four-unit cylindrically conformal microstrip antenna array is processed and tested. Testing results indicate that, the input VSWR of the antenna array in the vicinity of 1.575GHz is less than 2, the omni-directional performance good, 3dB bandwidth is about 90 degree on axial plane, right-hand circularly polarization good. Overall performance of the antenna array satisfies the design requirements.

对仿真获得的四单元柱面共形微带天线阵列进行了加工测试，测试结果表明该天线阵列在1.575GHz附近工作频带内输入驻波小于2，柱面法向平面全向性良好，轴向平面3dB波瓣宽度约为90。，右旋圆极化效果良好，天线整体性能达到工程设计要求。

PMMA compound X-ray lenses are composed of a group of 40 plano-concave elementary lenses positioned in line with axial symmetry.

用LIGA技术中的软 X射线光刻方法制作了PMMA材料 X射线组合透镜。

The latest experimental results of the focusing perfermance of the compound high-energy X-ray lens is designed with PMMA with the parameters of 40 plano-concave elementary lenses positioned in line with axial symmetry, 200 μm radius of the concave surface, 0.15 nm working wavelength, 0.5 mm geometrical aperture and 8 mm length of the compound lens and 1.3 m focus length, are briefly introduced.

报道了这种新型X射线光学元件聚焦性能的最新实验结果。设计的高能X射线组合透镜为聚甲基丙烯酸甲酯材料，包括40个相同的、顺序排布的平凹折射单元，折射单元的球面半径为200 μm，组合透镜的几何口径约为500 μm，长度约为8 mm，焦距约为1.3 m。简要描述了PMMA材料X射线组合透镜的制作技术和制作过程。并给出了X射线组合透镜聚焦性能测试实验系统和实验条件。

The design of these wall frames does not utilise the full strengthening effects of the plasterboard in carrying the axial loads.

在这些墙架的设计中没有利用石膏板在承担轴向荷载方面的增强效应。

Using the axial elastic platen, improve the clutch of comfort.

采用具有轴向弹性的从动盘，提高了离合器的接合平顺性。

The Ploughshare mixing tools have been designed especially for ore mixing. The mixing tools disperse the product, create a rubbing effect and return the product in axial direction, which is essential for accurate mixing.

犁铧式的混合工具为矿石混合特殊设计混合轴分散物料，产生物料运动效应，再把物料带回轴的方向，这对精确的混合是很必要的。

The Ploughshare mixing tools have been designed especially for ore mixing. The mixing tools disperse the product, create a rubbing effect and return the product in axial direction, which is essential

犁铧式的混合工具为矿石混合特殊设计混合轴分散物料，产生物料运动效应，再把物料带回轴的方向，这对精确的混合是很必要的。

Methods To take an axial view radiograph of patella with patient in sedentary position, the patients' hip joints were kept flexural with 90 degrees naturally and knees flexural between 30 to 80 degrees, then photos were taken by adjusting the angle and point of incidence of the central line.

取坐位投照髌骨，患者髋关节保持自然屈曲90°，屈膝角度范围30°～80°，然后调整中心线的入射角及入射点进行投照。

For the analysis of both static and dynamic characteristics, the additional moments, axial/radial coupled stiffness coefficients and the radial/radial coupled stiffness coefficients are taken into account Based on it, the influences of the bearing angle, the ratio of width to diameter, and the ration of magnetic polar angle on the static and dynamic characteristics conical magnetic bearing are analyzed, and the corresponding numerical results are presented.

在圆锥电磁轴承基础解的计算模型中，增加了轴承附加力矩、力矩刚度系数以及轴向/径向、径向/径向耦合刚度系数的计算。在此基础上，本文详细讨论了圆锥电磁轴承锥角、宽径比以及磁极角比对轴承静、动特性的影响，并给出了数值结果。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。