查询词典 axial

The use of ANSYS finite element software to establish a large-scale Decanters double cone angle of the two-dimensional finite element model of the drum to its normal working condition in the overall structure of static analysis, has been the drum of the radial, axial deformation and stress distribution and maximum stress points, results show that the double cone angle drum strength and stiffness to meet the requirements to verify the safety of the structure of double cone angle.

利用ANSYS有限元软件建立了大型卧螺离心机双锥角转鼓的二维有限元模型，对其在正常工作状态下的整体结构进行了静力分析，得到了转鼓的径向、轴向变形和应力分布及最大应力点，结果表明双锥角转鼓的强度和刚度均满足要求，验证了双锥角结构的安全性。

This provides for a double-header channeling rollers axial well, corresponds to the monlchamus on the 印张 area inking.

依此可拉不不入在经过了窜不朱辊的轴向打匀后，在印张上相差答不朱区的施不朱度差别。

These results indicate that the supper resolution in both transeverse and axial directions can be obtained meanwhile by the use of doublet.

说明双胶合透镜在横向和轴向同时具有较强的超分辨能力。

The maximum tangential velocity decreases downwardly and shifts gradually towards the center wall along the axial direction, which are mainly caused by the effects of the friction loss along the wall and the turbulent energy dissipation.

轴向速度沿径向呈明显的线性分布，下行轴向速度沿提升管外壁向封闭罩内壁的径向方向逐渐增大。

Firstly, the projects of designation and improvement of prewatering pelletizer are demonstrated, including the structure, the ways of delivering the motivation and drawknife system by referring some improvement experience from production practice; Secondly, based on the analytical results, axial force, the torque and power are computed so that the electromotor, decelerator and other corresponding components could be determined; Thirdly, according to the parameters of the parts which has already been assured, the simple exercise diagram of the transmission device is analyzed and drawn up and the ratios of all levels are assigned.

参考实践生产中的一些改进经验，首先进行了总体方案的论证；然后根据分析的结果来计算各传动轴的轴向力、扭矩以及功率，并校核了轴和螺栓的强度，从而选择电机和减速机型号及设计其他相关零部件。

On the basis of field resources analysis,the drill collar thread model is created by UG,and analyzed the thread stress under different axial forces by finite element method.The structure optimization design process of drill collar is described in the paper.

在现场资料分析基础上，运用UG软件建立了钻铤螺纹联接模型，然后通过有限元软件分析了钻铤螺纹应力分布，得出了钻铤螺纹在不同工况、结构条件下的等效应力分布情况，并对钻铤螺纹结构优化设计过程进行了相应说明。

Objective:Since some limitaions of SRK Ⅱ formula,the dual cubic curved regressive formula was designed. methods:By means of computer,statistical analysis and regressive treatment of kerato diopter,axial length and emmetropic IOL diopter of 415 pseudophakia was done.

针对目前临床上常用的SRKⅡ公式在计算人工晶体屈光度时的局限性，对415只后房型人工晶体眼的角膜屈光力、眼轴长度和正视化人工晶体屈光度进行回归分析后，设计出一种不同于传统的线性回归公式的曲线回归公式——二元三次计算公式。

The catheter assembly of claim 25, wherein the axial length of the outer jacket segment further comprises materials of different durometer hardness.

如权利要求 25 的导管组件，其中外护套段的轴向段呈弓状。

Ray will show the associated skeletal anomalies, such as skull base invagination, scoliosis, kyphosis, cervical ribs, and many other skeletal anomalies. Axial images with CT may demonstrate an obliterated cisterna magna, tonsillar ectopia, and a normal fourth ventricle.

线可以显示出伴随的骨骼异常，如颅底凹陷，脊椎侧弯，脊椎后突，颈肋，以及许多其他的骨骼异常，CT轴位图像可以显示一个闭塞的小脑延髓池，扁桃体异位，以及正常的四脑室。

Methods 15 patients with different type and degree of cicatricial ectropion were repaired with the method of simple skin grafting, posterior auricular refluxing axial skin flap or anchyloblepharon.

对15例不同类型和不同程度的瘢痕性睑外翻，采用局部瘢痕松解睑缘粘连、耳后返流轴型皮瓣修复及瘢痕松解植皮修复。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。