查询词典 axial

The main products are: general purpose centrifugal, axial fan, industrial boiler drum, suction fan, fan of pulverized coal, emission of dust and material handling fans, fire smoke extraction fans, heat fan, axial fan mining, roof fan, tunnel fans, top boxes, such as building ventilation more than 20 series over 400 varieties of different specifications.

主要产品有：一般用途离心、轴流通风机，工业锅炉鼓、引风机，煤粉风机，排尘及物料输送风机，消防排烟风机，高温风机，矿用轴流风机，屋顶风机，隧道风机，高层建筑通风箱等20多个系列400多个品种规格。

The simulation results shows that when the hydroforming for real axle housing needs two bulge processes and the specific value of the two bulge ratio is about 1, the result is the best one; To obtain an appropriate route of loading force need adjust internal pressure and axial compression force for many times and according to the failure, the size of the two forces which has been mentioned can be rapidly and rationally adjusted; Because of good greasing conditions influencing largely, reducing the friction between tube blank and die inside surface as well as possibly not only makes more materials flow into the bulge area but effectively diminishes the axial compression force; The good or bad characteristics of tube blank material is also one of the decisive factors and when material is selected, we first consider its' formability.

模拟结果表明，当后桥壳需要两次进行胀形，两次胀形比比值约等于1时，胀形结果最好；合适的加载路径要经过多次调试，能根据胀形缺陷对内压力和轴向力的大小进行迅速地合理调整；良好的润滑环境对后桥壳液压胀形的影响巨大，要尽量减小管坯与模腔内壁的摩擦力，不但使更多的材料流入胀形区，而且能有效的降低轴向力的大小；管坯材料性能的好坏也是影响胀形的决定性因素，选材时首先要考虑材料的成形性。

Compensation products have universal, single-axial type, rehabilitation to the type of single-axial-pressure, the tension bar, small drawbars, with heating network series, non-binding, all buried, half-buried, buried -, The multi-storey, three of New Coal pipeline to the fiber-and compensation, marine compensation, with compensation for the cement industry, and so on.

补偿器产品有通用型、单式轴向型、复向型、外压单式轴向型、大拉杆、小拉杆、热网用系列、无约束、全埋式、半埋式、直埋式、多层式、煤粉管道用新型三向式以及纤维补偿器、船用补偿器、水泥行业用补偿器等。

The axial fixed position preload is applied to middle ring of the shaft,the axial rigidity of the angular contact ball bearing is obtained by the impulse excitation tests.

对转台中环主轴施加轴向定位预紧力，通过脉冲激励法试验得到角接触球轴承的轴向刚度，试验结果与理论结果吻合较好，为转台研制中各轴系预紧量的控制提供了理论和实验依据。

The time history curves of axial load and impact load were recorded,the effect of axial load on mid-span deflection was achieved.

试验中记录的撞击力时程曲线可分为迅速上升的冲击力加载、平稳的塑性动力响应和卸载三个阶段。

At 24 h, Ang1 was expressed mainly in the lens, optic cup, mesencephalon, ventral part of hindbrain, and myotomes in the somites, while zfTie2 was mainly expressed in intersomitic vessels including dorsal aorta and axial veins, and sprouting vessels from the dorsal aorta in the trunk. VEGF was expressed mainly in the lens, optic cup, mesencephalon and myotomes in the somites, while zfFlk1 was mainly expressed in intersomitic vessels including dorsal aorta and axial veins, and sprouting vessels from the dorsal aorta in the trunk.

结果从受精卵胚胎发育第12小时可见血管内皮细胞生长因子和血管发生素1及其相应受体flk1和Tie2的表达；在受精卵胚胎发育的第16小时，血管内皮细胞生长因子和血管发生素1主要在头部和尾部胚芽表达；第24小时在眼球、视窝、中脑、后脑的腹前侧和肌节中表达，Tie2和Flk1主要在肌间背部动脉血管、躯干新生血管芽和轴向静脉中表达。

Both plain and enhancement CT scannings were made in 48 cases,8 cases with contrast CT and 4 cases with plain CT only.60 cases with axial view were scanned,and 26 cases with coronal and axial view.

结果 CT对鼻咽癌的原发部位，浸润范围、途径和颈淋巴结转移情况显示较佳。横断面 CT扫描和冠状面 CT扫描联合应用可以提高鼻咽癌 CT诊断的准确性。

The problem of noise of the fan is studied with the non-linear theory, and pressure pulsation of axial flow fan's inside flow was measured by dynamic pressure sensor, the gas-structure coupled noise of contra-rotating axial flow fan was studied through a

摘要用非线性动力学的理论对风机噪声问题进行了分析，同时运用实验手段测量了轴流风机流场内部流动的压力脉动，从全新的角度研究了对旋风机的气固耦合噪声。

The experimental and analytical results show that the axial rigidity of the corrugated pipe is 23.0 percent of the bare pipe with the same thickness and diameter,and the thermal compensation performance of the former is 2.27 times the latter's under equal-stress condition.By using corrugated pipe bundle instead of the bare pipe bundle with the same stiffness as its tube sheet,the axial thermal compensation can be increased by 40.4 percent,and the corresponding pulling-out force is 53.2 percent of that of the bare pipe bundle.

研究结果表明，波节换热管单管的刚度为相应光管的23.4%；在最大应力相同的条件下，波节换热管的轴向热补偿量为相应光管的2.27倍；在光管管束与壳体等刚度条件下，用波节管管束代替光管管束，轴向热补偿量可提高40.4%，相应的拉脱力为光管管束的53.2%。

In the maximal axial pulling-out force group, the hollow nails were directly implanted into 10 femoral neck samples after drilling at the axial center.

最大轴向拔出力实验分组，10个股骨颈在轴向正中钻孔后直接置入空心钉，另10个股骨颈在轴向正中钻孔后注入聚甲基丙烯酸甲酯骨水泥，然后置入带侧孔的空心钉。

Summary In copyright infringement cases,if the alleged infringer uses or even plagiarizes the copyrighted works or parts thereof,which causes no substantially adverse effect on the normal exploitation of the work,nor does it inflict any substantial damages to the right owner,the de minis doctrine should be applied to exempt the liabilities of the defendant and seek the balance of interests between the right owner and the general public embodied by the copyright law.

在侵犯著作权案件中，如果被控侵权行为人虽未经著作权人的同意，使用甚至抄袭了受著作权保护的作品或作品的片段，但若情节轻微，未对该作品的正常使用产生任何实质不利的影响，亦未对权利人的权利造成实质性的损害，则应适用&不计琐细原则&，免除行为人的责任，以寻求在权利人利益与著作权法所体现的社会公共利益之间的平衡。

This new product will become our best seller.

这个新产品会成为我们最畅销的产品。