查询词典 axial-flow

Also in order to maintain the main impeller axial force balance, have to set up a vice-impeller structure, it can reduce the pressure sealed chamber so that the axial force pump and mechanical seal life expectancy are greatly increased.

另外为了保持主叶轮轴向力的平衡，须设置一个副叶轮结构，它能降低密封腔的压力，使电泵的轴向力及机械密封的寿命均大大提高。

Also in order to maintain the balance of the main impeller axial force, shall be a Vice-impeller structure, it can reduce the pressure sealed chamber, so that the axial force pump and Magnetic pumps mechanical seal life are greatly increased.

另外为了保持主叶轮轴向力的平衡，须设置一个副叶轮结构，它能降低密封腔的压力，使电泵的轴向力及机械密封的寿命均大大提高。

By the support of National Nature Science Foundation, some key problems of CVT were investigated, and some useful results were obtained as follows:(1) The relations between metal-belt misalignment in axial direction and transmission parameters were studied. By designing curved generating line pulley or adjusting the axial displacement of pulley, the degree of misalignment of the metal belt was decreaed.

本文在国家自然科学基金重点项目(编号：59835160)，国家教委重点项目教技司(98121号，重庆市科委攻关等项目的资助下，对CVT传动的若干关键问题进行了研究，本文的工作为CVT传动的研究、应用和开发奠定了基础。

The axial direction and radial direction spectrum is blue-shift or red-shift. On axial direction, the blue-shift or red-shift increases with the relative propagation distance, truncation parameter, refractive index constant increases and temporal coherence length decreases, and the spectral-shift gurgitation becom gragually steady. On radial direction, spectral switches appear, and the truncation parameter, spatial coherence parameter, temporal coherence length and refractive index constant also influence critical position and transition height et al.

光谱沿轴向、径向均出现蓝移或红移，随着相对传输距离、光阑截断参数、空间相干参数及折射率结构常数的增大，脉冲时间相干长度的减小，轴向光谱蓝移量或红移量逐渐增大，并且由明显地起伏逐渐趋于稳定，沿径向出现了光谱开关，光阑截断参数、脉冲时间相干长度、空间相干参数和折射率结构常数对光谱开关的数目、光谱开关的临界位置和光谱跃迁量等也产生影响。

Then, the design and calculation of high voltage platform, central region, spiral inflector and the axial injection beam line is described in detail. The result of research shows that axial injection with high voltage platform is not only feasible but also efficient.

论文首先描述了与设计相关的回旋加速器理论，束流传输理论和空间电荷效应的有关理论，然后对组成该系统的高压平台，新的SFC的中心区，螺线静电偏转器和轴向注入束流线的设计研究作了比较详细的描述。

The main results of the study are obtained as follows:1 In order to analyze and study the physical and mechanical characteristics of Lianyungang marine soft clay deeply, large numbers of basic mechanical characteristics tests and tri-axial shear tests are completed.2 In order to investigate the loaded and failure characteristics of the cement-soil, the cement-soils for the different ratio and different cure time are studied in the laboratory, and their unconfined compression tests and tri-axial shear tests are performed.3 Based on the solution of one-dimension consolidation, the one-dimension consolidation of the double-layered foundation is solved for two-grade loading in virtue of transcendental equation; Simultaneously, the one-dimension consolidation of the double-layered foundation is solved by means of Laplace transform for two-grade loading, and Stehfest numerical transform is applied in Laplace's inverse transformation; Furthermore, according to the practical foundation shapes, the consolidation models of the soil between piles and the substratum are built and solved respectively.4 The effect of each parameters on the consolidation of the double-layered foundation is discussed, and the solution of load transfer method for double-layered foundation is applied in A1-A4 section of Lian-Xu expressway. The results of calculating settlement of the double-layered consolidation theory are basic agreement with the measuring settlement results.

取得了以下几方面的研究成果：1针对连云港海相软土进行一维固结和三轴剪切试验，深入分析连云港海相软土的物理力学特性。2模拟水泥土搅拌桩施工，在室内制备不同配比、不同龄期的水泥土试样，并进行无侧限抗压试验和三轴剪切试验，揭示水泥土的受力特性及破坏特性。3运用超越方程，以双层地基一维固结解析解为基础，推导出二级加荷条件下双层地基的固结解析解；同时，通过荷载传递法并借助Laplace变换对双层地基的固结问题进行了数值求解；此外，根据实际的地基结构，建立了桩间土和下卧层的固结模型并分别进行求解分析。4分析探讨了双层地基中各参数对双层地基固结的影响程度，并运用荷载传递法的解答计算了连-徐高速公路A1-A4标水泥土搅拌桩处理段的六个断面，计算结果与实测数据有较好的一致性。

The average correlative coefficients of linear regression function for isochronous stress- axial strain curve are 3.92% higher than that of average correlative coefficients of linear regression function for isochronous stress- radial strain curve, so nonlinear creep property of the fine sandstone specimen in axial direction is correspondingly weaker than that in radial direction.

应力－轴向应变等时曲线线性回归函数的平均相关系数高出应力－径向应变等时曲线线性回归函数的平均相关系数3.92%，因此其轴向非线性蠕变特性相对于径向非线性蠕变特性更弱。

According to the projection space, line and plane can be divided into upward-traveling and downward-traveling. The concepts of near axial-terminal and far axial-terminal to the straight line projection is introduced. The rule of the visibility of line and plane intersection is deduced.

将直线和平面按其在投影空间的位置，分为上行和下行两类，对直线的投影引入近轴端和远轴端的概念，有助于对线面相交空间位置的理解，而且使直线与平面相交可见性的规律更加清晰和直观。

The current research points out that for the CFCHS joints the linear extrapolation method can be used for chords,whereas the quadratic extrapolation method must be used for braces.The hot spot stress distributions on the CFCHS joints tend to be more uniform and their SCFs become smaller significantly,compared with the CHS joints.Axial tension on the brace puts the CFCHS joints at a disadvantage,which produces higher SCFs than axial compression.The effects of nondimensional geometric parameters β,τ and γ on SCFs of the chords of the CFCHS joints are basically the same as those of the CHS joints,but for the braces,there is a bit difference in the effects of parameters β,τ and γ between the two kinds of joints.Concrete has the function of improving the CFCHS joint rigidity and then decreasing SCFs which is expected to increase fatigue strength,but concrete strength grade does not exert significant influence on SCFs.

研究表明：CFCHS节点的热点应力，对主管可采用线性外推方法，对支管需采用二次外推方法；相比CHS节点，CFCHS节点的热点应力分布趋于均匀，SCF显著减小；CFCHS节点支管轴向受拉比受压不利，SCF增大；CFCHS节点几何参数β，τ，γ对主管SCF的影响效应与CHS节点基本一致，但是对支管SCF的影响效应与CHS节点有些差异；混凝土的作用主要是改善CFCHS节点刚度，从而降低SCF，并预期可提高疲劳强度，但混凝土自身强度等级的高低没有显著影响节点的SCF。

A large number of real data about axial load, axial displacement and vibration character istics of roll system are obtained.

轴向动载荷系数的确定为合理地分析轴向力对轧辊轴承的作用提供了依据。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。