查询词典 axial-flow

In the study of microwave sintering of BaTiO〓 PTC ceramics, when the applied microwave power are above than a certain value, the abnormal axial shrinkage of the sintered sample will occur, by the analysis of SEM and XRD, it is found the microstructure and phase are different with conventionally sintered sample, the reason for this phenomenon is due to orientational grain growth by the action of electric field in the microwave sintering process.

微波烧结BaTiO〓电子陶瓷时，当所加的微波功率超过一定值时，首次发现烧结样品出现轴向异常收缩现象，采用SEM、XRD等分析发现其微观结构与常规烧结有巨大的差异，这是BaTiO〓材料的晶粒在微波场中受电场力作用而发生的取向生长造成的。

In this thesis, the basic arithmetic of PIV software - cross-correlation arithmetic is introduced in detail, During the data process, through processing the two sequential images by the cross-correlation arithmetic, the vector charts of particles velocity can be obtained, so is the chart of absolute velocity, with velocity decomposed into the radial velocity and axial velocity.

本文对试验所获得的连续图像通过互相关算法，获得颗粒速度矢量图，并将速度分解为径向速度和轴向速度，对每一小区域内的颗粒按速度方向不同进行速度平均，获得颗粒的平均速度分布曲线。

An axial loading of 500 N was put to the model under bilateral acetabulum constraint.

模拟人体双腿直立位的生理姿势，对模型施加500 N轴向载荷。

The company also manufactures fiberglass tanks, tank, FRP, FRP / PVC, FRP / PP pipes, FRP tanks, acid mist purification tower, all kinds of glass fiber reinforced plastic ventilation pipes, a variety of centrifugal fans, axial fan, fan housing machine, wet dust and a glass fiber reinforced plastic trays, etc., and based on user requirements Design a variety of glass fiber reinforced plastic products.

公司还生产玻璃钢槽车、贮罐、FRP、FRP/PVC、FRP/PP管道，玻璃钢水箱，酸雾气净化塔，各种玻璃钢通风管道，各种离心风机、轴流风机、屋机风机、湿式除尘器及玻璃钢桥架等，并根据用户要求设计制作各种玻璃钢产品。

In addition, some experience formulas for them are regressed. The third chapter establishes a unified S-N curve equation to calculate multi-axial fatigue ultimate strength of concrete considering both the effect of confinement and minimum/maximum stress ratio, based on the triaxial fatigue test data in this paper and the test results under uniaxial and biaxial fatigue loading in previous literatures. Moreover, the consistency of calculating condition fatigue ultimate strength with fatigue life distribution and initial ultimate strength distribution is analyzed.

第二章简要地介绍了本文三轴疲劳试验装置，进行了两向等侧压约束下混凝土立方体试件三轴受压等幅和变幅疲劳试验，分析了三轴受压疲劳破坏机理，给出了相应的疲劳破坏试验判断标准；得到了混凝土在两向侧压约束下单级和多级受压疲劳的变形发展规律，包括最大纵向应变、残余应变、最大纵向应变率和疲劳变形模量等随循环次数的发展规律以及疲劳损伤的演变规律，并给出了相应的经验公式。

Comparing with the case of no adit, because of arch tunnel set being broken; the intersection structure is subjected to combination of complicated stresses including transverse stress, but not the axial stress.

与无横通道情况相比，由于拱形支撑作用被切断，结构受力己不再是单一轴向受力，而产生了部分弯曲受力的复杂受力状况。

The stress calculation method and strength condition of PET aerated water bottle were obtained from theory. The strength of PET aerated water bottle was simulated and calculated ANSYS. The stress graphics of the bottle with different thickness was plotted and their stress property was analyzed. The influence of axial load and grooves on bottle stress was also studied.

从理论上得到了聚酯碳酸饮料包装瓶的应力计算方法和强度条件；利用ANSYS对其强度进行了有限元模拟和计算，得到了不同厚度的聚酯碳酸饮料包装瓶的应力图，并分析了其应力特点；同时研究了轴向载荷和瓶体开凹槽对瓶体应力的影响。

The stress calculation method and strength condition of PET aerated water bottle were obtained from theory. The strength of PFT aerated water bottle was simulated and calculated ANSYS. The stress graphics of the bottle with different thickness was plotted and their stress property was analyzed. The influence of axial load and grooves on bottle stress was also studied.

从理论上得到了聚酯碳酸饮料包装瓶的应力计算方法和强度条件；利用ANSYS对其强度进行了有限元模拟和计算，得到了不同厚度的聚酯碳酸饮料包装瓶的应力图，并分析了其应力特点；同时研究了轴向载荷和瓶，婚开凹槽对瓶体应力的影响。

To generate lift and propulsion the Lippisch Aerodyne would utilize two co-axial propellers, diverting the slipstream downwards to achieve VTOL.

产生升降机及推进该利佩什博士aerodyne将利用两个合作轴螺旋桨，分流的Slipstream向下实现垂直起降。

The sensitiity of leukocyte scintigraphy in detecting chronic osteomyelitis in the peripheral skeleton was 84%(95% confidence interal, 72% to 91%) compared with 21%(95% confidence interal, 11% to 38%) for its detection of chronic osteomyelitis in the axial skeleton. The specificity of leukocyte scintigraphy in the axial skeleton was 60%(95% confidence interal, 39% to 78%) compared with 80%(95% confidence interal, 61% to 91%) for the peripheral skeleton.

白血球闪烁显像在检测慢性骨髓炎中对于外周骨的敏感性为84％（95％可信区间为72％-91％），而其对中轴骨的敏感性为21％（95％可信区间为11％-38％），白血球闪烁显像在检测慢性骨髓炎对中轴骨的特异性为60％（95％可信区间为39％-78％），而其对外周骨的特异性为80％（95％可信区间为61％-91％）。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。