查询词典 average error

It also can be used to measure the geometrical tolerance, such as straightness error, roundness error, cylindricity error, parallelism error, perpendicularity error, angularity error, coaxiality error, symmetry error and circular run-out error etc.

该仪器集机、光、电于一体，采用了新的光路系统和近些年最新的测量方法及数据处理方法，具有功能多、体积小、重量轻、操作方便、非接触测量、测量精度高等特点。

In this paper, some characteristic functions of the multifunctional single-flank mesh gear tester of model CD320G-D which is applying gear integrated error measuring technique, computer technique, error separation technique, fault diagnosis technique and error prediction technique, including automatic searching of profile error start point, determination of profile barrelling, separation of profile form error and profile slope error, measurement of profile error with evaluation range subtracting tooth tip, measurement of tooth topograph and statistical analysis of gear manufacture error, are presented.

阐述了综合应用齿轮整体误差测量技术、计算机技术、误差分离技术、故障诊断技术和误差预报技术的多功能 CD320G-D 型单啮仪的一些具有特色的功能。这些功能包括齿形误差起测点的自动找定、凸形齿凸形量的测定及其形状误差与倾斜误差的分离、取值范围扣除齿顶部的齿形误差的测量、齿面轮廓度误差的测量以及齿轮加工误差的大样本统计分析。

Second, the data checking and correction process, to understand the various sources of measurement error, its three main areas: equipment error (determined by the instrument itself, is an objective source of error), observation error (due to the technical level personnel a result of belonging to a subjective source of error), external influence error (subject, such as temperature, atmospheric refraction effects of external factors such as these factors are also constantly changing and difficult to control, belonging to a variable source of error).

其次，在对数据的检查和矫正的过程中，明白了各种测量误差的来源，其主要有三个方面：仪器误差（仪器本身所决定，属客观误差来源）、观测误差（由于人员的技术水平而造成，属于主观误差来源）、外界影响误差（受到如温度、大气折射等外界因素的影响而这些因素又时时处于变动中而难以控制，属于可变动误差来源）。

To analyze the pseudo phenomena caused by migration velocity error, the paper firstly studied the depth error between post-stack migration and prestack migration caused by same velocity error, and found the depth error was only relative to velocity error and had no direct matter with methods of depth migration (post-stack migration or prestack migration). Then the paper did numerical simulation of a complex lenticular body model with wave-equation modeling and migration, and found that the velocity error could not only induce depth error, but also could change the modality of construction and the event of subjacent layers. Furthermore, it could change the frequency of reflective event. They are the pseudo phenomena caused by migration.

从分析偏移速度误差带来的各种假象出发，本文首先对比分析了速度误差对叠后深度偏移和叠前深度偏移的影响，发现偏移剖面的深度误差仅与速度模型的误差有关系，与具体的偏移方法没有直接的关系；然后对一个复杂的透镜体模型进行了波动方程叠后正演和偏移计算，详细地讨论了不同的速度误差带来的各种假象，发现速度误差不仅会带来深度误差，而且会造成构造体的形态变化，下覆地层同向轴的扭曲，还可能引起地层同向轴的频率发生变化，给资料解释带来一定的假象。

Error analysis In order to analysis the pose error of the hexapod machine tool, considering the characteristics of the parallel mechanism,"analysis on the error prominency factors for the hexapod machine tool pose error"is proposed. Numerically, the error prominency factor can express the influence on the pose error of the tool resulted from the mechanism parameter error within the whole workspace.

四、位姿误差分析为了定量地对并联机器人机床位姿误差进行分析，结合并联机构的特点，首次提出了&并联机器人机床位姿误差放大因子分析法&，因位姿误差放大因子是反映机床机构参数误差对刀具末端误差影响大小的机床工作空间内的统计值，因此既可作为机床结构参数精度设计的依据又可对机构参数进行优化。

Results showed that average lint yield of F1 was 1296.30 kg/hm^2, which was an increase by 214.38 kg/hm^2, compared with CK and its average competitive dominancy was 19.81%; Average lint yield of F2 was 1168.65 kg/hm^2, an increase by 86.73 kg/hm^2, compared with CK and its average competitive domain was 8.01%; Average lint yield of F3 was 1117.65 kg/hm^2, an increase by 35.73 kg/hm^2 compared with CK and its average competitive dominancy was 3.30%. F3 had the highest competitive dominancy, then F2 and F3 whose decreasing ratio is consistent with their competitive dominance, and their average yield decreasing ratios were 12.59% and 17.62%, respectively.

结果表明，F1平均皮棉总产量为1296.30 kg/hm^2，比对照泗棉3号增产214.38 kg/hm^2，平均竞争优势为19.81%；F2平均皮棉产量为1168.65 kg/hm^2，比对照增产86.73 kg/hm^2，平均竞争优势为8.01%；F3平均皮棉产量为1117.65 kg/hm^2，比对照增产35.73 kg/hm^2，平均竞争优势为3.30%。F1竞争优势最大，其次为F2，F3，F2，F3的衰退率与竞争优势一致，其平均优势衰退率分别下降了12.59%和17.62%。

In recent years,medial average has still not been introduced in Sports statistics,which is used as a textbook in institutes of P.E. On the basis of analyzing the nature of medial average ,the author proposes that medial average is commonly got using average rates in sports researches because of its features and laws. Since medial average is gained by reciprocal of its observation value,a quick method of arithmetical average might be medial average equals to...

对近年来未把调和均数列入体育院校《体育统计学》通用教材提出了不同的看法，认为根据体育运动的特点与规律，在体育科研中，利用速率计算均值的情况较多，由于调和均数是应用其变数值的倒数来计算算术平均数，所以在加权正确的情况下，调和均数与算术均数计算结果相等，是算术均数的简捷计算方法，应该向学生介绍调和均数并列入教材。

The average percentage of polymorphic bands are 72.06% for ISSR and 66.67% for RAPD respectively. The genetic diversity of ginkgo revealed by ISSR (the average effective number of alleles is 1.8780, the average Nei"s gene diversity is 0.4652, and the average Shannon"s information index is 0.6574) are all higher than those by RAPD (the average effective number of alleles is 1.7842, the average Nei"s gene diversity is 0.4317, and the average Shannon"s information index is 0.6211), while the standard errors of the parameters estimated by ISSR were lower. Therefore, ISSR molecular markers are more suited than RAPD molecular markers when testing the genetic diversity of ginkgo populations and determining the genetic relationship of among populations or among individuals which are much similar hereditarily.

本文应用RAPD和ISSR两种分子标记技术，选取中国5个可能的野生银杏居群共计75个样品，对其遗传多样性进行了研究，得出以下结论：(1)用筛选出的12个RAPD引物和10个ISSR引物进行PCR扩增，分别扩增出65条和68条重复性高、清晰的条带，多态性位点百分率分别66.67%和72.06%，ISSR揭示的银杏遗传多样性(平均有效等位基因数目为1.8780，平均基因多样度为0.4652，平均信息指数为0.6574)高于RAPD所得到的结果(平均有效等位基因数目为1.7842，平均基因多样度为0.4317，平均信息指数为0.6211)，其所估算参数的标准差要低于RAPD所估算出的值，因此，在研究亲缘关系非常近的银杏物种的遗传多样性并试图确定居群间或个体间的遗传关系时，ISSR分子标记技术比RAPD分子标记技术更为合适。

Of 12 tomato lines, the analysis on the 4 fruit nourishment quality traits (the contents of vitamin C, total soluble solids and dry matter and ratio of sugar-acid ) was carried out to study the four kinds of disparities, which included the interspecific one, the one between two varieties in the same species , the one between the lines bred by different means in the same variety ,and the one between the different fruit-shaped lines in the same variety .The analytic method of orthogonal comparison of single degree of freedom was applied. The results showed that the line of Lycopersicum pimpinellifolium was better than the average of the lines of L.esculentum in the 4 traits at significant level of 1%, the average of the lines of var.cerasiforme was better than the average of the lines of var.vulgare in the 4 traits at significant level of 5% or 1%,and the two space mutation line(YH02-2 or YH02-6) was better than the average of the other lines of the same variation in the 4 trait, respectively, at significant level of 1%. Of the lines of var.cerasiforme , the lines with pear fruit were lower than the average of the lines with round-shaped or plum-shaped fruits in the 2traits(the contents of vitamin C and total soluble solids), at significant level of 1%,the lines with plum-shaped fruits were higher than the average of the lines with round-shaped fruits, at significant level of 1%,and the lines with yellow-colored fruits(YH02-11) was lower than the average of the lines with red-colored fruits(YH02-1and YH02-7) in the trait of the contents of vitamin C.

对12个品系进行种间、种内变种间、变种内不同选育方式间、变种内不同果实形状间在果实营养品质（果实维生素C含量、可溶性固形物含量、干物质含量和糖酸比）上的差异进行分析，采用统计学上单一自由度正交比较分析法与植物学分类相结合的方法进行分析，结果表明：醋栗番茄种品系YH02-12在4个营养品质性状上，极显著高于普通番茄种品系；樱桃番茄变种品系在4个营养品质性状上的平均水平极显著或显著高于普通番茄变种品系的平均水平；2个空间诱变品系YH02-2、YH02-6在4个营养品质性状上均极显著高于同变种的其他品系的平均水平；樱桃番茄变种品系中，梨形果品系YH02-5、YH02-8的果实维生素C、可溶性固形物含量均极显著地低于樱桃番茄变种中圆形或李形品系的平均水平，李形果品系YH02-9在4个营养品质性状上均极显著地高于圆形果品系的平均水平，黄色圆形果品系YH02-11的果实维生素C偏低于红色圆形果品系YH02-1和YH02-7。

The main production performancls of Guide black fur type sheep were determined.The results were as follows:①The average body weight,the average wool yield and the average staple length of adult ram and ewe were 49.65 and 39.96kg,1.75 and 1.45kg,26.65 and 24.15cm,respectively.②The average birth weight,the average daily gain and the average weight at the age of four months of ram lamb and ewe lamb were 2.87 and 2.89kg,0.12 and 0.12kg,12.95 and 10.43kg,respectively.③The average leather area of small lamb skin ...

作者对贵德黑裘皮羊主要生产性能进行了测定，结果：成年公、母羊体重、产毛量、毛辫长度分别平均为49.65、39.96 kg、1.75、1.45 kg和26.65、24.15 cm；羔羊初生重、羔羊日增重、4月龄羔羊断奶重公、母羔分别平均为2.87，2.89kg，0.12，0.12kg和12.95，10.43kg；小羔皮皮板面积平均为642.13cm〔2〕，卷花形状：环形、半环形、波浪形、无花形分别占29.0，51.4，18.6，1.0%，与20年前相比，除产毛量外，其它主要形状有明显的下降趋势。

Looking to bounce back from defeat against Cesena last weekend, the Calabrian boss will be sticking to his tried and tested 4-3-3, with Lopez and Sedivic joined up front in Giampaolo's absence by either Nanni or Plasmati.

鉴于上周末对切塞纳的比赛中反败为胜，这支南方球队将会更坚持其一贯而有效的4-3-3阵型，洛佩斯和塞德维奇将取代受伤缺席的詹保罗，和纳尼或者帕斯马蒂中的一个搭档锋线。

Meanwhile, their exposure to the more freewheeling ways of the West broadened dramatically.

另外，西方较自由的生活方式对年轻人的影响增大。