查询词典 attenuator

This paper introduces the principal theory , process and test technology of variable optical attenuator.

本文分析了集成化可变光学衰减器的工作原理、工艺制作和测试技术。

This 1206 size attenuator has excellent high frequency characteristics.

这1206大小衰减器具有良好的高频特性。

Optical attenuator is a kind of widely used passive optical component.

光衰减器是一种广泛应用的无源光器件。

By innovative use of the attenuator,the linearity handling ability of the system is dramatically improved.

通过使用衰减器，系统处理线性度的能力得到很大的提高。

Variable optical attenuator is one of the key devices in wavelength-division multiplexing systems.

可变光学衰减器是波分复用系统的关键器件之一。

Fourthly, a detailed process to design and optimize a variable optical attenuator was researched.

然后是详细的介绍了一种非对称的Y分支型光衰减器的设计优化过程。

This is not an HiFi attenuator but might come useful as a general purpose audio attenuator.

Thi 这不是一个音响，但可能出现衰减器作为一个通用的有用的音频衰减。

7 To 3.3 V operating supply voltage 44.1 kHz sampling frequency 16.9344 MHz (384fs) system clock Built-in crystal oscillator circuit 16-bit, MSB rst, rear-packed serial data input format ( 64 fs bit clock) 8-times oversampling digital lter · 32 dB stopband attenuation ·+0.05 to -0.05 dB passband ripple Deemphasis lter operation · 36 dB stopband attenuation ·-0.09 to +0.23 dB deviation from ideal deem- phasis lter characteristics Attenuator · 7-bit attenuator (128 steps) set by microcontrol- ler Soft mute function set by parallel setting ·(approximately 1024/fs total muting time) Mono setting · Left or right channel mono selectable by micro- controller Built-in innity-zero detection circuit , two-channel D/A converter · 3rd-order noise shaper · 32fs oversampling Built-in 3rd-order post-converter low-pass lters 24-pin VSOP package Molybdenum-gate CMOS process

2.7至3.3 V工作电源电压为44.1千赫的采样频率16.9344兆赫（384fs）系统时钟内置晶体振荡器电路的16位，MSB在前，后包装的串行数据输入格式（64飞秒位时钟）8倍超采样数字滤波器·32分贝的阻带衰减·+0.05至-0.05分贝通带纹波去加重滤波器的运作·36 dB抑制频宽衰减·-0.09到0.23 dB的偏差认为不理想，症状困扰评估滤波特性衰减器·7位衰减器（128级）集由单片机在-莱尔软静音功能的平行设置·（共约1024/fs静音时间）单声道设置·左或右声道单声道微控制器可选的内置的无限零检测电路Δ，两通道的D / A转换器·第三阶噪声整形·32fs过采样内置三阶后转换器的低通滤波器24引脚VSOP封装钼栅CMOS工艺

The theories of cuneiform prism and series neutral glass slices used as laser attenuator are analyzed in this paper. An aberration-free laser quantitative attenuator made of cuneiform prism is adopted and a series of neutral attenuated slices are used for adjusting laser-beam enegy at the same time.

分析了楔形镜和中性玻璃衰减片组对光束的衰减原理，采用反射式楔形镜作为无像差定量衰减器，并同时使用中性玻璃衰减片组微调光束能量。

The results show that this attenuator, which is 12mm×8mm×0.5mm and works at low temperature, can be used alone or integrated into HTS system to decrease system volume and weight. Insertion loss of this attenuator is about 0.2dB, whose magnitude is one order lower than that of a conventional attenuator. Attenuation step about 0.01dB can be achieved, which is 1~2 orders lower in magnitude than conventional attenuators.

主要结论如下：光控高温超导微波可变衰减器在液氮温区工作，电路尺寸为12mm×8mm×0.5mm，可单独使用也可集成于高温超导系统中，可大幅减小系统的体积与质量；高温超导衰减器的插损小于0.2dB，比常规衰减器低1个量级；高温超导衰减器的可变衰减步进值小于0.01dB，比常规衰减器低1~2个量级。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐