查询词典 atomizing

Here is a fine metal powder manufacturing program base on closed couple gas atomizing technology.

本项目是以高能气雾化技术为主的超细金属粉体加工项目。

In vc 6.0 circumstances, the use of DirectX atomizing effect was an example to explain the effect of aerosol...

在vc++6.0环境下，利用directx写雾化效果的例子，阐述雾化效果的原理，适应初学者适应初学者，学习direcx的使用。

Furthermore, in order to obtain satisfactory release, the atomizing diameter should be optimized around 40—120 μm , and the ideal average diameter of the membrane pores should be in the range of 50—150 nm.

为了获得达标的控释肥，必须将雾化颗粒控制在40～120 μm的范围内，将膜的平均孔径控制在50～150 nm范围内，才能获得预期的控释性能。

The test method droplet diameter and distribution of doubledeck nozzle is proposed and experimental investigation on its atomizing characteristics is accomplished.

为此，提出了雾滴直径及喷雾密度分布的测试方法，并对双层喷嘴的雾化特性进行了实验研究

The preparation technique of metal powder by electromagnetic vibration atomizing and quenching method is discussed in this text.

本文介绍了一种新发明的电磁振动雾化-速凝制金属粉方法，研制了电磁振动雾化-速凝制备金属粉炉，并用该装置制造了NdFeB合金粉，讨论了电磁振动雾化频率、激振力等参数对制粉的影响因素

Methods: Treating 13 patients by systemic anti-allergy and sustained atomizing inhalation.

对13例患者采取全身综合抗过敏及持续药物雾化吸入治疗。

D3d atomizing effect of source code, the best guide beginners!

这是一个d3d雾化效果的源代码，初学者的最佳指导！

Based on the structural design of the centrifugal nozzle, the article gave an experimental study on the atomizing property of particulate size distribution for this kind of nozzle.

在离心式喷嘴结构设计的基础上，对喷嘴粒子尺寸分布的雾化性能进行了试验研究。

Hot air enters into stirring and crushing and drying chamber from the botton of drier with suitable atomizing speed. It exerts strong shearing, blowing, floating and rotating effect to raw material. Therelore raw material is granulated through centrifuge, sheafing, impacting and friction effect. It strengthens the process of heat exchange.

热空气由入口管以适宜的喷动速度从干燥机底部进入搅拌粉碎干燥室，对物料产生强烈的剪切、吹浮、旋转作用，于是物料受到离心、剪切、碰撞、摩擦而被微粒化，强化了传质传热。

The results indicate that the cooling rate of melt droplet that can not break further depends not only on its diameter, but also on its position in atomizing chamber. As a result, the same sized particles in different positions show different cooling rates and two different kinds of microstructures. The cooling rates of melt droplets range from 104 to 108 K/s, and the critical cooling rate for glass formation of Al-Ni-Y is about 105 K/s. Moreover, the corresponding maximum diameter of amorphous particles is 25 μm, which accords well to the theoretical analysis results. The new approach, reflecting the complexity of close-coupled gas atomization objectively, is available and effective to evaluate the cooling behaviors of close-coupled gas atomization.

结果表明：在一定的工艺条件下，紧耦合气雾化存在多种破碎模式，熔滴的冷却速率因直径、雾化位置的差异，相同直径熔滴经历结晶和非晶化2种不同冷却行为；依据Al基合金粉末的粒度分布和微观结构，结合熔体的雾化过程及冷却模式，确定熔滴冷却速率的上、下限；实验得出熔滴的冷却速率为104~108 K/s，Al-Ni-Y合金的非晶化临界冷却速率为105 K/s，能形成非晶态的熔滴最大直径为25 μm左右，实验结果与理论分析结果较吻合，比较客观地反映紧耦合气雾化的复杂过程。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。