查询词典 atomie heat

The main object of this research is to investigate synthesis of Cu23Cl Cu and CuO nanoparticles through electrospinning and heat-treated method The research is mainly focused on preparative parameter and the change of heat-treated temperature to form the nanoparticles inlaid in silicon fibers the shape and color change are dicussed First of all to prepare the Polyvinyl butyral and silica dioxide complex nanofiber by electrospinning and then to investigate different heat-treated temperature and reactive time to being an influence on the products The results detected by SEM XRD TEM EDS FTIR combined sol-gel process and electrospinning can prepare Polyvinyl butyral and silica complex nanofiber The experimental result is found when heat-treated temperature is 100~4750C it can produce Cu23Cl nanoparticles; Above 4750C~ 4900C it can produce Cu nanoparticles; Above 450~7000C it can produce CuO nanoparticles And the viscosity is lain between 20~40cp and the sol-gel process time is 3hr it can produce the thinner fibers The average diameter of the fibers are 107 88±21 01nm;Due to the nanoparticles inlaid in the silica fibers the thinner fibers can be inlaid the smaller nanoparticles so this is the result that the experiment is expected To calcine the complex fibers is to produce surface silica fibers contain Cu23Cl Cu and CuO nanoparticles due to surface plasma resonance it make the color of the fibers become yellowish green from light white green turn into the red nuclear finally As the experimental result to utilize sol-gel process combine electrospinning can produce porous silica fibers contain Cu23Cl Cu and CuO nanoparticles

本研究旨在探讨「利用放电纺丝和热处理法来合成Cu23Cl、Cu和CuO奈米粒」之研究，实验著重在制备参数与热处理温度变化对所形成的奈米粒镶嵌在二氧化矽纤维中的形态与颜色变化探讨。首先，利用放电纺丝法制备出聚乙烯醇缩丁醛及二氧化矽之奈米纤维，比较不同的热处理温度与反应时间的改变对产物生成产生影响，进而研究不同热处理温度和时间对生成奈米粒的影响。产物经由SEM、XRD、TEM、EDS和FTIR等仪器分析结果显示，结合溶胶-凝胶法(sol-gel process)和放电纺丝法可产生聚乙烯醇缩丁醛及二氧化矽复合奈米纤维。实验结果发现，若热处理温度在100~4750C下可得到Cu23Cl奈米粒，475~4900C 可得Cu奈米粒，450~7000C以上可得 CuO奈米粒。而黏度介於20~40cp间和溶胶-凝胶时间为3hr时，可产生直径比较细的纤维，纤维直径为107 88±21 01nm；且由於奈米金属颗粒镶嵌在二氧化矽纤维中，直径比较细的纤维，可以得到比较小的奈米金属颗粒，这与实验预期相符。而锻烧此复合物产生多孔的二氧化矽纤维并包含Cu23Cl、Cu和CuO奈米微粒时，由於表面电浆子共震关系，而使纤维颜色由淡白黄绿色变成黄绿色，再变红褐色。由实验结果得知，利用溶胶-凝胶法(sol-gel process)结合放电纺丝法和不同热处理温度，可产生Cu23Cl、Cu和CuO奈米粒镶嵌在二氧化矽纤维。

Defines a d imensionless initial height of a heat source to reflect the effect of a heat source on heat distribution regularity of an air conditioned room with upward displacement, using variance analysis method obtains the dimensionless relationship between the heat distribution resularlty and other factors as Arn, Zr,ZJ and DIHHS, and reveals their importance in desoendins ceder as Arn, Zr, DIHHS and Zj.

提出了用热射流起始无因次高度来反映热源起始高度对下送风空调房间热分布系数α的影响，利用回归原理得出了α随阿基米德数Ar_n、热射流自由度Zr、机械射流自由度Zj及热射流起始无固次高度变化的准则关系式。用连结向量图法和对实验数据回归公式的F检验，对影响室内热分布规律的各个因素进行了分析，发现这些因素均为主要影响因素，其影响的相对主次依次为Ar_n，Zr，和Zj，回归结果具有很强的显著性。

The results are:(1) The brightness of the specimens will decrease and the chromatism will increase with the prolongation of time of heat treatment. Compared to heat treatment in vacuum, the specimens have more color changes after heat treatment in air, with the same temperature and time of heat treatment.

该研究的结论为：(1)在相同条件下，随着处理时间的延长，试材的明度减小，色差增大；空气介质中热处理和真空中热处理相比，在处理温度和时间相同的情况下，前一种方法处理后的试材材色较深。

The results are:(1) The brightness of the specimens will decrease and the chromatism will increase with the prolongation of time of heat treatment. Compared to heat treatment in vacuum, the specimens have less brightness and more chromatism after being heat treated in air, under the conditions of same temperature and time of heat treatment.

该研究的结论为：①在相同条件下，随着热处理时间延长，木材明度减小，色差增大；空气介质中热处理和真空中热处理相比，在处理温度和时间相同的情况下，前一种方法处理后的木材明度更小，色差更大。

The phase-changing material supplies heat for indoor heating by heat conduction upwards and convection current, meanwhile heat supply of the phase-changing material is adjusted by air duct and indoor aeration speed, which further regulates and controls heat supply speed.

相变材料通过向上导热和对流为室内供暖提供基础供暖量，同时通过调控空气通道与室内的换气速率来调整相变材料的供暖量，起到进一步调控供暖速率的作用。

Heat quench heat temper heat anneal heat correctitude.

分别是淬火，回火，退火，正火。

Determination of heat transfer coefficient for corrugate pipe heat exchanger is discussed, and the method of separating surface heat transfer coefficient from heat transfer coefficient with genetic algorithm is put forward.

讨论了波纹管换热器传热系数的测定，提出了采用遗传算法将对流表面传热系数从传热系数中分离出来的方法。

Because of the fuel-rich propellant's high heat value and combustion temperature, the common stainless steel crucible and oxygen bomb's parts are always burned in the combustion heat testing process. In order to realize the proper testing of combustion heat, some fireproof materials characteristics and their application in the combustion heat testing of fuel-rich propellant were studied. Those fireproof materials include acid washing asbestos, C/C compound materials, Al2O3 chinaware and tungsten crucible.

含金属富燃料推进剂由于热值高、燃温高，在燃烧热测试过程中普通的不锈钢坩埚及附件经常被烧毁，为了正确测试金属富燃料推进剂燃烧热，对酸洗石棉、碳／碳复合材料、Al2O3陶瓷坩埚和金属钨坩埚的基本耐烧蚀特性和在金属富燃料推进剂燃烧热测试中的应用进行了实验研究。

Based on the thermodynamic analysis of heat transfer process between water jet and the blade surface, the differential equations of heat convection and differential equation of steady heat conduction between water jet and the blade surface are established. Power expression of heat exchange and temperature field expression of the blade are derived.

根据对水射流与刀片间传热过程的热力学分析分别建立了水射流与刀片表面对流换热微分方程组和热源与刀片间的稳态导热微分方程，推导出水射流对刀片的换热功率表达式和刀片内温度场表达式。

Major product: the production of I、II type pressure vessel vertical vibration heat interchanger plate exchanger displacement heat exchanger half of displacement heat exchanger sylphon bellows heat exchanger various sectional fast loading floor-type expansion cistern stainless steel holder box water-softening plant DBNL air heater high and low-temperature polyurethane directly buried pipeline and so on.

我公司所生产的产品主要有：I、II类压力容器的生产，立式振荡换热器，板式换热器容积式换热器半容积式换热器，波纹管换热器，各种组合式快装机组落地式膨胀水箱，不锈钢水箱、软水设备、玻璃钢冷却塔空气加热器高、低温聚胺脂直埋保温管等十余种系列供热产品。

But this is impossible, as long as it is engaging in a market economy, there are risks in any operation.

但是，这是不可能的，只要是搞市场经济，是有风险的任何行动。

We're on the same wavelength.

我们是同道中人。