查询词典 atomie heat

Company's products range, including vacuum hot water boiler, steam boilers, hot water boiler, heat pump units, electric boilers, heat-conducting oil boilers, waste incineration furnace, heat pump water heater, etc., and provide a full range of Accessories services.

公司产品齐全，包括真空热水锅炉、蒸汽锅炉、热水锅炉、热泵机组、电锅炉、导热油锅炉、垃圾焚烧炉、热泵热水器等，并提供全方位的配件服务。

The feasibility of proposed GA/SA approach for HENS with multi-stream heat exchangers is demonstrated successfully through varying scale synthesis problems.3 The economical advantage of multi-stream heat exchangers network over traditional two-stream heat exchangers network is illustrated through calculations.

作为工程实例，本文将GA/SA综合多流股换热器网络程序应用于辽阳石化分公司的原油预热换热器网络的改造，所提出的换热网络满足了厂方的改造要求，降低了操作费用，可以带来较高的经济效益。

In heat treatment field, controlling precision and stability of equipments act as a key role to heat treatment quality of products. Because electronic potentiometer and the two-position type controlling style are using widely in our country to control temperature of most box-style furnaces nowadays, which lead to the heat treatment quality can not satisfy the product requirement as desired.

在热处理行业，设备的控制精度和稳定性等对产品的热处理质量起着至关重要的作用，但目前我国大多数箱式炉还使用比较落后的电子电位差计和位式控温方式，其热处理质量远远不能满足产品质量的要求。

Plate-shell heat exchanger is new equipment of combining the advantage of shell and tube heat exchanger and plate heat exchanger.

板壳式换热器是集板式换热器和管壳式换热器优点于一身的新型换热设备。

The comprehensive heat transfer basic trial study about the influence factors, regular pattern and the limit heat transfer capability and effect of augmentation of heat transfer of jet impingement has been completed.

在关于发生在磨削弧区的传热过程的深入的机理研究的基础上，提出了可以通过有效强化弧区换热过程，大幅度开发高效磨削潜力的创新思想，并在此基础上构思设计了采用径向高压水射流冲击强化冷却弧区工件表面的独创方案。

By means of numerical simulation in different heat conduction processes, the steady-state temperature field in upper arm skin tissue, the temperature distribution and the burn depth threshold after 15 s exposure to a heat source at 90℃, the surface temperature rising of skin subjected to a surface-applied constant heat flux, and the steady state temperature elevation distribution under the thermal insulation, are obtained.

通过数值模拟，获得了不同皮肤组织结构模型下上臂皮肤组织内的稳态温度场和90℃高温热源作用15 s后皮肤组织内的温度分布，以及皮肤组织热损伤深度的变化、常热流作用下皮肤组织表面的温升曲线和表面绝热条件下皮肤组织内的稳态温升分布。

An expression of combined heat transfer coefficient was obtained based on the heat transfer analysis of a blast furnace copper stave, and the combined heat transfer coefficients at different gas temperatures were obtained through the thermal test in an experimental furnace.

根据铜冷却壁传热过程分析，得到铜冷却壁热面复合传热系数的计算公式，并在1：1的热态实验炉上进行了热态实验，得到不同炉气温度下相应的热面复合传热系数值。

This paper introduces the selection of the heat relay s type and current its reset mode, points out that connection wire section of rated current of heat relay should be selected according to strict rules it can not take as the protective device of wire short circuit puts forward working environment and temperature of heat relay and matters needing attention of reset after operation.

介绍了热继电器的类型选择、电流的选择、复位形式，指出热继电器的连接导线截面应按规定选择，热继电器不能作为线路的短路保护装置，热继电器的工作环境温度，动作后的复位等注意事项。

With a constant space and different duty ratios, two conditions with high heat transfer performances emerged mainly due to the different degrees of influence of the heat transfer surface area and the rib thickness on the heat exchange performance.

以换热系数进行比较，当占空比为83％左右时，热沉表面温度最低，换热性能最佳；当间距恒定不变而占空比不同时，会出现两个换热性能较好的情况，主要是由于换热表面积和肋片厚度影响换热性能的程度不同。

By setting up the mathematical models of the regulating objects （combusting heat transfer, heat utilization and storage, superheater and main steam pipe line）, by combining heat transfer function of regulating system and by selecting method of setting PID accoding to set attenuation index object, the corrections among PID and pulverized coal＇s caloric values are found. Now the PID can be set according to caloric values of the pulverized coal burned in the unit and the automatic control can be put into operation.

通过建立调节对象四个环节（燃烧传热过程、热量的利用和储存过程、过热器、主蒸汽管道）的数学模型，结合调节系统的传递函数，选用按给定衰减指数设定PID参数的方法，找出PID参数与煤粉热值的关系式，最终达到在机组燃烧不同热值的煤粉时可依据该方法设定不同的PID参数、并都能投自动的目的，从而有利于提高机组的稳定性，并可节约煤粉。

A carrier gas such as nitrogen is directed through line 20 and valve 22 to connect with line 26 and mix with the gas sample.

如氮气之类的载体通过管线20和阀22引入，与管线26相通，与气体样品混合。

But for the most part, knaves and parasites had the command of his fortune

然而支配他的家产的大多是恶棍和寄生虫。