查询词典 atomic diameter

Roundness tolerance of pitch diameter Roundness tolerance for a minimum of 345o circumferential arc of the pitch diameter shall not exceed .002 inch (0.051 mm) total, or one half the pitch diameter tolerance if the pitch diameter tolerance is less than .004 inch (0.102 mm); roundness tolerance of the remaining 15o maximum circumferential arc shall not exceed .004 inch (0.102) total, provided such tolerance does not result in excrescence on the thread flank.

圆度公差沥青直径圆容忍最低限度的345o圆周弧音高直径不得超过0.002英寸（ 0.051毫米）总，或一的一半，足球场直径公差，如果沥青直径公差小于0.004英寸（ 0.102毫米）；圆的耐受性，其余15o最大周弧不得超过0.004英寸（ 0.102 ），共计提供这样的宽容不会导致在excrescence对线程的侧翼。

Results:① The distance between handle of malleus and stapes head was(2.38±0.19)cm(2.00～2.70cm), the point selecting for measuring was outer margin of handle of malleus and stpes head.②The cross section form of one_third of the handle of malleus at the end, was triangle, the anteroposterior diameter of handle of malleus was(0.79±0.12)mm, the exterior and interior diameter was(0.58±0.10)mm at the crook point,the angle of line of manubrium mallei laid(83.24±8.33)°(66～98°)posteroinferior to arch of zygoma.③The long axis of prosthesis formed(27.60±1.75)°(24.6～30.2°)angle with the perpendicular of stapes.④The dependablity between the malleus_stapes distance and transverse diameter of tympanum, the location of umbo in tympanic membrane, the diameter of manubrium mallei, angle of line of manubrium mallei and arch of zygoma were not statistically significant.

结果：①锤_镫距离最短为(2.38±0.19)cm(2.00～2.70cm)，测量点为锤骨柄末端1/3处外缘和镫骨头；②锤骨柄末段1/3横断面形状接近三角形，弯曲处前、后方向直径为(0.79±0.12)mm，内、外方向直径为(0.58±0.10)mm；锤骨柄与颞线的成角为(83.24±8.33)°(66～98°)；③赝复物长轴与镫骨垂直方向成角平均为(27.60±1.75)°(24.6～30.2°)；④锤_镫距离与鼓室横径、鼓脐在鼓膜上的位置、锤骨柄直径、锤骨柄的方位的可能相关因素之间相关性检验无统计学意义。

Independent variables are diameter class, relative diameter, number of stems per hectare, basal area per hectare, quadratic mean diameter, degree of closenessand sum of squared diameter of larger trees than th...

自变量有径阶、相对直径、每公顷株数、每公顷断面积、平方平均直径、郁闭度和大于所估径阶的林木直径平方和。

The average number of anterior lymph nodes was 3.83±1.79. Their blood supply originated from the branches of lateral thoracic artery, whose mean diameter and length were 1.04±0.42 and 29.5±12.25 respectively.(3) The average number of posterior lymph node was 2.38±0.97. Their blood supply originated from the lymph node branch of subscapular artery, whose length and mean diameter were respectively 18.78±8.67 and 0.78±0.32.(4) The average number of central lymph nodes was 4.05±1.95. Their blood supply originated from axillary artery whose mean diameter was less than 1mm.(5) The average number of apical lymph nodes was 2.82±1.96. Their blood supply originated from the branches of thoracoacromial artery whose mean diameter was 0.79±0.29mm and length was 10.60±4.13mm.

结果 外侧群淋巴结数量为(3.16±1.72)个，血供属多源性且不恒定；前群淋巴结数量为(3.83±1.79)个，营养血管主要为胸外侧动脉的分支，其外径(1.04±0.42)mm，干长(29.5±12.25)mm；后群淋巴结数量为(2.38±0.97)个，血管来源于肩胛下动脉的淋巴结支，其外径为(0.78±0.32)mm，干长(18.78±8.67)mm；中央群淋巴结数量为(4.05±1.95)个，血管来源于腋动脉的分支，其外径均在1mm以下，干长20mm以上；尖群淋巴结数量为(2.82±1.96)个，营养血管为胸肩峰动脉的分支，外径为(0.79±0.29)mm，干长(10.60±4.13)mm。

Methods:Three-dimensional(3D) CT imaging reconstruction was performed in 200case of cervical spine without radicular symptom and injury.C_3-C_7 vertebral body horizontal diameter, sagittal diameter,high.vertebral gap.pedicle vertical diameter and horizontal diameter,coronary high,base long of vertebral uncus,space between vertebral uncus point.highness and width of intervertebral foramenand,transverse foramen,The CT data was transferred to a computer workstation,grouping with age and sex,statistical analysis.

材料与方法：选取200名不同年龄段无外伤、无神经症状和体征的受检者，进行多排螺旋CT薄层扫描，在计算机工作站上对获得图像进行多平面重建，获得相应截面图后，测量各相关指标，包括第3至第7颈椎(C_3-C_7)椎体横径、矢状径及高，椎体间隙，椎弓根的高与宽，冠状位钩突高度、钩突基底宽度、基底长、两侧钩突尖间距及基底长径角度，椎间孔高和宽，横突孔长和宽。按性别、年龄分组进行统计学分析。

Studied the solid particles cyclone separation under structural parameters and operating parameters of different hydrocyclone, the results showed that major factor influence split ratio is in the ratio of entrance to exit pressure of hydrocyclone. Exit pressure has a certain influence on the split ratio, the various of the diameter and cone angle of hydrocyclone (in the ratio of entrance to exit pressure is constant) have no influence on split ratio; With diameter and cone angle increase, the separation granularity gradually increasing and recovery ratio decreasing; With entrance pressure increase, the separation granularity of hydrocyclone decrease, the split ratio of underset will increase slowly; With the diameter of overflow pipe increase, the separation granularity of hydrocyclone increasing and recovery ratio decreasing; With the diameter of underset pipe increasing, the separation granularity of hydrocyclone decreasing and recovery ratio increasing.

在不同的水力旋流器结构参数和操作参数下，对固体颗粒的旋流分离进行了分析研究，结果表明：旋流器的排出口比是影响分流比的主要因素，进口压力对分流比有一定影响，水力旋流器的直径变化和锥段角度变化对分流比基本上没有影响；随着直径、锥段角度的增大，分离粒度逐渐增大，回收率降低；随着入口压力增大，水力旋流器的分离粒度变小，底流的分流比会缓慢增加；随着溢流管管径的增加，分离粒度增大，分流比明显减小，回收率降低；随着底流管直径的增加，分离粒度减小，分级效果明显下降，回收率会增加。

All patients underwent echocardiography and conventional 12-lead electrocardiogram examination,Parasternal short axis at papillary muscle level of left ventricular cross-section,Application of M-mode ultrasonography were measured end-diastolic ventricular septal diameter,End-diastolic left ventricular posterior wall diameter,The largest left ventricular end diastolic diameter and left ventricular end systolic diameter.

所有患者均行超声心动图和常规12导联心电图检查，在胸骨旁左室短轴乳头肌水平切面，应用M型超声分别测量室间隔舒张末期厚度、左室后壁舒张末期厚度、左室最大舒张末期内径和左室收缩末期内径。

There was a significant inverse correlation between sarcomere length and A/I (r=-0.686, P.05). 4 Relations of the skeletal muscle histological characteristics and meat quality The muscle fibre and the myofibrils diameter were thinner, the muscle fiber density was denser, the sarcomere length was longer and the meat color was redder. The A/I was bigger, the meat color was whiter, contrarily was redder. The right amount of fat content may improve the meat brightness. The muscle fiber diameter and the myofibrils diameter were the biggest factors to influence the skeletal muscle shearing force, their assumed the obvious linear correlation. The muscle fiber density influence on the shearing force was only inferior to the muscle fiber and myofibrils diameter. Mensurate the IFA from tectology angle may reflect in intramuscular fat content. However intramuscular fat was not enough to carry weight on the shearing force, it may mostly affected on the smack, but not the tenderness expression.

猪骨骼肌组织学特性与肉质性状的关系肌纤维和肌原纤维直径越小、肌纤维密度越大、肌节长度越长，肉色鲜红；肌节中暗带比例越大，肉色偏白，而明带比例大，肉色偏红；适量的脂肪含量可以改善肉的亮度；肌纤维直径和肌原纤维直径对骨骼肌剪切力的贡献率最大，呈明显的线性相关，肌纤维密度对剪切力的贡献率仅次与肌纤维和肌原纤维直径；从组织形态学角度测定肌内脂肪面积比一定程度上可以反映肌肉内的脂肪含量，而肌内脂肪对肌肉剪切力的贡献率比较微弱，对肉食用品质的影响可能更多表现在改善肉的风味，而不是嫩度的表达。

The experiment can be optimized by these results: the pellets with great density or with big diameter have the same influence tendency.When the material density is great,the pellet diameter should be taken short relatively,when the material density is small,the pellet diameter should be taken long relatively,the modification effect is best.If spray gas is air,the best pellet diameter should be taken between 1 μm and 10 μm.

结果表明：大密度颗粒与大直径颗粒受流场影响趋势相同；材料密度较大时，颗粒直径应相对取小，材料密度较小时，颗粒直径应相对取大些，喷涂效果最佳；若喷涂气体为空气时，最佳颗粒直径应在1～10 μm。

Hickeys greater than 0.050 inch in diameter are not acceptable. Seven (7) hickeys less than 0.05 inch in diameter, but greater than 0.02 inch in diameter are acceptable per surface. Hickeys less than 0.02 inch in diameter are not to be considered visible.

11.3.2 漏漆：Hickeys 直径大于0.050英寸之漏漆不接受每一版面容许直径小于0.02英寸，而大于0.05英寸之漏漆七处，小于0.02英寸之漏漆视为看不见。

Some of them were ligated to the plasmid vector pCR 2.1 andsequenced,respectively.

将所获DNA片段克隆到pCR2.1载体进行测序，并与基因组数据库进行同源性比较。

Thinking since Google owns Blogger, I would be able to escalate this issue to the support team.

自谷歌的思考拥有Blogger的，我将能够缓解这一问题的支持团队。