查询词典 at the maximum

In order to achieve a high concentration and high productivity of exopolysaccharide from Auricularia auricula, the effect of pH on the performance of EPS production in submerged fermentation was investigated. It was showed that the maximum yield of EPS （7.54 g/L） was obtained at pH 5.5, but the mycelial growth rate was enhanced at pH 5.0 and the maximum dry cell weight was

为了实现黑木耳深层发酵生产胞外多糖的高产量和高生产强度的统一，在7L发酵罐中研究不同pH对A.auricula分批发酵生产黑木耳多糖的影响。A.auricula细胞生长的最适pH为5.0，而黑木耳胞外多糖合成的最适pH为5.5。

Studies have suggested: Of every joint curve, the pace of hip joint is smaller and not changing much; The paces of knee joint , ankle joint and tiptoe are obvious in curvilinear motion; Knee joint up to the peak value of pace early , then moderate , ankle and tiptoe nearly reach the pace maximum at the same time during the course of proposing the knee, later dropped rapidly, the tiptoe pace increased but not reached the maximum again at the time of hitting the target.

研究表明：各关节曲线中，髋关节速度较小且变化不大；膝关节、踝关节和脚尖的速度曲线变化明显；膝关节较早达到速度峰值，然后减速，在提膝阶段踝和脚尖几乎同时达到速度最大值，之后迅速下降，在击靶瞬间脚尖速度又增大但没达到最大值。

Concretely, firstly with Timoshenko beams, the fundamental formulae of solutions of dynamical equations, boundary conditions and initial conditions have been transformed by Laplace transformation. Secondly, in the Laplace regions , we gain the analytical solutions of impact forces at the impact contact points, shear and maximum inverse stress of beams. Then, by using Durbin numerical inverse method, we gain the numerical solutions of Timoshenko beams under various restriction conditions. Moreover, the graphs about impact forces at the impact contact points, shear and maximum inverse stress of beams can be obtained too.

把Timoshenko梁力学模型动力学方程的基本解形式、边界条件以及初始条件进行Laplace变换，在Laplace区域得到了冲击接触处的冲击力、整个梁的最大弯曲应力和剪力的解析解，然后利用Durbin数值反演的方法得到了各种约束条件下的Timoshenko梁模型时间-空间的数值解，得到了冲击接触处的冲击力、梁各处的最大弯曲应力和剪力的曲线图。

At the same time, the MEMS geophone can be used to monitor the microseismic event of coal mining, water reservoir and hydraulic fracturing through the research of failure location and the ratio of rock fracture can be predicted by counting numbers of acoustic emission.After spent six months to monitor injecting microseism in Ying 11 block of DongXin field using this system and collect abundant microseismic wave files. The result showed that the orientation of injecting fracture was mainly NE90°to NE125°. The maximum horizontal principal stress directions were mainly distributed in NE90°-NE130°range. Analysis of numerical simulation result of reservoir stress in Ying 11 block showed that the maximum horizontal principal stress directions are approximate east-west in central and western region and approximate NE130°at eastern border.

利用该系统对东辛油田营11进行了六个月现场注水微震监测，对监测数据的处理表明营11注水区域裂缝发育方向基本上为NE90°-NE125°；同时营11地区油藏地应力数值模拟结果分析表明其水平最大主应力的方向主要分布在NE90°-NE130°的范围内，研究范围中西北区块的水平最大主应力方向近似为东西向，研究区块的东部边界的水平最大主应力方向近似为NE130°左右，模拟结果与裂缝监测方位相符较好，两者结合给出了这个地区合理开发部署建议。

Materials and Methods:141cases of senile cervical spondylosis were measured at vertebral artery with 5.0-7.5 MHz probe of Ultrasonic Doppler,to find morphological changes and Maximum,Minium,Time Average Maximum,Diameter At the same time,the controlled analysis were performed on 200 cases of the healthy aged.

材料和方法：应用超声多普勒诊断仪，探头5.0～7.5MHz，检测141例老年颈椎病患者的椎动脉，观察形态与结构变化，获取收缩期峰值流速、舒张末期流速、时间平均流速、内径，并与200例健康老人进行对照分析。

As the same section is concerned, near the bottom the maximum value of frequency appear within 1mm of bubble size, towards the water face this value tend to decrease, yet the corresponding size turns to increase; in the same time, the frequency is concentrated near the bottom and deconcentrated near the water face; under the experiment condition, the maximum frequency of the total section approximately appear at 0.5mm size; mean bubble size access 0 at bottom and increase acceleratively towards water face where tend to be infinite; total number increase during developing of aeration, and become steady when reach wholly developed area; on the same section, the total number in unit time tend to increase at first and decrease then, along the water depth.

对于同一断面，靠近槽底的测点气泡个数分布最大值出现在气泡尺寸小于1mm的范围内，朝水面方向各测点气泡个数分布最大值呈减小趋势，而其对应尺寸则呈现变大趋势；在靠近槽底，个数分布表现得比较集中，而在水面附近气泡个数分布曲线表现得低而平缓；实验条件下，整个断面上的气泡个数分布的最大值大体上出现在尺寸为0.5mm的地方；气泡平均尺寸在槽底处接近于0而朝水面方向迅速增大，且越接近掺气水流的水面，增加速度越快，最终趋于无穷大；气泡总数在掺气发展区内是沿程增加的，当掺气水流发展到一定程度后气泡总数就基本保持不变了；在同一断面上，各测点单位时间内的气泡总数随高度呈现出先增加后减小的趋势。

A subsidy of 1000 RMB per square meter at its maximum will be granted to the qualified enterprises and organizations toward their purchasing houses and a subsidy of 20 RMB per square meter per month at its maximum will be granted toward the enterprises and organizations for tenting office spaces.

符合条件的企业和机构，购置自用办公用房的，予以最高1000元/平方米的资助；租赁办公用房的，给予最高20元/平方米/月的资助。

The measurement results show that the general characteristics of the present crustal stress field of the project area are as follows: the horizontal principal stress is the maximum principal stress, and the preferred orientation of the maximum horizontal principal stress is NW-WNW, the maximum principal stress of surrounding rocks of the plant buildings and high-pressure branch tunnel area is generally 14.5±0.5 MPa and the minimum principal stress is 9±0.5 MPa; the dead oad-bearing capacity of surrounding rocks is 10—14 MPa; and the surrounding rocks are essentially impermeable at high pressures of 8—10 MPa.

测量结果表明，工程区现今地壳应力场的总体特征为：水平主应力为最大主应力，最大水平主应力的优势方向为NW-NWW向；厂房和高压岔管区围岩的最大主应力值一般为14.5±0.5MPa，最小主应力值一般为9±0.5MPa；围岩自身的抗载强度一般为10～14MPa；在8～10MPa高压力作用下围岩基本不透水。

Using harmonic analysis of the calculated tidal level and current, the distributions of co-tidal lines for K1, O1, M2 and S2 are obtained, whose maximum amplitudes can reach 112 cm, 96 cm, 50 cm and 15 cm, respectively. The distribution of the maximum probable current velocities in Qinzhou Bay is basically the same as that of isobaths, and the maximum probable current velocity can reach 200cms^(-1) nearby the Longmen Harbor. It is concluded by the analysis of K1 and M2 tidal current ellipses that the flow is rotating at the mouth of the bay, while its retilinear flow is in the nearshore area, estuaries and channels. The distributions of the major axes are closely related to the topography, and the rotation directions of both constituents are clockwise.

根据模拟结果计算得到了较以往更为精细的钦州湾K1、O1、M2、S2分潮的同潮图，潮汐最大振幅分别为112、96、50和15cm；最大可能流速的分布基本与等深线一致，龙门港附近最大可能潮流流速可达200cms^(-1)；钦州湾的外湾口海域开阔，一般为旋转流，近岸海区及水道、河口等多为往复流，K1和M2分潮流椭圆长轴的分布与地形密切相关，旋转方向均为顺时针，流速极值出现在龙门港区。

The objectives are the subsonic and supersonic zero-lift drag coefficients, the maximum lift-drag ratio, the maximum lift coefficient at low speed, the average and maximum value of forward and sideway RCS.

目标函数取为亚音速及超音速时的零升阻力系数、最大升阻比，低速时的最大升力系数，以及飞机前向、侧向的RCS平均值、最大值。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。