查询词典 at the distance

One parsec is defined as the distance at which a star would show a parallax displacement of 1 second of arc, a distance which proves to be approximately 3.258 light years.

一秒差距被定义为一颗恒星位移一度的距离，此距离经证实大约为3.258光年。

The distance between settled releaser and inlet of raw water is 180 cm, and the range of distance between pensile releaser and inlet of raw water is 60-90 cm. The flow of pensile releaser is 2-3 times as much as settled releaser.

较为合理的布置为：固定式释放器S与原水进水口距离为180 cm，悬挂式释放器P与原水进水口的距离在60～90 cm之间。P与S的流量比控制在2～3之间。

Euclidean distance and Hamming distance are used in verification. With full searching, experimental results show a 1 percent rate of error.

利用Euclidean distance、Hamming distance等方式来进行比对，对抽取的特徵full search的结果辨识错误率可达1 %。

The central studied content is: the studying for the C and R in the distance measurement, the study for standard deviation of distance measurement of the total station instrument, the study and calculation of illustration for the formula of periodic error of the total station instrument, the checking of horizontal angle.

主要的研究内容有：全站仪测距加乘常数的分析，全站仪测距标准偏差的研究，全站仪周期误差公式的分析及其实例计算，全站仪水平角的检定(多齿分度台法和多目标平行光管法)，一测回水平方向标准偏差计算公式的分析，一测回竖直角标准偏差的合理性分析及其实例计算。

A new way of distance measurement is introduced in this paper, it is similar to traditional measurement way, and has its origination. In the new measurement way, the rough measurement of the distance is realized by countering high frequency pulses filled in discriminable phase pulses. Discriminable phase pulses go through integral circuits, and then are sampled by Analogue Digital Converter, so the accurate measurement of the system is obtained by the sampling value.

本文提出了一种新的测距方法，该方法与常规相位测距仪比较，既有相似之处也有其创新之处，常规相位测距仪一般使用多波长测尺频率组合、差频数字测相的方法，本系统虽然也采用多波长测尺频率组合，但并不采用差频数字测相，该方法摒弃了传统的内外光路的切换方式及电路的混频，粗测采用对鉴相脉冲填充高频脉冲的办法实现，精测则利用鉴相脉冲对积分电路进行积分，然后由ADC 对积分电平进行转换，通过对ADC 的输出值的计算处理实现精测。

When described as a distance of an arc on the engagement pitch circle, it is called "Circumference Direction Backlash", when described as the shortest distance between two opposing tooth surfaces is called "Normal Line Backlash".

当描述为齿间弧度距离时，也叫做"圆周向回程间隙"。当描述为两啮合面的最短距离时，也称作"常规线性回程间隙"。

By Visual Basic 6.0 program, taken the distance between hole 200mm and buried depth 120～150mm as the optimization goal, the most optimum parameters range of the mechanism was obtained as follows: the initial angle between planet frame and the line formed from spraying-fertilizer needle-tip and planet wheel axle was -45°～-40°, the initial angular displacement of planet frame was 40°～50°, the distance between spraying-fertilizer needle-tip and the planetary gear axle center was 280～300mm, simultaneously, the semi-major axis of elliptic gear was 29.364mm, the teeth quantity was 23, the ratio of semi-minor axes and semi-major axis was 0.958, the radius of circular gear was 25mm.

对该机构进行运动学分析，建立了数学模型，以穴距200mm和入土深度120～150mm为寻优目标，应用Visual Basic 6.0软件编程得出满足机构运动要求的最优参数范围为：喷肥针尖和行星轮轴连线与行星架的初始夹角-45°～-40°、行星架初始角位移40°～50°、喷肥针尖与行星轮轴心距离280～300mm，此时椭圆齿轮长半轴29.364mm、齿数23、短半轴与长半轴比0.958，正圆齿轮半径25mm。

Firstly, the soil samples are gathered from the same section such as surface layer soil samples gathered from 0cm to 15cm depth and representation on studied object. Secondly, the precondition of tested samples must be the same. This study indicates that the tested samples must be 1mm diameter, over-dried at 40℃ for 24h and airtight cooling for 24h before measured for air-dry samples, and softly planish the surface at measuring. Lastly, the illuminating condition of light must be the same. This study indicates that the testing geometric condition are light source angle 15°, light source distance 30cm and sensor distance 15cm for soil hyperspectra indoor. The surface of white reference must be the same plane of that of sample.

第一个环节的"相同"是指田间土壤样品采集时的剖面位置一致，如表层土都采集0～15cm深度范围内的土壤，且所采集的样品应能尽量具备研究对象的代表性；第二个环节的"相同"是指土壤制备过程中的一些前处理条件应一致，建议土壤光谱测试样品的粒径1mm，风干土壤样品测试前在40℃恒温条件下烘24小时，然后密闭冷却24小时，测试时土壤表面进行稍稍压平处理；第三个环节的"相同"是保证测试光照条件的一致性，建议在50W卤素灯、8°探头角条件下，采用15°的光源照角度、30cm的光源距离和15cm作为室内士壤高光谱测试几何条件，测试时除遵循光谱测试指南的要求外，还须保证参考板表面与测试土壤样品的表面在同一平面上。

By taking the noise of an infrared focal plane detector as the main factor, an operating distance estimation equation for point targets is derived. A calculation example of the operating distance of a typical infrared detection system is given.

本文推导了以红外焦平面探测器噪声为主要因素的点目标红外探测系统的作用距离估算方程，结合实例求解了典型红外探测系统的探测系统的作用距离。

The results show, when polar distance is bigger than the size of cross section of tunnel, the difference of anomalous feature between the corner-sections and wall-sections in tunnel is very small. The apparent resistivity is only related to the distance between section and bodies. The shielding effect of the tunnel is not so evident that the character and value of anomalous are similar with those in full space.

计算结果表明，当坑道内偶极测深的极距大于坑道截面尺寸时，坑道角与坑道面断面异常形态差异不大；视电阻率值只与断面和地质体间的距离有关；坑道空腔的屏蔽效应并不明显，坑道内各个测深断面的异常幅值和形态与全空间中观测结果非常相似。

Listen,point and check your answers.

听，指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例，经过临床的诊断后，其中施以温针治疗的48例，疗效显著，报道如下。1临床资料本组病例48