查询词典 at length

Heart malformation, such as PTA, DORV, VSD and aortic arch malformation, were detected when neural crest were taken out before they migrated into 3, 4, 6 pharyngeal gland. Interestingly, the types of malformation were related with the length of neural crest destroyed; PTA was detected if the length exceeds two somites, while DORV would be detected if the length less than two somites. These results indicate that CNCCs are very important to the conotruncal development.

研究发现，如果在迁移之前切除散发到第3、4、6咽弓的神经嵴细胞，就会出现永存动脉干、主动脉骑跨、右室双出口、主动脉弓畸型和室间隔缺损等心血管畸形，且切除的长度与畸形的种类相关，如切除长度大于两个体节可产生永存动脉干，切除长度小于两个体节则产生右室双流出道，由此可见，心脏神经嵴细胞对于心脏圆锥部的发育意义重大。

Growth of cultured winged pearl oyster, Pteria penguin was studied in 20 months in Li'an Lagoon, Hainan, south China. The growth parameters of maximum diagonal length, shell length, hinge length and total weight were measured monthly and described using y=y(subscript ∞)/superscript (1+e-k+d sin (2п/365.25).

对海南黎安港的企鹅珍珠贝养殖群体的生长进行了20个月的观察，每月测量其壳高、最大对角线长、绞合线长和总重四个生长指标，并用模型y=y/1+e(上标-k+d sin (2п/365.25)分别拟合这四个指标的生长曲线。

In this article , the application of PLC in straightening and cutting the steel bar with regular length is introduced, measuring the length by high speed counter in PLC, cutting the bar by servo working-bench with pneumatic clamp and setting the length and showing quantity of the bar straightened, shutting down without bar or in malfunction.

介绍了PLC在钢筋定长矫直切断中的应用，提出利用PLC的高速计数器进行测长，气动夹具随动剪切，用显示装置完成长度设置、产量设置和产量显示，实现无料与故障自动停

The tree diameter at breast height and crown length can be used to predict the size and location of mean knot diameter in a whorl.A linear mixed model expressed as function of tree and knot variables such as HK、RKD、KD and DBH was used to predict sound knot length,and a log-linear mixed model using RKD and DBH as variables was used to describe loose knot length.4.A knot has four development phases:from the birth of a branch to its growth cessation,from growth cessation to death,form death to occlusion and form birth to occlusion.The numbers of annual rings in four periods,as well as the stem width of respective zones were used as dependent variables predicted by models expressed as function of tree variables and knot attributes.5.Using the data of diameter out side bark of 15 relative heights along the step,the best taper equation for Larix olgensis was established.

节子平均直径可以用以胸径，冠幅和节子高度为参数的舒马克生长方程来预测，用树木胸径和冠长可对每轮节子平均直径的最大值及位置进行预测；健全节长度可用以节子着生高度、相对直径、节子直径以及树木胸径为参数的线性混合模型来预测，疏松节长度采用节子相对直径和胸径为自变量的可转化为线性模型的自然对数模型来预测；4、节子有四个生长发育时期：从枝条形成到生长停止BC从生长停止到死亡(CD从死亡到包藏DO从形成到包藏

With analysing the the fatigue mechanism, the general mode of interply fatigue damage propagation is denoted by delamination length and crack density. Based on the power-law, the relationship between number of cycles and delamination length and crack density are established. The specimen is modeled as an equivalent six-ply material system. Starting with the analysis of interply stress, the interply shear stress under cyclic loading is calculated by using nonlinear three-demension FEA. According to the stage regularity of fatigue damage propagation, such models as average strain, effective modulus, ratio of delamination length and crack density, experimental relationship between crack density and effective modulus, are proposed by introducing subsection coefficient.

通过对疲劳机理的分析，确定了以脱层长度和裂纹密度表示的层间疲劳损伤演化的一般模式，利用指数法则建立了脱层长度和裂纹密度随疲劳循环周次变化的关系；从层间应力分析入手，以等效六层的材料模型对循环载荷下的层间剪切应力进行了三维非线性有限元分析；根据疲劳损伤扩展的阶段性，引入分段系数，分别建立了平均应变与载荷循环周次的分段线性模拟模型、有效刚度随载荷循环周次的变化关系模型、裂纹密度变化和脱层长度变化关系随载荷循环周次变化的分段线性模型以及疲劳裂纹密度和有效刚度关系的经验模型。

Results The length between posterior superior iliac spine and greater trochanter of femur was (15.2±1.35) cm for man and (11.5±0.72) cm for woman; the length between posterior superior iliac spine and ischial tuberosity was (13.3±0.87) cm in man and (10.3±0.49) cm in woman; the length between greater trochanter of femur and ischial tuberosity was (8.3±0.83) cm in man and (5.5±0.61) cm in woman; the surface projection where the superior gluteal artery, superior gluteal veins and superior gluteal nerve permeate the suprapitiform foramen was below the point 0～6.8 mm between 2/5 superior and middle trunk from posterior superior iliac spine to greater trochanter of femur; the surface projection where the inferior gluteal artery, inferior gluteal veins and inferior gluteal nerve permeate the infrapiriform foramen was at the point between 2/5 inferior and middle trunk from posterior superior iliac spine to ischial tuberosity; the surface projection where sciatic nerve permeate the infrapiriform foramen was at the point between 3/5 lateral and middle trunk from ischial tuberosity to greater trochanter of femur.

结果臀三角各边的长度分别为：髂后上棘转子间距，男(15.2±1.35) cm，女(11.5±0.72) cm；髂后上棘结节间距，男(13.3±0.87) cm，女(10.3±0.49) cm；转子结节间距，男(8.3±0.83) cm，女(5.5±0.61) cm。臀上动脉、静脉、神经出入梨状肌上孔的体表投影在髂后上棘与大转子连线中、上2/5交界处向下0～6.8 mm内；臀下动脉、静脉、神经出入梨状肌下孔处的体表投影在髂后上棘与坐骨结节连线中、下2/5处；坐骨神经出梨状肌下孔处的体表投影在坐骨结节与大转子连线中外3/5处。

Winter wheat varieties were used as materials, their coleoptile length, seedling length and main radicle length of wheat seedlings were investigated under different concentrations of PEG-6000 osmotic solution simulated drought stress, and their relations with the yield components and drought tolerance under rainfed and rainout shelters were further analyzed.

以6个抗旱性不同的冬小麦品种为材料，通过不同浓度的PEC-6000渗透溶液模拟干旱胁迫处理，研究了小麦苗期的胚芽鞘长度、苗高、主胚根长等性状，并与其在大田及防雨棚控水条件下的产量构成和抗旱性的关系进行分析。

The camera length of electron diffraction in transmisson electron microscopy is one of the main technical parameters in designing electron microscope and the electron diffraction analysis to microcrystal sample. According to Bragg law, the formula of calculating TEM electron diffraction camera length is derived from the research on the ray path of electron diffraction images in TEM and the comparison on electron diffraction with ordinary electronic diffractometer. The difference of physical significance of electron diffraction camera length between TEM and ordinary electronic diffractometer is discussed.

透射式电子显微镜(Transmisson Electron Microcopy， TEM)中的电子衍射相机长度，是电子显微镜设计和对微晶体样品进行电子衍射分析的主要技术参数之一依据布拉格定律，经对TEM中电子衍射成像光路的探讨与研究，并通过TEM与普通电子衍射仪的电子衍射的对比分析，导出了TEM电子衍射相机长度的精确计算公式，阐述了TEM和普通电子衍射仪的电子衍射相机长度所表征的物理意义的区别。

Aqueous extract of cotton has allelopathic effect on Raphanus sativus, Brassica campestris, Lactuca indica, Brassica campestris, Echinochloa crusgall, Setaria viridis and Abutilon theophrasti and its inhibition effect gradually strengthens with increasing concentration. Aqueous extracts from stems, leaves and roots of cotton inhibit or accelerate seed germination and seedling growth, and activity of enzyme of seedling root of cotton. While aqueous extracts from stems and leaves of cotton are 0.02 gmL^(-1), root length, shoot length, lateral root number and dry weight of cotton respectively increase by 10.3%, 3.1%, 22.9% and 2.4% over the control. The above mentioned indexes are lower than the control by 34.4%, 39.2%, 40.6% and 19.0% respectively as the aqueous extracts are 0.1 gmL^(-1). At the same time, root activity and SOD activity decrease by 38.2% and 36.7%, while POD activity and MDA content increase by 52.3% and 36.5%. Growth indexes of plant receptors increase at low concentrations but decrease at high concentrations of aqueous extracts. The allelopathic effect of aqueous extract of stems and leaves is stronger than that of root.

结果表明：棉花植株水浸提液对萝卜、白菜、莴苣、油菜、稗草、狗尾草、苘麻均具有化感效应，随着作用浓度增加，抑制效应逐渐加强；棉花茎叶和根系水浸提液对棉花种子萌发、幼苗生长、幼苗根系活力、根系酶活性有抑制或促进作用，当茎叶浸提液浓度为0.02 gmL^(-1)时，棉花根长、苗高、侧根数、干重分别比对照增加10.3%、3.1%、22.9%和2.4%，当浓度为0.1 gmL^(-1)时，上述指标与对照相比分别降低34.4%、39.2%、40.6%和19.0%，而根系活力、SOD活性比对照降低38.2%、36.7%，POD活性、MDA含量较对照增加52.3%和36.5%，不同浓度棉花植株水浸提液对棉花生长呈现"低促高抑"的规律，且茎叶浸提液作用效应大于根系浸提液。

Then, two primers were designed from it, the full length cDNA of malate dehydrogenase gene in Chinese cabbage was gained through RT-PCR amplifying and sequencing and entered GenBank as accession number FJ208590, which is 1 209 bp length and coded 403 amino acids.

然后设计引物，经RT-PCR扩增、测序，获得了大白菜苹果酸脱氢酶基因的cDNA全长序列，并已将其登录到GenBank，登录号为：FJ208590，该cDNA全长1 209 bp，编码403个氨基酸。

The shaping method of noncircular part and the tool holder's radial motion characters in noncircular turning process are discussed in detail in the thesis.

论文详细研究了非圆零件的成型方法和加工过程中刀架的径向运动规律。

I have not really liked him,I do not like his this kind of disposition.

我没有真的喜欢他，我不喜欢他的这种性格。