查询词典 at every pore

The research of reservoir characteristics indicate that the T_1j~2_2 reservoir's pore spaces were dominated by intercrystalline pores and corrosion pores, there have 1 ~2 high porosity section by corrasion in Mainan structure, the porosity is 6~16%,and in this area reservoirs mainly belong to type Ⅱ and typeⅢ, the reservoir type was defined as fracture-pore type. and the reservoir physical property were primarily dominated by sedimentary fades、 corrosion and dolomization.

储层特征研究表明，嘉二~2储层以白云岩的晶间孔、溶孔为主，麦南构造存在1～2个溶孔发育的高孔段，孔隙度约为6～16%，储层主要为Ⅱ、Ⅲ类，储集类型属裂缝—孔隙型，储层物性主要受沉积微相、溶蚀作用及白云岩化作用的控制。

The specific surface area and pore structure of mortar with cracks after electrodeposition were examined by COULTER SA3100 Surface Area and Pore Size Analyzer.

采用COULTER SA3100比表面积和孔径分析仪研究了电沉积处理后带裂缝的砂浆比表面积和孔结构的变化。

For finding a suitable sorbent for a-methylstyrene in the process of producing phenol from cymene, the pore structure and pore size distribution of four coconut-shell activated carbon were analyzed and characterized by different methods (BET, t-plot and BJH) according to their nitrogen adsorption isotherms.

为了筛选在异丙苯法生产苯酚工艺中吸附分离α-甲基苯乙烯的吸附剂，测定了4种椰壳活性炭材料的氮吸附等温线，并用BET模型、t图法、BJH理论等方法对孔结构进行分析与表征。

Based on definitions of stress and strain, and the D'Alembert's principle, stress and strain of soils at various depths were derived from the data of acceleration, displacement, as well as excess pore pressure measured in the test. The stress paths and stress-strain relationships of saturated sand during the shaking event, and their connection with development of excess pore pressure were revealed.

根据应力和应变的定义以及达朗贝尔原理，由试验观测的土体加速度、位移和孔隙水压力数据直接推导得到不同深度处砂土的应力和应变，揭示了振动过程中饱和砂土的应力路径和应力-应变关系演化过程，以及与超静孔隙水压力发展的联系。

Emphasis has been put on changes of structure properties such as crystallization, crystal cell parameter, BET surface area, average pore diameter and pore volume with addition amount of FCC decant oil under conditions that the ratios of toluene to FCC decant oil are 1∶1 and 2∶1 respectively.

结果表明，当剂油比为1∶1时，分子筛的结晶度和晶胞参数随催化油浆添加量的变化呈现先增加后减小趋势，当noil/nCTMAB=0.34时，其晶胞参数最大可以达到5.95 nm；当剂油比为2∶1时，随添加剂量的增加，分子筛结晶度降低，BET表面积成先增大后减小，而孔容和平均孔径呈逐渐增加趋势。

Steam can make facial skin pore outspread, remove deposit the bilge within pore, in the meantime, the water that compensatory cell metabolism needs is divided, desiccate dry, coarse skin becomes delicate.

蒸气可使面部皮肤毛孔扩张，排除淤积于毛孔内的污垢，同时，补充细胞新陈代谢所需要的水分，使干燥、粗糙的皮肤变得细嫩。

In the test, after anisotropic consolidation, keeping the deviator stress, pore water is injected using pore water control apparatus under a constant volumetric strain controlled condition.

该实验是在各项异性的固结作用后保持差应力，使用孔隙水控制装置在体积不变的应变控制条件下将孔隙水注入。

The results show that, consolidated deviator stress ratio has the most significant effect on normalized pore water pressure developed with number of cycles. And the normalized pore water pressure developed with generalized shear strain is independent of various initial stress condition.

研究表明：非均等固结条件下，固结偏应力比对归一化后的孔隙水压力随振次增长模式影响最为显著；不同固结条件下的归一化孔隙水压力随应变增长模式却基本相同。

Based on statistical results and the volcanic lithology and facies map, high cracks surface pore concentrates at diatreme subfacies and cryptoexploisve sub-facies of volcanic conduit facies, inner subfacies of extrusive facies, pyroclastic flow subfacies and base surge subfacies of explosive facies, lower subfacies of effusive facies which are close to the volcanic edifices center. Holes surface pore focus on upper and middle subfacies of effusive facies which locates in the edifice slope.

将物性结果结合平面岩性岩相图，确定出裂缝面孔率高的区域主要集中在火山机构中心附近的火山通道相火山颈亚相和隐爆角砾岩亚相、侵出相内带亚相、爆发相热碎屑流和热基浪亚相、喷溢相下部亚相；气孔面孔率高的区域集中在距离火山口较近的斜坡处，亚相主要为喷溢相上部、中部亚相。

The result indicates that all the reservoirs have the characteristics that the mineral maturity is low but the structure maturity is high; the porosity types are primal grain porosity and dissolution porosity est., The physical property is middle pore and low permeability , middle pore and very low permeability; Sedimentary environment, petrology composition and radius, composition and amount, and the digenesis are all the factors that influence the reservoirs.

结果表明：延长组储层具有成分成熟度低而结构成熟度高的特点；孔隙类型主要为粒间孔，溶蚀孔，晶间孔和微裂隙等；属于中孔，低渗型和中孔，特低渗型储层。影响储层物性的主要因素是沉积环境和沉积相，碎屑颗粒成分及粒度，填隙物成分及含量，成岩作用等。该研究对制定油田开发方案和提高油气采收率具有重要意义。

Metrorrhagia is also gynaecological problems of common diseases.

崩漏是妇科常见病也是疑难症。

WordFTP gives you the convenience and timesaving you need.

wordftp让您的方便和省时您所需要的。