查询词典 archimedically ordered number field

The use designs the digital cocurrent current supply and the probe head removable intelligence magnetic field measuring instrument to the Helmholtz coil magnetic field key point is the spool thread magnetic field strength survey, drew up the actual field intensity and the theory field intensity graph, has confirmed the magnetic field principle of superposition.

利用所设计出来的数字直流电流源与探头可更换的智能磁场测量仪对亥姆霍兹线圈磁场重点是轴线磁场强度的测量，绘制出了实测场强与理论场强的图表，验证了磁场叠加原理。

Then direct against the concrete conditions of the oil field of Xinjiang, influencing the important factor that the oil gas operated the cost in the oil field of Xinjiang to be analyzed at first, then analyzing in the face of the domestic and international oil field before combining provide the oil field oil gas in Xinjiang and operate concrete method and measure that the cost controls, and combine the change law of petroleum gas cost in the past 10 years of big company of foreign petroleum Oil field Company oil gas cost control what time does it get helpful enlightenment out of about Xinjiang, providing the incentive mechanism of operating the cost of oil gas of oil field company of Xinjiang to design finally.

然后针对新疆油田的具体情况，首先对影响新疆油阳油气操作成本的重要因素进行了分析，然后结合前面对国内外油田的分析给出新疆油田油气操作成本控制的具体方法和措施，并结合国外石油大公司在近十年的石油天然气成本的变化规律对新疆油田公司油气成本控制提出了几点有益的启示，最后给出了新疆油田公司油气操作成本的激励机制设计。

Experiment results indicate that the magnetic fluid flux has a direct relation with the magnetic field under the effect of traveling wave magnetic field. The bigger the magnetic field is, the more the flux is, when the structure of the magnetic fluid travellig pump and the saturation magnetization of magnetic fluid are constant. The volumes of the magnetic fluid from the travelling wave pump increase from 1.9 ml to 3.1 ml, when the magnetic field intensity increases from 25 900 A/m to 40 000 A/m. In addition, the change rate of the magnetic fluid decreases with the increase of the magnetic field due to the effect of magnetic field on magnetic fluid viscosity. The bigger the saturation magnetization of the magnetic fluid is, the more the flux is.

结果表明，行波磁场作用下的磁性流体流量与磁场的强度有直接关系：在磁性流体行波泵结构和磁性流体饱和磁化强度相同的条件下，磁场强度越强，其流量越大；当磁场强度从25900A/m增加到40000A/m时，单位时间内从行波泵内流出的磁性流体的体积由1.9 ml增加到3.1 ml；随着磁场强度的不断增加，磁性流体流量的变化率由于磁场对其粘度的影响而减小；而磁性流体的饱和磁化强度越大，其流量也越大。

The three dimensional flow field in the triple-screw extruder with triangle configuration is the research objects of this task, including velocity field, pressure field and shear rate field etc., simulate the representative flow field in metering section of the triple-screw extruder, consisted of three-thread element with75mm pitch, has been simulated at the screw speed of 60, 120, 180, 240 and 300rpm and the flowing regulations in flow field and especially the role of the unique center zone affecting to the conveying and pressure generating ability have also been analyzed.

本课题以三角形排列的三螺杆挤出机三维流场为研究目标，研究内容包括速度场、压力场、剪切速率场等。模拟分析首先以螺距75mm的三头螺纹元件为代表，计算由其构成的三螺杆挤出机在60、120、180、240及300rpm转速下的流场，分析流动规律，并分析了特有的中心区在输送、建压方面的作用。

The following are main contents studied: A finite element method for Navier-Stokes equation with ALE formulation is considered and by combined with theNewmark method of numerical intergration a pressure correction scheme is obtained for the solution of the FE formulation of N-S equation. Because the incompressibility condition can be satisfied approximately in this scheme, the interpolation functions of elements can be equalorder for the velocity field and pressure field. In the ALE formulation the fluid-solid interaction analysis became a three-field coupling problem of the fluid field, the solid field and the fluid dynamic mesh. The properties and charactiristices of this three-field coupling problem are deeply discussed.

研究的主要内容有：主容器中流体大晃动是一种强非线性问题，文中研究了求解ALE描述的粘性流体N-S方程的有限元方法，以有利于大晃动自由液面的跟踪和流体大晃动中非线性现象的描述；并结合Newmark数值积分法推出了求解ALE型N-S方程的压力修正解法，由于这种解法可以近似满足不可压条件，因此可以采用速度场和压力场等阶插值的有限元离散格式，从而较好地解决了普遍采用的不等阶插值解法中，速度场和压力场数值精度不一致、程序编制不便等的不足。

Trichogramma showed high control efficacy on cotton bollworm eggs after three times of release both in the second and in the third generation bollworm periods. The parasitism on the second and third generation bollworm eggs were 66.0%-70.7% and 76.0%-81.2%, respectively, which were significantly higher than that in the control (second generation: 7.0%-12.3%, third generation: 5.2%-7.4%). And the injury rate of cotton buds and bolls in the second and third generation bollworm were 2.2% and 3.1%, respectively, which were significantly lower than that in the control (second generation:8.5%, third generation: 20.9%). In the second generation bollworm period, number of bollworm eggs or larvae in the Trichogramma released cotton field did not differ to that in the chemically controlled field. But in the third generation, there were significantly less bollworm eggs and larvae in the Trichogramma released cotton field. There were more predators in the Trichogramma released cotton field. These results indicated that cotton boll worm in the transgenic insect-resistant cotton field can he effectively controlled by mass-releasing of T.

结果发现：棉铃虫卵在棉株不同部位的分布差异较大，2代棉铃虫卵主要分布在叶正面、叶背面和茎尖，3代棉铃虫卵主要分布于蕾铃；在放蜂田，赤眼蜂对棉株不同部位棉铃虫卵的寄生率差异较大，2，3代棉铃虫时期对叶正面、叫背面、茎尖、蕾铃的棉铃虫卵寄生率均较高，对叶柄和茎杆处卵的寄生率较低；并以3代棉铃虫时期的寄生率较高；在2，3代棉铃虫时期分别连续释放3次赤眼蜂，对棉铃虫具有很强控制作用，2，3代棉铃虫卵的被寄生率分别为66.0%~70.7%和76.0%~81.2%，均显著高于化防田的自然寄生率（2代：7.0%~12.3%，3代：5.2%~7.4%）；蕾铃被害率分别为2.2%和3.1%，均显著低于化防田（2代：8.5%，3代：20.9%；2代棉铃虫时期，放蜂田和化防田的棉铃虫卵量和幼虫数量差异均不显著，但3代棉铃虫以后，放蜂田棉铃虫卵量和幼虫数量均显著低于化防田，且放蜂田的捕食性天敌数量显著高于化防田。

It is shown that maximum temperature value of the field's will rise while the Mach number increases. After the Mach number exceeds one, a clear bowshock is obtained in the simulation result, and the Mach angle decreases along with the Mach number. Those are consistent with theoretical results. While the Mach number is 3.5, even the radome inside is adiabatic, the maximum temperature is below 1000K. So the CVD diamond thick film radome can meet practical requirement of flight at 3.5 Mach number.

研究发现，随着马赫数的增加，温度场中最大温度值也随之增大；在马赫数大于1时，会产生明显的弓形激波，且激波的锥角随马赫数增加而减小，这与理论结果相一致；当马赫数为3.5时，即使在头罩内壁绝热条件下，温度场中最高温度值也在1000K以下，表明CVD金刚石厚膜可以满足Ma=3.5的实际飞行要求。

Based on electro-characteristic and double electric layers models, directional mechanisms of soy protein molecular are analyzed for the first time on DC heating condition. After the main factors which effect soy protein gels transparency and strength being studied on DC heating condition, the different affects on soy protein gels transparency and strength by DC heating and water bath heating are analyzed and compared, and the transparent mechanisms of soy protein gels are further explored. In addition to temperature action as water bath heating, DC heating is added as electric field directional action. As a results, heating rate is increased. Directional range degrees of soy protein molecules are raised. These advantage the increase of soy protein gels transparency and strength. Microstructures of soy protein gels forming on DC heating condition are observed by SEM and the results showed that ordered structure of transparent soy protein gels on DC heating condition is more ordered than that of transparent soy protein gels on water bath heating condition.

首次从大豆蛋白的电特性和双电层模型上分析了直流电加热条件下，大豆蛋白分子定向的机理；通过对直流电加热条件下影响大豆蛋白凝胶透明性和强度主要因素的研究，分析和比较了直流电加热与水浴加热对大豆蛋白凝胶透明性和凝胶强度的不同影响，又进一步探讨了大豆蛋白凝胶透明的机理；直流电加热除了水浴加热中的温度作用以外，又增加了直流电场的定向作用，提高了加热速率，提高了大豆蛋白分子定向排列的程度，有利于蛋白质凝胶透明性和强度的提高；利用SEM对电场下大豆蛋白凝胶微观结构的观察，进一步证明了直流电加热比水浴加热形成的透明大豆蛋白凝胶微观结构具有更高的有序性。

In this article the generalization of the main theory of non-negative matrices to ordered field further to ordered division ring has been given.

本文的目的是把非负阵矩的主要理论推广到有序域乃至有序除环。

We prepared the ordered porous alumina membrane by a two-step anodization method in oxalic or sulfuric acids, which is a self-ordered hexagonal array of cells with an adjustable pore diameter of 20-150nm and a different pore structures (i.e. Y-branched, dendriform, toothed and torous ones). Furthermore, the template-electrodeposition, vapor-catalytic growth, and controlled chemical etching were developed for well-aligned carbon nanotubes and oxide nanopillars with adjustable diameter, Al2O3-AlN one-dimensional heterojunction, Y-junction and dendriform metal nanowires, as well as Y-junction, and torous carbon nanotubes. The resultant one-dimensional junctions were characterized by XRD, SEM, TEM,HRTEM, and STM, and the field emission of the well-aligned carbon nanotubes and the luminescence of ZnO nanopillar array have also been mearsured.

完善和发展了阳极腐蚀法制备多孔氧化铝膜的方法，制备出了孔径在20-150nm之间可调和具有不同孔结构（如Y形、树枝状、锯齿状）的系列多孔氧化铝模板，在此基础上，利用电化学沉积、气相催化生长和化学控制腐蚀等方法，成功地生长出具有可调直径的碳纳米管和氧化物纳米柱有序阵列、Al2O3-AlN异质结纳米线、Y形和树枝状的金属纳米线以及Y形、藕节形和锯齿形的碳纳米管等多种一维结纳米材料及其阵列体系，探索了基于模板孔壁内沿生长一维结纳米材料的机制，较系统的研究了碳纳米管阵列的场发射性能和氧化锌纳米柱的发光性能，为低维纳米材料器件化提供了实验基础。

You can do some assertiveness training.

你可以进行一些自信训练。

We were well on the path to making a rear-wheel-drive global platform," says Mays."

我们正致力于建立一个后轮驱动的平台，"Mays这样说道。"