查询词典 annular tubes

In different conditions on fluidized state and stability of conical fluidized bed. The conlusions are: the conical angel of the conical fluidized bed is 20°, the fluidized state havesmall difference in conical distributor and distributor plate. The angle of conical bed increase,the fluidized state will have big difference. The angle is 60°and the conical as distributor, themass of fluidized is less, the most of material is the bottom of conical bed. The effect ofdistributor plate is much better than the conical distributor. Sawdust and rice hull can fluidize.The annular gap of conical distributor different, the angle of conical bed is same, the fluidizedquality of 10mm annular gap is better than the other conical distributors. The annular gap ismore wide, the conical bed have more slugging phenomenon and the pressure fluctuate is turnbig.In the experiment the flow of 2％and 4％distributor plates don\'t easy to control, becausethe pressure is very big and the pressure fluctuate of conical bed is too big.

在不同的条件下对锥形床的流化状态和稳定性进行了研究，结果得出：锥形床的锥角为20度时，分布锥和分布板的流化状态相差不明显，随着锥形床锥角的增大，分布锥和分布板的流化现象会出现明显的变化，锥形床锥角越大，分布锥的流化状态变化越明显，流化的的物料越少，大量物料都聚集在锥形床底部，而分布板在加料量少的情况下，能流化起来。10mm、15mm和20mm环隙分布锥在锥形床锥角相同条件下，10mm环隙分布锥的流化质量要好于其它两个分布锥，环隙越大越容易出现腾涌现象的产生，压降波动范围增大。2％、4％和6％开孔率分布板在本实验测定时，2％和4％开孔率分布板的流量不容易调节，同时产生的压降波动范围也很大，比较来说，6％开孔率分布板流化质量好些。

It is worth to be noted that the needed driving current to the MR valve with both annular and radial damping gaps is less than that to the MR valve with annular damping gaps under the cut-off state of the MR valves, which show that the MR valve with both annular and radial damping gaps consumes less energy.

测试结果显示：（1）在相同的工作条件下，同时具有圆环和圆盘阻尼间隙的磁流变阀产生的压降更明显；（2）处于截止状态时，同时具有圆环和圆盘阻尼间隙的磁流变阀的激励电流明显小于具有圆环阻尼间隙的磁流变阀的激励电流，因此采用同时具有圆环和圆盘阻尼间隙的磁流变阀可以节约能量的消耗。

The mechanical property testing shows that the seamless PLLA tubes perform excellent radial strength,which indicates that the mechanical properties of biodegradable stents made of these tubes was supposed to be excellent.PLLA and its composites were first used in preparing seamless tubes as antecedency of laser-cut biodegradable coronary stents in china.Finite element analyses of the biodegradable coronary stent model indicate the explorative design basically meets the requirement of reasonable and applicable stents.There is not such kind of research yet in domestic.Optimum laser-cuttting parameters of CO2 laser was cauculated based on experiential formula,within it,biodegradable coronary stents,especially those with complex structure would be manufacutured from seamless tubes quickly by laser microprocessing with high consistency to the design model.The processing efficiency of the CO2 laser demonstrated in experiential formula by us will play an important guiding role in manufacturing biodegradable stents by laser-processing.Our stents that ascribed to laser-cutted,slotted tube stent are proved to be biodegradable, self-expandable and good biocompatible,basically reach the international level on the aspest of manufacturing procedures and design.

研究结果表明：壳聚糖改性材料综合性能优于纯PLLA，更适合于作为可降解冠脉支架的原材料；自主设计的探索性自膨胀管状闭环型可降解冠脉支架的性能符合冠脉设计要求，设计、验证生物可降解冠脉支架模型的研究在国内还未见报道；制备的改性PLLA无缝管的力学性能优越，可通过激光切割获得冠脉支架，这是国内首次采用聚乳酸材料来制备通过激光加工出可降解冠脉支架的无缝管；二氧化碳激光器加工精度能达到加工要求，加工出来的血管支架名义设计与实测值误差小，实现了冠脉支架、尤其是带有复杂外观设计冠脉支架的快速化、规范化加工，对二氧化碳激光器加工聚乳酸材料的效果研究在国内外属于首创，获得的经验公式对日后的深入研究有重要的指导意义；制备的支架为激光切割管状闭环型冠脉支架，支架外观设计、支架加工手段、支架的性能都基本接近国际水平，支架样品符合设计的理念，可以实现自膨胀功能。

Moreover, since the strain energy of zigzag tubes is larger than that of the armchair tubes with the same semidiameter, the ends of the armchair tubes are easier to be closed than those of the zigzag ones. And the closed structures of the zigzag tubes have a lot of defects, even at 3000 K, there will be few carbon atoms flying away from them.

此外，由于锯齿型碳管应力能比同口径扶手型碳管的应力能大，使得扶手型碳管比锯齿型碳管更容易形成端口封闭的结构，且锯齿型碳管端口的封闭结构出现相对较多的缺陷，甚至在3000K下会有少最碳原子从端口飞离碳管。

The 2, 4 mg tubes and the control tubes were not precipitated except for the 8 mg tube with 10000 r/min configuration. The 3 transparent tubes were desalted with column of Sephadex G-25 Superfine HiTrap respectively. All of the eluents of the 3 tubes were half-diluted consecutively with phosphate buffer saline respectively to change totally into 36 samples of 2 mg group, 4 mg group and control group, with 12 in each group.

取2、4 mg管及未加DNFB的HBIG水溶液对照管，各取半量对半稀释，以HiTrap分子筛柱脱盐， 3个洗脱液再分别作对半系列稀释11次， 3组共组成36个标本。

Water inside vacuum heat- collection tubes; since the hot medium inside vacuum tubes floats up and cold one goes down due to respective specific gravity, hot and cold mediums convections up and down to cause the heat conduction, furthermore transfer the heat to the related working medium in the heat tubes, the working medium sorbs the potential heat and becomes steam to rise up to the condensing section from the tube heat evaporating section; it emits the heat in condensing section to change again into liquid working medium; it flows back to evaporating section under the gravity action, the emitted heat is transferred into the water inside water tank or tube group by means of the heat-conduction through heat tubes condensing section; it makes the cold water in water tank into hot water in the repeated way.

阳光透过全玻璃真空集热管的外玻璃，照射到涂覆在内玻璃管外表面的选择性吸收涂层上，涂层将太阳的辐射能吸收并转化为热能，通过内玻璃管壁导热，传递给真空集热管内其液态传热介质，由于真空集热管内热的介质因比重小而上浮，冷的介质因比重大而下沉，冷热介质上下对流传热和导热，再通过热管的金属壁导热，将热量传递给热管内其相变工质，工质吸收汽化潜热而变成蒸汽，由热管蒸发段上升到冷凝段，在冷凝段放热冷凝，又变成液态工质，在重力作用下流回蒸发段，所放出的热量通过热管冷凝段金属管壁导热，传递给水箱或联集管内的冷水，周而复始，于是便将水箱内的冷水全部加热成热水。

The products have General efficient tubes, three-high tubes, three-cavity tubes and other series, specifications like ф47,ф58,ф70 and so on, and from 1.2m to 2.1m in length about 100 species. Its nnual output can reach 7 million vacuum tubes.

产品有普通高效管、三高管、三腔管等多系列，ф47、ф58、ф70多种规格，长度从1.2米-2.1米近百个品种，年产达700万支真空管。

In view of the consecutive bursting problems of reheater tubes in Xinxiang Thermal Power Plant,the diagnosis tests at cold and hot state of reheater were carried out, thus the causes for reheater bursting were found out, and it was put forward that to employ arc tangent tertiary air to reduce flue gas temperature derivation, to replace part reheater tubes with TP 347 stainless steel tubes with better heat-resisting property etc.

针对新乡火电厂再热器连续爆管问题，进行再热器冷态和热态诊断试验，查明了造成再热器爆管的原因，提出用三次风反切减少烟温偏差，并将部分再热器管子更换为耐热性能更好的 TP347 不锈钢管等技术措施。

Another feature of HEDDTB is that its tubes' buddle is composed of tubes with different diameters, which lead to a smaller fluctuation of heat transfer coefficient in the condition of fluctuating flux than that of the heat exchanger with tubes that has the same diameter in the case of low Reynolds number.

异径管束换热器的换热管束由直径不同的管子组成，这种换热管束在低雷诺数下传热系数随流量的波动相对同径管束而言较小，因此异径管束有一定的抗传热系数波动的性能，这使得换热器在流量波动的工况下工作性能稳定。

Results Among 62 cases, the double J tubes in 58 cases were took out successfully under cistoscope, the double J tubes in 2 cases were dislodged by emiction, and the double J tubes in 2 cases were took out under ureteroscope because of upward displacement.

结果 62例中，58例通过膀胱镜顺利将双J管取出；2例女性患者在排尿时尿出丝线而直接牵出；2例因双J管向上移位，经输尿管镜取出。

Liapunov—Schmidt method is one of the most important method in the bifurcation theory.

Liapunov—Schmidt方法是分叉理论的最重要方法之一。

Be courteous -- even when people are most discourteous to you .

要有礼貌──即使当別人对你最不礼貌的时候。