查询词典 anisotropically

The deformation of conductive particles in pure metal connected by anisotropically conductive adhesives has been investigated using finite element analysis. The results indicate that the increment in stresses of the conductive particles begins at the contact area toward the boundary through the centers of conductive particles when the reduction in height increases. When stress is over the yield strength, the similar behavior was observed. So the deformation of conductive particles is not uniform, which means that the deformation of conductive particles is the same as the stress does.

采用有限元模拟分析了各向异性导电胶连接的纯金属导电颗粒的变形过程，研究结果表明，随着压下量的增加，导电颗粒的应力增加由接触面开始，经中心区域向导电颗粒的周边扩展，大于屈服强度的应力变化与此相似，因此导电颗粒的变形是不均匀的，即导电颗粒的变形由接触面开始，经中心区域向周边区域进行。

The author suppose, the anisotropically undrained shear strength is applied for the first time in the analysis of resistant heave stability for deep braced excavations in the world, the safety factors of two kinds of stability failure are gained, the first kind of factor is stability against sliding, the second is losing the ultimate bearing capacity.

在国内外首次将各向异性不排水剪强度应用到深基坑抗隆起稳定分析中，推导抗滑稳定破坏（包括浅桩支护及刚性支护）和丧失极限承载力破坏两种情况下的稳定安全系数公式，对典型上海软土的模型参数进行计算分析，并对各参数对安全系数的影响进行讨论，最后以三个工程实例加以验证。

It is indicated that loosely compacted soil is of strain-softening behaviour under undrained conditions, accompanied with a rapid increase in excess pore water pressure. In anisotropically consolidated constant shear stress tests, a very small axial strain was required to induce the failure and the excess pore water pressure increased quickly at failure.

研究表明：松散填土在不排水条件下具有应变软化的特性，软化过程中伴随着孔隙水压力的迅速上升，有较高的液化势；在常剪应力排水剪条件下，具有破坏前轴向应变小、破坏时间短，破坏过程中孔隙水压力迅速上升。

All non-hydrogen atoms were refined anisotropically.

所有非氢原子经各向异性精修。

Then, by depositing conformal SiO2 on the polysilicon pattern, etching back SiO2 anisotropically in the perpendicular direction and removing the polysilicon with KOH, a sacrificial SiO2 spacer was obtained.

然后在多晶硅台阶上淀积保形性很好的SiO2层，再采用高度各向异性的干法刻蚀进行垂直刻蚀SiO2。在使用KOH去除多晶硅后，可以获得SiO2纳米线。

The method includes the following steps: depositing a non-magnetic layer (3) of sufficient thickness; anisotropically etching the non-magnetic layer to form a steep wall of suitable dimensions at the required position of a flux guide; depositing a magnetic material to form a magnetic layer (9) on the wall in such a manner that the magnetic layer has a thickness corresponding to the required track width; removing undesired deposits of magnetic material but maintaining the magnetic layer on the wall; depositing an insulating material (19a) to cover the magnetic layer.

该方法包括下列步骤：淀积足够厚度的一个非磁层(3)；非均质地蚀刻该非磁层以便在磁通引导的要求位置形成适宜尺寸的阶跃内壁；淀积一个磁性材料，以便在该内壁上形成一个磁层(9)，使得该磁层具有对应于该要求的磁迹宽度的一个厚度；去除不希望的淀积的磁性材料而保持在该内壁上的磁层；淀积一个绝缘材料(19a)以便覆盖该磁层。

Stringered sulfide inclusions severely and anisotropically affected the caustic SCC of 16MnR steel.

沿轧向分布的条状MnS夹杂使16MnR钢横向抗碱脆性能明显低于其纵向抗碱脆性能。

Precursors of sulfates and alkali halides prepared in co-deposition process were mixed homogenously, annealed at high temperature and then formed CoO and NiO fibers, XRD, XPS, Raman and SEM were used to characterized the samples, the growth of these fibers might be a special LS mechanism: soluble precursors in molten salt decomposed gradually to form initial crystal nucleus and succeeding particles adhered to these nucleus and grew anisotropically in the special high temperature fluent medium, the higher decomposition temperature and solubility of the precursor are two key factors in this method, which are in favor of a longer growth process and result in larger sizes of the final metal oxides crystals.

以共沉淀方法生成硫酸盐与碱金属卤化物融盐的均匀混合前驱物，在高温下退火制备出了CoO和NiO的晶须，以XRD和XPS等对成份进行了分析，SEM分析了形貌特征，研究了不同前驱物热分解特性，认为本方法是一种简单的LS生长机制：可溶性前驱物于融盐中热分解后逐渐析出成核，后续的粒子附着在核上，在融盐环境下沿一定方向作准一维生长，其产物形貌之不同源于硫酸盐的高分解温度和在融盐中的可溶性，导致晶体生长过程中成核过程与生长过程竞争的结果对一般前驱物结果的偏移。

The variograni of No.100 ore-body in three directions have been calculated, and the variogram curves were formulated. All these curves are leap type. The mathematical models of grade variability of Sn. Pb.. Zn.. Sb and Ag have been established respectively, the structural analysis of No.100 ore-body indicates the ore-body varies band anisotropically.

计算并拟合了100号矿体三个方向的变异函数，各变异函数曲线均为跃迁型，分别建立了Sn、Pb、Zn、Sb、Ag五元素的品位变化的数学模型，结构分析表明100号矿体呈带状各向异性变化。

Creep cracks seem always to initiate at inherent casting pores and slowly propa-gate anisotropically along the (001) planes, perpendecular to axis of stress applied, upto the final fast fracture. Creep cracks can also nucleate at fractured carbides or at in-terfaces between carbides and matrix in the alloys containing more carbon.

结果表明：单晶的蠕变断裂具有明显的晶体学特征，蠕变裂纹总是从已有的铸造的显微疏松处萌生；对于含碳量较高的材料，碳化物及其与基体的界面也是裂纹萌生的有利位置；这些已萌生的裂纹在外加应力轴垂直的(001)面上各向异性地扩展，直到由于承载截面的逐渐减小而导致最终破坏。

But we don't care about Battlegrounds.

但我们并不在乎沙场中的显露。

Ah! don't mention it, the butcher's shop is a horror.

啊！不用提了。提到肉，真是糟透了。