查询词典 angle of torque

Using laser Doppler effect , based on measurement of the rotate speed of single section , the speed difference of double sections is measured and integrated , then the torsion angle of rotating shaft on torque effect is got. The non2contact torque measurement is realized , and dynamic monitoring of rotary machine equipment is achieved.

利用激光多普勒效应，在单截面测量转轴转速的基础上，采用双截面测量转速差并积分得到转轴在扭矩作用下的扭转角，实现扭矩非接触测量，达到回转机械设备的动力监测的目的。

Integrating the rotational speed difference, the relative torsion angle of the two sections under the action of torque was obtained, so the rotating shaft torque was gotten.

同时，设计了实验系统并在扭矩实验平台进行了实验，实验结果表明，激光多普勒法与传统扭矩测量方法的相对误差小于0.2％，说明激光多普勒法具有较高的测量精度。

The muscle samples were taken and check under microscopy and electro-microscopy,Desmin was checked with imunohistochemistry technique,maximal isometric titanic force,CK and LDH in blood,MDA and SOD in muscle were assessed for rats,before and after exercises to show muscle damage,maximal isometric torque,muscle soreness, circumference of the arm,range of motion of the elbow were assessed before and after exercise to show muscle damage,maximal eccentric torque, optimal angle of the elbow,total work during exercise were also assessed for college students.

观察指标包括：肌肉活检光镜及电镜观察，肌肉骨架蛋白Desmin组织化学荧光标记，电刺激最大强直肌量，血清LDH、CK及肌肉MDA、SOD等；等长峰力矩MIT，肌肉酸痛度SOR，肢体围度CIR，关节活动范围ROM，运动中离心峰力矩及其对应关节角度、所做总功等。

In order to implement the algorithm, a linearization method is applied in an extremely short sampling cycle to calculate the increments of torque and flux magnitude, to derive the linear equation between the desired stator flux linkage vector increment angle and the increments of torque and flux magnitude, to derive the stator voltage vector reference and to determine the next position of the stator flux linkage vector.

算法的实现运用了线性化的方法，在一个极小的采样周期内，计算出转矩增量和磁通增量，以此推导出所需的定子磁链增量角与转矩增量及磁通增量两者之间的线性方程，进一步导出所需的定子电压矢量，并确定新的定子磁链位置。

Based on the analysis of calculation theories on magnetic field and torque of permanent magnetic gears, the characteristic curve of torque-angle are calculated with the use of Ansoft electromagnetic calculation software.

本文在分析永磁齿轮磁场和转矩计算理论的基础上，利用Ansoft 电磁计算软件计算了平行轴永磁齿轮的矩角特性曲线，并研究了恒定负载下永磁齿轮的转速波动情况。

In this paper, according to the theory of electromagnetic fields, firstly, electromagnetic field of large and medium asynchronous motor is calculated from the angle of coupled fields, secondly, the end voltage of the stator is taken as constraint condition and starting current in stator is iterated in the numeral computation process, finally starting current and starting torque at rated voltage are gained, and by comparing calculation results with test results ,starting performance of large and medium asynchronous motor meet the demand of project practice.

本文根据电磁场理论，从耦合场的弱耦合角度首先计算了大中型异步电动机的电磁场，在电磁场的数值计算过程中，以定子端电压为约束条件，对定子起动电流进行了迭代计算，得到了额定电压下的起动电流和起动转矩，并把正弦时变场计算结果与实测结果进行对比，表明大中型异步电动机的起动性能的计算结果满足工程实际的需要。

The instrument runs stably in pratical with the merit of little stepping angle, unvaried torque and low power consumption.

实际运行表明，步进电机运行稳定，且具有步距角小、矩恒定、耗低等优点。

Utilize energy method to research crook problem of drilling rod under pressure and act on together, having studied the crooked influence to the drilling rod of torsion emphatically, the theory analyses found that Axial load, hole vertex angle and torque are important factors of influence drilling rod crook.

利用能量方法研究了压力和扭矩共同作用下钻杆的弯曲问题，着重研究了扭矩对钻杆弯曲的影响，理论分析发现，轴向载荷，钻孔顶角和扭矩是影响钻杆弯曲的重要因素。

In this paper, the flux oriented angle of stator flux oriented vector control is deduced by the voltage vector space angle of the direct torque control, and mathematical model is set up based on the direct and quadrature axis component of the stator current.

将直接转矩控制与定子磁链定向矢量控制相结合，利用DTC中电压矢量的空间位置角，推导出SFOVC中的磁链定向角，然后根据旋转坐标系中的d轴和q轴电流分量，建立定子磁链估计的数学模型。

On the base of the data measured on automotive mechanics parameters tester, through setting up a relationship between lateral angle of tire, body roll angle, aligning torque and lateral acceleration and using method of least square, for curve fitting on non-linear data, a relationship has been found between these data and stable steering characteristics.

本文以汽车力学参数试验台测出的数据为基础，通过建立轮胎侧偏角、车厢侧倾角、回正力矩与侧向加速度之间的关系，运用最小二乘法对测试数据进行非线性曲线拟合，找出了这些数据与汽车稳态转向特性之间的关系，并按国家标准GB/T13047-91中的有关规定对被测试车辆的稳态转向特性进行了评价

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失