查询词典 angle of reflection

In this study, we use Computer Aided Diagnosis Axiogragh recorded condylar movement of normal occlusion and Angle class two division one subdivision malocclusion with mandibular retrusion every twenty-five during mandible open and close, protrusion and retrusion, and medio-free movement. Then we analysis the deference in order to find out the characteristic of condylar movement of Angle class two division one subdivision malocclusion with mandibular retrusion and the change regularity among befor and after functional appliance treatment.

本研究以正常牙合和下颌后缩型安氏Ⅱ类1分类错牙合各25名为研究对象，采用髁突运动轨迹轴图描记仪(Computer Aided Diagnosis Axiogragh)记录其下颌在开闭口、前伸后退和侧方运动时髁突的运动情况，对比分析下颌后缩型安氏Ⅱ类1分类错牙合的髁突运动轨迹特征及其功能矫治前后髁突运动轨迹的变化。

The research concluded that the design of the kingpin caster angle γ and the kingpin inclination angle β are rather little, which caused inadequate steering self returnability and light hand holding when the truck is empty.

研究认为：该型货车主销的后倾角γ和内倾角β设计保守偏小，空载时转向轮回正能力和转向盘手感不足。

There is a 30 degree lead angle roughing cutter and two 30 degree lead angle finishing and semifinishing cutters.

有一种60°主偏角的粗铣刀具和两种60°主偏角的半精铣/精铣刀具。

A method of designing antireflection coatings by the way of Rugate coatings was presented. The reason of difference of transmittance was analysed under the circumstanes of polarization and board angle incidence. Antireflection coatings of 1500-1600nm and incidence angle from 0° to 80° were designed. A new way of design was founded.

阐述了利用Rugate膜系理论设计宽角度减反射薄膜的方法，从理论上分析了在宽角度的情况下，偏振产生透过率不同的原因，模拟设计了光谱区在1500-1600nm波段，入射角从0度到80度宽角度减反射薄膜，探索出了一条新型膜系设计的途径，其优化结果是较为理想的。

The change of motor thrust ,deflection angle of thrust line with scarfed angle was investigated.

应用有限体积法建立了三维守恒型N-S方程组的数值求解器，对某非轴对称斜切喷管内流场开展了数值模拟计算，研究了斜切角度变化时引起的发动机推力及推力线偏转角变化。

Our results showed that the most appropriate rib's level for applying force was below the apex of scoliotic spine. From this appropriate level, the stress delivered to its conjunctive vertebra was the highest, as 1.3~1.8 times compared with others. Furthermore, the correction of Cobb's angle was also the highest, achieved 15%. The ML force was dominant in alteration of Cobb's angle, whereas the AP force was dominant in alteration of axial vertebral rotation. In addition, initial vertebral rotation influenced neither correction nor stress.

研究结果显示由凸点椎体的下一节对应之肋骨施力能使传入椎体具最高平均应力，较其他施力位置高出1.3到1.8倍之间，对柯卜氏角度可达15%的最佳矫正率；其中侧向施力主导冠状面上的矫正，而前后向施力主导扭转角度的矫正；另外椎体初始旋转角度对侧弯矫正和应力分布均无明显影响。

The conditions for the formation of different surface morphologies have been discussed in terms of the contact angle of SEPs at the interface between water and chloroform, and a contact angle slightly greater than 90o is found to be pre-requisite for the formation of honeycomb structures.

我们通过改变复合物中烷基链密度、烷基链长度以及多金属氧簇内核的尺寸，详细研究了复合物的亲疏水性和尺寸对所形成的多孔膜形态的影响，并在得到高度有序的多金属氧簇复合物有序多孔膜的同时，首次获得了有序多孔结构的形成规律，即只有界面接触角稍大于90o的复。。。

The eff ect of launching force and angle of attack on the misˉ sile trajectory was presented, it is indicated that launching force just accelerates the movement of the missiles while the angle of attack change have a greater impact on movement paramet ers of the missile.

分析挂架弹射力和载机迎角变化对分离过程运动参数的影响，发现挂架弹射力仅是加快了导弹的运动，而迎角的变化对导弹运动参数有较大影响。

Because the most actual bank sides are slantwise, the wave-making resistance under different width conditions was calculated by changing the angle of the bank sides to test the practicability of this program. By analyzing the angle of the slantwise bank and the coefficient of the wave-making resistance, the optimal distance to the bank can be determined.

考虑到实际的航道岸壁大多为倾斜岸壁，为增强本方法的实用性，在上述基础上，通过改变航道岸壁的倾斜角度，计算船舶在不同航道宽度情况下的兴波阻力，由兴波阻力系数与岸壁倾角之间的关系分析，得到倾斜岸壁对船舶兴波阻力的影响。

The scale-type geometric wear-resistant structure surface is characterized in being made up of a base and the bionic geometric units on the surface. The bionic geometric structure unit is a scale-type structure distributed regularly on the surface of the base, and the distribution density is that: the ratio between the geometric projection area of the scale-type structure on the base surface and the surface area of the base formed by all the edge ends is 50-100%; the scale-type geometric structure unit has a symmetric hexagon shape on the surface; the sides L2/L1=1.0-2.0, L1: 1mm-50mm, and the internal angle Alpha is 120 degree -130 degree, the internal angle Beta is 100 degree -110 degree; the A-A section is subtriangular, and the B-B section is a trapezoid, the height H of the scale-type is 1-5mm.

本发明由基体和其表面上的仿生几何结构单元组成，仿生几何结构单元为在基体表面规律分布的鳞片型结构，鳞片型的分布密度为：其在基体表面上的几何投影面积之和与所有棱端围成的基体表面积之比为50-100％，鳞片型几何结构单元的表面形状为对称六边形结构：边长L2/L1＝1.0-2.0，L1：1mm-50mm，内角α为120°-130°，内角β为100°-110°，鳞片型的A-A截面为近似三角形，B-B截面为梯形，鳞片型的高度H为1-5mm。

The dissecting of samples in group2 were difficult. The root of pulmonary artery and ascending aorta failed to be unfolded because fibrous tissue was tough, right and left fibrous trigone were too firm to be solved by hand. Cardiac muscle fibers couldn't be stripped along myofibrillar trajectory since they were prone to break because of their friability.

组2的心脏解剖困难，表现为纤维组织坚韧，游离肺动脉非常困难；徒手无法松解左、右纤维三角，肺动脉和主动脉根部的游离非常困难；心肌纤维坚硬、质脆，解剖时容易断离成碎块，无法沿纤维走行方向剥离。

We have battled against the odds in a province that has become increasingly violent.

我们对在一个争夺日益激烈省的可能性。