查询词典 angle of pitch

Several factors that affect the stability of solder bridging spanning two identical circular pads are considered herein, including the pad size, the total volume of solder bumps, the pitch between adjacent pads, the contact angle between the molten solder alloy and the pad, the contact angle between the molten solder alloy and the solder mask and the surface tension of the molten solder alloy, respectively.

锡桥稳定性之影响因子，如垫片尺寸、焊锡凸块总体积、相邻垫片脚距、熔融焊锡与垫片间之接触角、熔融焊锡与防焊层间之接触角以及熔融焊锡之表面张力等均分别予以有系统之探讨。

Through transformation of parameters, the meshing design system among Hy-Vo silent chain, sprocket and hob was built up based on the research of the pitch increment and the equivalent apothem increment of the effects on the common normal line length when the Hy-Vo silent chain was wrapped around and located on the sprocket, with the proper meshing conditions of Hy-Vo silent chain and sprocket into consideration. The design method of common normal line length was put forward that can be used when the value of the sprocket pressure angle was equal or unequal to the value of the Hy-Vo chain plate pressure angle.

在分析Hy-Vo齿形链链节围在链轮轮齿上定位时其节距增量和当量边心距增量对链轮公法线长度影响的基础上，根据Hy-Vo齿形链与链轮的正确啮合条件，通过参数变化，建立了Hy-Vo齿形链－链轮－滚刀三者之间的啮合设计体系，提出了既适用于链板齿形角等于链轮压力角情况，也适用于链板齿形角不等于链轮压力角情况的Hy-Vo齿形链链轮公法线长度的计算方法。

The flexure of claim 1 wherein a positive change in flap angle produces a negative change in pitch angle.

柔性索赔1其中了积极的变化，在皮瓣的角度产生负面的变化俯仰角。

Firstly, full factorial experiment method is implemented to achieve an optimization of longitudinal microstructure design in the incidence plane of a LGP for LED BLUs. There are three control factors involving in the optimization process: the pitch and depth of both V-cut and U-cut, and angle and radius for V-cut and U-cut, respectively. Each individual control factor has three levels. It leads to a total of 27 sets of experiments.

本实验先行讨论全因子实验求取发光二极体背光模组之导光板入光侧纵沟微结构最佳化设计，选定入光侧V-cut纵沟微结构控制因子：V-cut角、V-cut间距、V-cut深及入光侧U-cut纵沟微结构控制因子：U-cut半径、U-cut间距、U-cut深等项目，其中各一因子分别有三个水准变化，依控制因子及其水准的目各进行27组实验。

Plain scan and enhanced scan were performed in these patients with Siemens 64-slice spiral CT with the following parameters: 1.0-mm section thickness,0.6-mm collimation,pitch of 1, voltage of 120Kv and tube current of 100mAs, The scanning range is from the thoracic inlet to posterior costophrenic angle; A 80-100ml dose of nonionic iodinated contrast material is injected intravenously at approximately 4-5 ml/sec.

扫描采用Siemens 64层螺旋CT；扫描参数选择层厚1 mm，准直0.6mm，螺距1，管电压120 kV，电流100 mAs；扫描范围从胸廓上口至后肋膈角；强化时对比剂为非离子型对比剂(碘海醇，350 mg I/ml)，注射流率4～5 ml/s，对比剂总量80～100 ml；采用人工智能触发扫描技术，触发点选择肺动脉主干横断层面，阈值为100 HU，触发扫描延迟时间为6 s。

Nanjing Green State machine factory Decanter centrifuge design engineer Yan Chun Min, qualitative analysis of the sediment conditions Decanter centrifuge drum cone angle with a knife, screw conveyor blade angle B, blade pitch, liquid pool radius and the difference between speed An elaborated to improve the conditions of slag lose Decanters design ideas.

南京绿州机器厂卧螺离心机设计所高级工程师颜春敏，定性地分析了卧螺离心机的沉渣条件与其转鼓的锥角刀、螺旋输送器叶片的倾角B、叶片的螺距、液池半径及差转速An之间的关系，阐述了改善卧螺离心机输渣条件的设计思想。

To model and compensate the magnetic heading error of the magnetic compass system which in a carrier with some pitch angle or roll angle,a new deviation compensation algorithm based on RBF neural network is presented.A BP neural network has been developed to solve the same problem for comparison.

针对具有一定俯仰角或横滚角的磁罗盘系统磁航向误差建模和补偿问题，提出了基于径向基函数神经网络的修正方法，并与BP神经网络方法进行了比较。

In the second method, the nonlinear tracking differentiator is applied to producing the differential signal of the pitch angle, which is used to calculate the pitch angular rate.

给出了两种重构方法，一种是通过建立等效的线性模型，设计线性状态观测器重构状态信号，另一种是使用非线性跟踪微分器方法，通过跟踪俯仰角的微分信号来计算俯仰速率信号。

This paper addresses the control problem of a variable speed wind turbine system in above rated wind speed which uses pitch angle control of the blades and delay angle control of the rectifier,with special emphasis on the differential geometric theory.

讨论了在额定风速以上时变转速风力机的控制问题，系统采用基于微分几何理论下的桨距角和触发角双输入控制。

The experiment resuh shows that in straPdawn condition, with thegnscoP suPPlying attitude, the measuring direction s maximum ermr is less than 0 .6 degree (the range of the bank angle and the pitch angle is within ± 45°).

实验结果表明：在捷联状态下，用垂直陀螺提供我体的姿态角，在俯仰角、倾斜角达±45°的情况下，测角精度优于0.6°。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐