查询词典 angle of contact

Meanwhile, the coated surface was hydrophobic with a contact angle of 107.2°since the introduction of methyl groups and methylene groups. Static immersing corrosion test, potentiodynamically polarization curve and electrochemical impedance spectroscopy were conducted to evaluate the film corrosion performances. The results of potentiodynamically polarization curve and EIS in 55wt% LiBr solutions at room temperature in atmospherical pressure indicated that the corrosion current density of BMBSE film coated surface was 4 orders of magnitude smaller than that of bare SUS304 steel, and the impedance was increased by a factor of 10000. Static immersing corrosion test presented that the BMBSE film can significantly increase the corrosion resistance in 55wt%LiBr solution at 180°C compared with stainless steels.

同时由于有机组分甲基和亚甲基的引入，结构均匀致密，并具有一定的疏水性；电化学测试结果表明BMBSE膜的极化阻抗比不锈钢大4个数量级，自腐蚀电流密度也下降低了4个数量级左右，具有良好的耐腐蚀性能；成膜的影响因素优化结果表明BMBSE、EtOH、D.I.water摩尔比为1∶4∶3，热处理温度为200℃时，更有利于制备结构均匀、致密、耐腐蚀性能好的薄膜；静态浸泡腐蚀实验结果说明，在180℃、55%的高温溴化锂溶液中BMBSE膜能起到良好的腐蚀防护作用。

SiO 2/TiO 2 superhydrophilic coating on glazed tile substrate was prepared by solgel method,the surface chemical composition, contact angle of water and photographs of surface of the coating were studied by use of XPS,photomicroscopy and SEM.

用溶胶 -凝胶方法在釉面砖上制备了SiO2 /TiO2 超亲水涂层，用XPS、光学显微镜和SEM研究了涂层的表面化学组成、水润湿角和表面形貌。

With the results of contact angle and analysis of surface and interface to polychloride, TDI, PF and NBR is proved to attach to the ATH surface to successfully produce the multi-modified layers with the characteristics of polarity transiting gradually from large to small.

通过接触角测量、表面张力及其与PVC界面张力的计算结果表明，TDI、PF、NBR依次在ATH表面成功地形成了极性由大到小、逐步过渡的多层改性层，ATH表面极性随着改性层数的增加而逐步减小。

The result indicated that we can get stable homopolymer and copolymer emulsion with uniform size distribution, when the ratio of sodium polyether sulfovinate modified polysiloxane to sodium lauryl sulfate was two, the quantity of the emulsifiers ranged from 6% to 8%, the quantity of initiator ranged from 0.4% to 0.8%, the stirring speed ranged from 200rpm to 250rpm, the polymerization temperature was 80 centigrade degree. As for the copolymer emulsion, the more the TRIS content in the monomers, the larger the water contact angle of their films became, namely, the surface energy of the copolymer films increased with the TRIS content in the monomers. In addition, the glass-transition temperature of the copolymers ranged from high temperature region to low temperature region with the increasing of TRIS content in the monomers.

结果表明：当乳化剂用量在6%～8%、改性乳化剂与十二烷基硫酸钠复配比为2：1、引发剂用量在0.4～0.8%、聚合温度为80℃、搅拌速度在200～250rpm时，得到的均聚物和共聚物乳液稳定，而且粒径分布均匀；对于共聚物乳液来说，随着单体中TRIS含量的增加，所得聚合物膜的水滴接触角增加，即其表面能增加：另外，随着共聚单体中TRIS含量的增加，共聚物的玻璃化转变温度从PMMA的Tg的高温区向PTRIS的Tg的低温区移动。

The intercrossing angle of the two kinds of epitaxial lamellae is about ±45℃,while the contact planes should be (010) of IPP and (100) of LLDPE.

两种片晶的c轴成45°交角，附生结晶的接触面为LLDPE的(100)和IPP的(010)。

The surface and cross section of uncoated and coated Polyvinyl acetals were analyzed by microscope and SEM, results showed that, the contact angle of the coated fiber decreased in most of the areas of the fibers, the chitosan film on the fibers was thin and uniform. At the same time, there was no residual material in the coating process and the whole process was environmentally friendly.

结果表明，该方法切实可行，通过显微镜和SEM照片对涂覆壳聚糖前后的维纶纤维进行微观分析，发现在化学纤维表面形成的壳聚糖膜薄而均匀，同时增加了化学纤维的表面粗糙度，涂覆效果较好；通过接触角的变化说明纤维的亲水性得到改善；该方法还具有无残留物和对环境友好的优点。

The contact angle of complex coatings composed by latexes with different sizes of particles, glass transition temperatureT(subscript g and core-shell structure were measured and the effect of binary collaboration was also discussed.

将粒径不等、T不同的乳液复配、核壳结构不同的乳液复配，并测定了复配物成膜后的接触角，讨论了它们可能产生的二元协同作用。

The changes of contact stress on the facet joint, maximum slip displacement of the implants on the endplate, and rotational angle of the upper vertebra were investigated under different loading conditions.

计算植入不同椎间融合器在不同负载情况下，对小面关节应力、植入物与终板界面滑动距离与上椎体旋转角度的影响。

Pure magnesium was treated by A. C. treatment technique in 0.25mol/L NaZSO4+0.1mol/L NAOH solution. The surface morphology was observed by scanning electron microscopy. The contact angle of the treated surface of pure Mg was measured by the First Ten Angstroms instrument and then its surface free energy can be calculated. The effect of alternating current treatment on the corrosion resistance of the pure magnesium was studied through electrochemical methods in 0.05mol/L NACI+0.01mol/L NAOH solution. The experimental results showed that a uniform and perfect oxide film was formed after A.

采用载波处理方法，用0.25mol/L Na2SO4+0.1mol/L NAOH作为载波处理溶液，对纯镁试样进行载波处理，通过正交试验确定载波处理的最佳工艺参数；用扫描电了显微镜观察载波处理后试样的表面形貌；用First Ten Angstroms仪器测量蒸馏水纯镁的接触角并计算出表面能；用电化学方法研究了在0.05 mol/L NACI+0.01mol/L NAOH溶液中载波处理对纯镁耐蚀性能的影响。

The elongations at break were monotonously increased with the addition of organosilicone at a saturated content of 3%, at which the elongations at break were improved by 57% and 50%. The more the content of organosilicone, the smaller the contact angle of the nature rubber latex.

随着KGF-903含量的增加，改性天然乳胶片的水接触角逐渐减小；扫描电子显微镜观察的结果表明，添加聚硅氧烷能改变乳胶的分散状态。

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里，举止就文雅一些，因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计，这件高贵的制服是香港本土制造，是我们第一套不配帽子的制服。