查询词典 angle beam

The results show, when the prism wedge angle is 4°, the transmitted laser beam changes about 1 μrad as the prism rotates 1′; when the small angle deviation on one side of the minimum deviation angle of each prism is controlled, the scanning range of laser beam in the horizontal and vertical direction is not less than 500 μrad, and the scanning precision of the device is superior to 0.2 μrad.

结果表明：取棱镜棱角α为4°时，棱镜每旋转1′，透射光束变化约1 μrad；分别控制双棱镜在其最小偏向角一侧小角度偏转，可以实现光束在水平方向和垂直方向500 μrad范围内的精确扫描，装置的扫描精度可以达到0.2 μrad。

C. Two angle of the angle beam, differ from between the two angle of refraction is greater than or equal to 10

二种角度的斜射波，两者角度差10

The relationship between transmitter, receiver apex angle, beam divergence, and the value of loss-time delay are simulated by model developed by Luegtten. Energy distributing is elicited in the fixed angles.

该文通过利用Luettgen提出的非视距单散射模型，比较了在不同仰角、光束孔径角情况下，损耗、延时、脉冲半宽展宽的变化特征，并给出了不同传输距离下能量密度的分布情况。

In strictly, it is hard to make the light normal incident into the sphere, double refraction will take place in crystal sphere when a TEM〓 mode Gaussian beam oblique incident into the sphere, and the two orthogonal polarized beams are both elliptical Gaussian beam. The ellipticity and eccentricity of the elliptical Gaussian beam will change with the incident angle, and for a fixed incident angle, they will change with the shifting of incident beam waist position.

由于严格意义上的正入射较难实现，基模圆高斯光束斜入射晶体球后将在球内产生双折射，且球内偏振态正交的两束折射光都将是椭圆高斯光束，它们的椭圆度e和偏心度Δ随入射角的改变而改变，在入射角一定的情况下，入射光束束腰的移动也将改变这两束折射光的椭圆度e和偏心度Δ。

So the main study contents of this thesis are as follows: the load distribution pattern along the length beam and the cross beam in the place of node、 the appropriate matching rigidity of the length and cross beams in the action of same anchorage force and the affection pattern discuss on sloping surfaces dip angle、 beam rigidity 、 anchor-rope angle as well as the position of load which affect the load distribution ratio on length and cross beams. In the end it brings forward lattice beam internal force calculated method on the basis of double parameter groundsill model.

鉴于此，本文主要的研究内容是格构梁节点处荷载沿纵横梁的分配规律、同一锚固力作用下纵横梁合理的匹配刚度以及对格构梁纵横梁荷载分配比值可能存在影响的坡面倾角、梁刚度、锚索夹角、加载位置等因素的影响规律探讨，最后提出基于双参数地基模型的格构梁内力计算方法。

The separation angle about beam and beam is depended on the vice structure angle:the design of splitting Li P prism is better about the need of beam vertical out;the design of splitting Grand · Thompson prism is better about the need of big splitting angle .

出射的 光与光的分离角与副结构角有关；对于光垂直出射的需要，选用分束李普奇棱镜设计为好；对于大分束角的需要，选用分束格兰·汤普逊棱镜设计为好。

After verification of FEM, 45 species of 15 series are computed. The major parameters including slippage coefficients, pretensions forces, dimensions of angles, arrangement of bolts, connection method among angle, beam web, column flange, and so on are studied. Some important conclusions are drawn.

主要研究了摩擦系数、螺栓预拉力、螺栓线到与柱连接角钢肢背的距离、螺栓直径及级别、梁长、螺栓排列布置、梁高、柱翼缘厚度、角钢厚度、角钢长度、梁腹板只与角钢肢尖相焊接、钢材强度、角钢与梁柱均栓接、角钢与柱焊接与梁栓接、角钢与梁柱均焊接等参数对腹板双角钢梁柱连接滞回性能的影响，得出了一系列重要的结论。

After verification of FEM, 45 species of 15 series are computed. The major parameters including slippage coefficients, pretensions forces, dimensions of angles, arrangement of bolts, connection method among angle, beam web, column flange, and so on are studied. Some important conclusions are drawn.At last, Advices for seismic design based on tests and FEM analysis are presented at last. The study is rather comprehensive and systematic, and the conclusions. can be useful for revising design code, guiding design of engineering, and provide good basis for further to study behavior of shear beam-to-column connections.

主要研究了摩擦系数、螺栓预拉力、螺栓线到与柱连接角钢肢背的距离、螺栓直径及级别、梁长、螺栓排列布置、梁高、柱翼缘厚度、角钢厚度、角钢长度、梁腹板只与角钢肢尖相焊接、钢材强度、角钢与梁柱均栓接、角钢与柱焊接与梁栓接、角钢与梁柱均焊接等参数对腹板双角钢梁柱连接滞回性能的影响，得出了一系列重要的结论。

But the real focus of shoring in hard rock, the rock Zaocheng a trapezoidal shape of right-angle look, and then insert-beam, and right-angle ladder to fully close some acute angle, using principles of mechanics into a half-beam as the base.

而真正的重心撑在坚硬岩石里，岩石凿成了形似直角梯形的样子，然后插入飞梁，使其与直角梯形锐角部分充分接近，利用力学原理半插飞梁为基。

The vibration test is marked in different velocities to probe the effective way of the beam damping by changing the fixed type of the beam on two ends,setting up the curve beam with right angle to sustain the beam,and installing the rubber damper,so as to reduce the amplitude of the beam .

通过改变横梁两端固定方式，增设直角弯梁后撑横梁，加装横梁橡胶减振器等方法，在不同速度工况下进行振动测试，以减小横梁振动的幅值。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。