查询词典 analyzing

Because the chemistry interference is more complicated, I find out some compendious methods of dispelling interferences by carrying on analyzing its procreant reason and combining myself practice of experience. Such methods as these: add the solvents of improving and solvents of releasing, use high temperature flame, chemistry apart and standard addition, etc.

化学干扰比较复杂，通过对其产生的原因进行分析和结合本人的检测实践经验找到了一些间简单消除干扰的方法，如加入释放剂、加入保护剂、利用高温火焰和化学分离以及标准加入法等。

By analyzing the structural size of flexible shaft of the existing screw drill, the finite-element model of force analysis of the flexible shaft is established.

通过对现有某型号螺杆钻具挠性轴的结构尺寸分析，建立了挠性轴受力分析的有限元模型。

By checking and analyzing the stresses of floor and main beam, the results show that the support system can meet requirements.

通过对楼板以及主梁的验算分析得出，该支撑体系符合规范和施工要求。

The simulation results of the cylinder-block model were given in the article, consistent with that of Middlemen"s. It was shown that the block part could improve the uniformity of the flow distribution. The analysis of the flow field of some materials with different power-law factor in the die designed by Mckelvey was close to that of Mckelvey"s. It was shown that the flow distribution was uniform in the die that can producesheets with 1200mm in width. During the analysis the flow channel was divided into several parts to get the details about the fluid flow in each area. A conclusion was drawn after analyzing the influence of the die pressure on the flow distribution, that the higher pressure is good for the output and bad for the uniformity of the distribution. Simulation of the die applying the cylindrical main runner showed the fact that when the cylinder replaced the cone the change of uniformity was trivial. The uniformity of the non-block flow channel was so poor that the block in the proper position of the die channel was necessary. The project of the die for the wider sheet was put forth, and the analysis of the fluid flow in the die was shown.

本文模拟了圆柱管缝隙流模型的三维流动场，得到了与Middlemen结论一致的流动均匀性，并通过模拟直观地展示了采用阻尼块可以改善挤出均匀性的现象；分析了多种幂率指数的流体在Mckelvey等人设计的流道模型中的流动分布，得到了与Mckelvey的分析结果接近的压力降和流量偏差；本文建立了1200mm幅宽机头流道的三维有限元模型，并逐个分析各个区域和多个截面的流动分布状况，由此揭示了1200mm幅宽L-型机头流道内的流北京化工大学硕士学位论文动分布基本均匀，并在分析了机头压力对于挤出流动分布的影响后得出结论：较高的机头压力可以获得较大的产量，但是不利于物料均匀分布；模拟了采用圆柱管主流道时机头流道内的流动分布，得出结论：主流道由圆锥管改为圆柱管时对流动均匀性影响不大，通过设置适当的阻尼仍然可以达到挤出平衡；模拟了两端进料式圆柱管无阻尼流道的流动均匀性后得到结论：两端进料式无阻尼结构的流动均匀性较差，宽机头中仍然有必要设置阻尼块；确定宽幅机头流道的基本方案，并设计了一种宽幅防水卷材挤出机头流道的结构，通过流动模拟表明该种结构的流动均匀性较好；考察了宽幅机头对于不同厚度片材的挤出适应性，得到结论：当生产不同厚度的片材时，阻尼块高度需要调整。

Methods: Comparing and analyzing the samplings′ operation time, length of stay, Bhler angle Gissane angle and the foot function score.

对两组手术时间、住院时间、Bhler角与Gissane角及足部功能评分(Maryland足部功能评分)进行分析。

By analyzing the foot indexes variances of athletes at different loads, some useful conclusions have been discovered.Firstly,different weight-bearing has influence on the foot shapes of youth track man. Secondly,there is marked difference on the foot shapes between youth track man and common undergraduates.Then,Sensitive and non-sensitive indexes were discovered.Length,width of foot,height of internal malleolus,height of external malleolus,height of medial longitudinal arch,etc.varied significantly with the increasing work load.For length of instep,width of heel,toe angles,no differences were identified between sets.

通过对不同载荷承重下的青年田径运动员的足部外形指标的差异分析，得到以下结论：不同载荷压力对足部外形变化有一定影响：我国青年田径运动员在不同载荷下的足部外形指标与普通青年大学生存在较大差异；我国青年田径运动员的足长、足宽、内踝高、外踝高、内侧纵弓高等指标容易因载荷的不同而产生明显变化；我国青年田径运动员的足面长、足跟宽、跖趾斜宽角、自然前翘角等指标不易受到。。。

By analyzing the foot indexes variances of athletes at different loads, some useful conclusions have been discovered.Firstly,different weight-bearing has influence on the foot shapes of youth track man. Secondly,there is marked difference on the foot shapes between youth track man and common undergraduates.Then,Sensitive and non-sensitive indexes were discovered.Length,width of foot,height of internal malleolus,height of external malleolus,height of medial longitudinal arch,etc.varied significantly with the increasing work load.

通过对不同载荷承重下的青年田径运动员的足部外形指标的差异分析，得到以下结论：不同载荷压力对足部外形变化有一定影响：我国青年田径运动员在不同载荷下的足部外形指标与普通青年大学生存在较大差异；我国青年田径运动员的足长、足宽、内踝高、外踝高、内侧纵弓高等指标容易因载荷的不同而产生明显变化；我国青年田径运动员的足面长、足跟宽、跖趾斜宽角、自然前翘角等指标不易受到。。。

Part C: On the basis of analyzing the terms and condition to develop forfaiting in ourcountry, the author brings forward some legal advice in this part.

第三部分在对我国福费廷业务发展状况进行分析的基础上，对我国福费廷业务的发展提出了法律方面的建议。

Petri nets and process algebras are both most widely used formalisms for describing and analyzing discrete-event concurrent systems.

Petri网和进程代数作为研究离散、并发系统的有利工具，是最主要的两种工作流建模和分析方法。

When analyzing Guangzhou, Chongqing, Shanghai and Xiamen accented PHT (in abbreviation GZPTH, CQPTH, SHPTH, and XMPTH),it is essential to compare the distribution of formants across accented PTHs.

研究采用基于线性预测(linear prediction， LP)的二维-隐马尔可夫模型(2Dimentional Hidden Markov Models， 2-D HMM)方法自动提取连续语音的共振峰参数。

The Porsche Owner: But it's my car!

可，这是我的车呀。

LOX_83}{Oh, another bunch of wackos.

{LOX_83}{呃，又一群怪人。