查询词典 amorphous

In addition, combining the Poly-gate Amorphous Implantation process, additive enhancement of Id,sat can be obtained.

此外结合多晶矽闸极非晶化离子布植制程(Poly-Gate Amorphous Implantation)，可以使饱和电流值获得加乘性的提升。

And,for the purpose of improving the positioning accuracy,an improved Amorphous algorithm is described.

并对Amorphous定位算法进行改进，以提高整个网络的定位精度。

Thermal stability is an important parameter of amorphous material, and is an inevitable subject in amorphous matter research.

热稳定性是非晶材料的重要参量，是非晶材料研究中不可回避的课题。

Ti-Si composite materials are mixed at atomic scale, and Ti-O-Si bond appears in all of the samples with different TiO2 content; the mixed oxides are mainly existed in the form of amorphous pattern, anatase appears when the TiO2 content is more than 80%, but compared with the intension of pure TiO2, it has not integrate structure. The acetic content has great influence in the specific area and crystal structure of the mixed oxides. 20TiSi has good heat stability, still possesses 11m2/g after calcined at 1100℃; calcinations on the large scale of temperature does not cause the break of Ti-O-Si bond, TiO2 is well dispersed in 20TiSi calcined at 1100℃, and it still existed in the form of amorphous.

结果表明：制得的Ti-Si复合氧化物具有很高的比表面积，在TiO_2含量为10％时达到681.5m~2／g，Ti原子进入Si-O四面体结构中，形成Si-O-Ti键，复合氧化物的稳定性好，当TiO_2含量低于60 wt％时，以无定型形式存在；当含量为80％时，出现锐钛矿型TiO_2，但与纯TiO_2相比晶型不完整：醋酸对Ti-Si复合氧化物的比表面积、晶型都有很大的影响；TiO_2含量为20％的20TiSi经1100℃高温焙烧后，仍有较高的比表面积(11m~2／g)，稳定性好，在较宽的温度范围内焙烧，没有引起Ti-O-Si键的断裂，分散度高，没有出现晶型TiO_2。

Cu6Zr5, the basic cluster of the primary devitrification phase of Cu-based amorphous alloys, is selected as cluster model based the on structure heredity existing between amorphous alloys and primary devitrification phases.

根据非晶与其晶化相存在结构遗传关系，以Cu-Zr基非晶晶化相Cu10Zr7中的Cu6Zr5阿基米德反棱柱为团簇模型，利用离散变分方法从电子层次研究了Al元素对Cu基非晶合金团簇稳定性的影响。

In order to reach the purpose of using pre-laser cladding method preparation of Ni-based amorphous alloy coatings on 45 steel substrate surface by the method was carried out. The principles of the three clusters and the amorphous line of the law of composition rules were used. The Ni59.35Nb34.45Sn6.2 alloying powder which has a great glass-forming ability in conventional preparation methods of amorphous alloys was chosen. In the protection of atmosphere, the amorphous surface coating was prepared. The microstructure, micro-hardness and performance of the different output power of the laser cladding were analyzed.

中文摘要：为了达到研究预置激光熔覆可以在45钢上制备Ni基非晶合金涂层的目的，采用非晶形成能力三判据原则及非晶成分团簇线定律法则，选择了采用常规非晶合金制备方法中具有极大玻璃形成能力的Ni59.35Nb34.45Sn6.2合金粉末，在保护气氛下，制备非晶涂层，并对不同输出功率下得到的涂层进行微观组织和结构表征及性能测试。

According to the physical aging behavior of rapidly quenched atactic polystyrene , it was found that dual amorphous phases with quite different properties were formed due to the internal stress: free amorphous phase and constrained amorphous phase.

通过研究快速淬冷无规聚苯乙烯的物理老化行为发现，在此试样中由于内应力的存在而形成了两种性质大为不同的非晶区：自由非晶区和受限非晶区。

The catalytic performance of all the amorphous alloy catalysts mentioned above was measured during liquid phase hydrogenation of furfural to furfuryl alcohol, together with the kinetic studies. The relationship between the catalyst performance and the structure of catalyst, surface electronic state of the amorphous alloy has been systematically studied based on a series of characterization of catalysts . Meanwhile, the promoting effects of the support on the thermal stability and catalytic activity of the amorphous alloy catalysts have been discussed.

本文采用一系列的表征方法(XRD、XPS、TEM、BET、氢吸附、TPD等)进一步研究非晶态合金催化剂的表面结构、表面电子态和催化性能之间的关系，探索电子效应和几何效应对催化剂活性中心结构的影响，探索非晶态合金的晶化失活和载体对非晶态结构的稳定化作用，以及修饰剂对催化性能的改善作用等。

It is found that the structure of the ternary electroless Ni-W-P coating is greatly influenced by W content in the deposit. It is also found that the requisite content of phosphorus for amorphous Ni-W-P structure is less than that of Ni-P binary alloy coating, and the more tungsten exists, the less phosphorus is required. The hardness of the deposits will be enhanced as the deposit structures are changed from amorphous to mix-or nanocrystalline structures. The corrosion resistance of Ni-W-P ternary alloy is improved as W content increased, and the passivation of amorphous deposits is formed more easily than that of mix-structure and nanocrystalline deposits.

研究发现，化学镀Ni-W-P三元合金镀层的结构受镀层中钨含量的影响较大，非晶态Ni-W-P三元合金镀层所需磷含量较非晶态Ni-P二元镀层所需磷含量要低，并且钨含量越高，所需磷含量越少；镀层硬度随镀层结构从非晶态→混晶态→纳米晶态转变而增加；镀层的耐蚀性随镀层中钨含量增加而变好，且非晶态镀层较混晶态和纳米晶态镀层更易形成钝化区。

The composite membranes with different ratio of Al〓O〓 to SiO〓 are composed of amorphous matter or amorphous matter and γ-Al〓O〓 when sintered at 600℃. The composite membrane with mullite composition go thrsought the following phase transition as the temperature rising from 200℃ to 1100℃: amorphous matter and boehmite (200℃)→amorphous matter and γ-Al〓O〓(4001000℃)→mullite and α-Al〓O〓.

经热处理后不同化学组成的复合陶瓷膜由无定形态或者无定形态和γ-Al〓O〓组成，具有莫来石化学成分的复合膜随着烧结温度的升高，其组成分别为无定形态和勃姆石（200℃）、无定形态和γ-Al〓O〓（400-1000℃），并在1100℃时析出莫来石和α-Al〓O〓。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。