查询词典 ambiguous point

Sb can combine with Cu and P to form a low melting point compound which lowers the melting point of binary Cu-8P eutectic alloy by nearly 200℃. Bi and Cu can create compounds with low melting point(270℃) distributing at the boundaries and that is the reason why the melting point of (Cu-8P)-Bi is lower than that of binary Cu-8P eutectic alloy. The eutectic cluster can be refined with the addition of Fe, and that is the reason why the addition of Fe can decrease the melting point of Cu-8P alloy. Two means of decreasing the melting point of Cu-8P are found.

一定量的Sb与Cu， P形成低熔点相，从而大幅降低了Cu-8P合金的熔点，使其熔点降低近200℃；加入少量Bi后， Bi与Cu在共晶团晶界上形成熔点为270℃左右的低熔点化合物，且Bi的加入明显细化Cu-8P合金共晶团，从而使Cu-8P合金的熔点降低；加入Fe能明显细化Cu-8P合金的共晶团，使层片间距由8μm减为2μm以下，并使共晶团由层片状向短棒状转变，虽然Fe与Cu形成熔点为806℃的高温相，但Fe的细化作用使得Cu-8P合金的熔点降低，但降低幅度不大。

For a continuous map of trees or graphs to itself, we show the properties that every isolated chain recurrent point is an eventually periodic point, and an isolated chain recurrent point which is not in the orbit of a critical point and has no critical point in its orbit is a periodic point.

第三章主要讨论一些特殊连续统上连续自映射的孤立链回归点与最终周期点之间的关系，证明了对树或图上连续自映射，孤立链回归点是最终周期的，且如孤立链回归点不在临界点的轨道中，也无临界点在其轨道中，则此点必为周期的。

Resistance to Earth magic by an amount equal to your skill in Earth and lasts one hour per point of skill. 1 point resistance per point of skill 2 points resistance per point of skill 3 points resistance per point of skill 4 points resistance per point of skill P

每提高一个土魔法等级可以增加1点防御值每提高一个土魔法等级可以增加2点防御值每提高一个土魔法等级可以增加3点防御值每提高一个土魔法等级可以增加4点防御值 P

Results show that floes' VC and D at the surface water were closely related to current velocity; and the peaks of VC lag those of the current velocity. The lag variation during ebb and flood tides is 10-30min and 30-50 min, respectively. Current velocity at 50 cm/s is a turning point of D vs. vertical average current velocity, before the point, Dm increases with current velocity, and decreases after the point. Similarly, VC at 75μl/L becomes a critical point in the surface water, below the point, D increases with VC, and above the point, D stabilizes.Δp is D dependent, larger floes have much lower Δp than smaller floes. Both D and Δp of floes affect ω. In the surface water during spring tide and neap tide, a power exponent relationship exists between Δp and D, and ω and D.

研究表明：①长江口徐六泾表层絮凝体体积浓度主要受水流流速影响，再悬浮现象明显，体积浓度过程线滞后流速过程线，落潮期间滞后10-30min，涨潮则滞后30-50min；②小于一定流速时絮凝体平均粒径随流速增大而增大，大于一定流速时絮凝体平均粒径则随流速增大而减小，徐六泾夫、小潮表层絮凝体在50cm/s的垂线平均流速时出现平均粒径与垂线平均流速关系的转折；③徐六注大、小潮表层絮凝体平均粒径在体积浓度75μl/L时出现平均粒径与体积浓度关系的转折，体积浓度小于75μl/L时粒径随体积浓度增加而增大，超过75μl/L时粒径随体积浓度的增加变化不明显；④絮凝体有效密度由粒径大小控制，粒径大，有效密度小，反之亦然，粒径和有效密度共同决定絮凝体静水沉速，有效密度和沉速与平均粒径之间均存在良好的幂指数关系。

The critical point means such a state that all the differences between gas and liquid disappear completely,being a most important parameter of dividing the types of fluid and being widely verified in both theory and practice.Currently,four methods of determining critical point are summarized as follows:①laboratory measurement through examining critical opalescence or recording the bubble point and dew point curves;②empiric relation;③calculation of the bubble point and dew point curves by PVT software;and ④ direct calculation according to thermodynamic theories.

随后对临界点进行确定，临界点是气液一切性质差异均消失的状态，是区分流体类型最重要的参数，并得到了理论和工程应用的广泛验证，目前确定临界点大致有四种方法：①实验测定，通过观察临界乳光现象或记录流体的泡点和露点线；②经验关系式；③通过PVT软件计算流体的泡点和露点线；④利用热力学理论直接计算。

Distance from the origin point to O point was (1.84±0.69)cm,unharmful separation point to O point was (0.05±0.12)cm,muscle entry point to O point was (4.35±0.12)cm.

结果 桡神经旋后肌支数为2.6±0.52，其自然分支处距O点(1.84±0.69)cm，干支分离后分支距O点(0.05±0.12)cm，入肌点距O点(4.35±0.12)cm。

On the basis of distributive shapes of point collection on the Poincare section, define three indexes to quantitatively describe the distribution of point collection. Which are distance between two adjacent points, diffused angle and distance between every point and center point of point collection.

以庞卡莱截面上RR间期序列的点集分布形式为基础，提出点集中相邻点间距离、扩散角度和点到点集中心距离三项指标，用以定量地衡量点集的分布形式。

Firstly, according to this character, primacy central point is detected by the exploring extremum method in the windows of 3×3 pixels. Then, basing on this central point, approximate normal line at ±45°、0°and 90°angle are drew.if the minimums of normal line is at central point and the difference between the minimums and the maximum in the normal line is more than the threshold, this point is considered to the edge point of image.

首先，在3×3象素的窗口中，如果中心值为最小值，则以该点为基础，以±45°、0°和90°方向作为近似法线带，然后判断该法线上的象素最小值是否在切点上（即是否在法线的中心点上），再通过检验切点与轮廓法线上亮度极大值的差值是否超过阈值，来判断切点是否为边缘轮廓上的点。

While it is usually impractical for the marshallate to measure blade weight directly by weighing the sword before the basket hilt, cross, or pommel weight is attached, the linear density of the blade (its weight divided by its length) can be estimated fairly easily by weighing the finished sword, locating the point on the blade at which it balances, and measuring the distance from the point of balance to the tip, from the point of balance to the hilt, and from the point of balance to the point where the additional weight (the basket hilt, cross, or cross plus pommel weight) is attached to the blade.

而这通常是不切实际的为marshallate来衡量的刀身Weight直接由称重剑前一篮子的Hilt ，交叉，或pommel重量是重视，线性密度的刀片可估计相当容易称重成品剑，定位点的叶片在它的结余，以及测量距离平衡点，以尖端性，从平衡点到极限和从平衡点以点的额外重量（篮子的Hilt ，交叉，或跨加pommel重量）是连接到刀片。

Subline matching method based on binary system small wave transform is proposed, which expliots the character that the model maximum point of spline binary small wave transform coefficient at different scales can provide position information of signal's fast changing point. The matching scheme from thick to thin for point matching is adapted. Then, the point to point matching is calculated with the sequence consistent principle in each subline.

设计基于二进小波变换的子线段匹配方法，通过求解样条二进小波变换系数在不同尺度下的模极大点确定不同尺度下信号急速变化点位置，采用由粗到细的匹配策略匹配端点，再对端点之间的每一个子线段采用顺序一致的原则，进行点对点匹配。

But this is impossible, as long as it is engaging in a market economy, there are risks in any operation.

但是，这是不可能的，只要是搞市场经济，是有风险的任何行动。

We're on the same wavelength.

我们是同道中人。