查询词典 along

Room cooling loads increase along with buliding area increasing, and ventilation efficiency minishes along with buliding area increasing.

2工作区冷负荷随建筑面积的增大而增大，且房间通风效率随房间高度的增加而降低。

Bending angle about material augments along with laser power and laser light spot diameter augment, but bending angle about material minishes along with laser scan rate and material hardness augment.

随着激光功率和激光光斑直径的增加板材弯曲角度增大，但随着激光扫描速度和板材厚度的增加弯曲角度减小。

The rules of fluid rate with different technical parameters: the increase of electromagnetic force causes the increases of the fluid rates at S/L interface and free surface, the decrease of skin depth, the increase of electric current density which will make the fluid at free surface flowing faster, while it doesnt affect the fluid rate at S/L interface. When the height of melt increases, the both of fluid rates will increase too. The increase of the width-thickness ratio augments the fluid rates along the wider edges at S/L interface evidently, while the rates along the narrow edges will have little change, and the rate at free surface has little change too. The increase of overheat degree minishes the range of mush zone, while the fluid rates at S/L interface and free surface will increase evidently.

流速的大小随各种不同工艺因素的变化呈现出一定的变化规律：随电磁力的增大，固液界面以及自由表面处的流速都会增大；集肤层渗入深度变薄，电流密度增大，会导致自由表面上流动的加强，但对固液界面处的流动速度影响不大；熔区高度的增加，也会使固液界面及自由表面处的流动增强；宽厚比增大时，固液界面上沿宽面方向的流动显著增强，但窄面方向流速变化不大，同时自由表面上流速变化也较小；过热度及温度梯度的增大，使糊状区减小，导致固液界面及自由表面处的流速显著增大。

The shear stress at some point and along arbitrary direction of the wringed pole just equals to the slope at the counterpoint and along perpendicular direction of the membrane.

扭杆横截面上某一点处的，沿任意方向的剪应力，就等于该薄膜在对应点处的，沿垂直方向的斜率。

Research result shows that pH changes rate when worthing between 4.0-5.5, along with the increase of pH value and selectivity also along with increase.

研究结果显示， pH值在4.0-5.5之间时，随着pH值的增大，转化率和选择性也随着增大。

Of the five stages deformation, the exact ages of the (2) and (3) were determined by 40Ar/39Ar method as 290 and 259 Ma respectively.2. New results on the metamorphic belts and associated metamorphism of the Xiaopu metamorphic rocksBased on detailed microtextural observations and occurrence of typical metamorphic minerals, five metamorphic belts in the Xiaopu metamorphic rocks are identified. From the north to the south, they are biotite belt, garnet belt, staurolite belt, andalusite belt, and sillimanite belt. I suggested that the metamorphic belts occurred in the Xiaopu area belongs to the high temperature/low pressure series, may have resulted from the later Permian crust extension at ca. 290 Ma.3. I suggest that there may have been a Carboniferous backarc basin along the southern slope of the Harlik Mountain.Detrital Zircon SHRIMP U-Pb dating indicated that the sedimentary age of the Julideneng formation lithic sandstone must be later than late Devonian, most likely is Carboniferous rather than previously thought Precambrian. Analyses on its geologic setting, location of provenance, and sedimentary environment suggest the Carboniferous strata may form in a lagged backarc basin bounded by backarc uplifts.5. Reconstruction of the post-Paleozoic tectonic evolution history of the Harlik MountainThe tectonic evolution of Harlik mountains since the Paleozoic were reconstructed as followings:(1) arc-affinity magmative activities occurred during the middle-Ordovician to early-Silurian;(2) the middle-Silurian to late-Devonian was a back-arc uplift stage;(3) back-arc extension featured the Carboniferous period;(4) post-collisional extension and/then compression during Permian;(5) at the Mesozoic, differential uplift developed; and (6) the late Cenozoic is the intra-continental re-orogen stage.6. Primary estimation of the crust shortening is madeThe folded pre-Mesozoic strata were used to estimate crust shortening along the Harliknanshankou-Koumenzi, Shichengzi-Baishitou, and Qincheng-Xiaopu sections. Their shortening ratios are 16.2%, 19.8%, and 20.1% respectively corresponding crust shortening are 4.3, 9, and 11.3 km.

根据Ar-Ar热年代学研究，精确测定了早二叠世伸展变形和晚二叠世挤压变形的峰期时代分别为290Ma和259Ma.2、提出了关于哈尔里克山南麓小铺一带变质带和变质作用的新认识根据显微观察资料和特征变质矿物的出现，把小铺一带的变质岩由SW向NE方向依次划分为黑云母带、石榴石带、十字石带、红柱石带和矽线石带等变质带；初步确定该区的变质作用属于中温-低压型，变质作用发生的时代为290Ma左右，是该区早二叠世地壳伸展的产物。3、首次提出哈尔里克山南麓在石炭纪可能发育弧后盆地的新观点根据哈尔里克山南麓原&居里得能组&岩屑砂岩的碎屑锆石SHRIMP U-Pb定年，确认这套地层的沉积不早于晚泥盆世，很可能是石炭纪，而不是前人所说的前寒武纪；结合对其区域地质背景、源区位置和沉积环境分析，推测该区石炭纪可能为滞后弧后盆地和弧后隆起区构造背景。4、进一步证明哈尔里克山不发育与岛弧演化相关的泥盆纪岩浆活动根据对代表性闪长岩和花岗岩的锆石SHRIMP年代学研究获得的新资料，结合该区已有相关资料的综合研究，确定哈尔里克山岩浆岩分别形成于奥陶纪-志留纪和石炭纪晚期-二叠纪，不存在泥盆纪的岩浆岩，进而认为该区泥盆纪不属于岛弧环境。5、重建了哈尔里克山古生代以来的地质演化过程根据区域资料以及本次研究所获得的资料，把哈尔里克山古生代以来的构造演化划分中奥陶世-早志留世为岛弧、中志留世-晚泥盆世为弧后区、石炭纪弧后伸展、二叠纪为后碰撞伸展与挤压、中生代差异隆升和晚新生代陆内再造山过程等构造阶段。6、初步估算了哈尔里克山地壳缩短率和缩短量根据前中生代地层褶皱估算的哈尔里克山南山口-口门子、石城子-白石头和沁城-小铺三条剖面的地壳缩短率分别为16.2%、19.8%和20.1%，相应的地壳缩短量分别为4.3km、9km和11.3km。

Thus in the dawn of time, river civilizationsflourished in the old world: Chinese civilization along the Yellow River; pre-Indian along the Indus; Sumerian, Babylonian and Assyrian on the Euphrates and the Tigrist Egyptian on the Nile.

在人类历史萌芽的古代世界，河流文明繁荣发展，譬如黄河流域的中华文明，印度河流域的古印度文明，幼发拉底河和底格里斯两河流域的苏美尔、巴比伦及亚述文明，尼罗河流域的古埃及文明。

Please cut along the dotted line and send your Participation Form ONLY on or before 4 March, 2005 by fax (2731-6363) or post. Please be reminded to bring along the Sponsorship Form on the Walkathon Day.

参加者请於2005年3月4日或之前，填妥报名表并沿虚线剪下，把报名表部分传真至2731-6363，或以简便回邮寄回本处；填妥之赞助表格则需於活动当日出示盖印。

Please cut along the dotted line and send your Participation Form ONLY on or before 4 March, 2005 by fax (2731-6363) or post. Please be reminded to bring along your Sponsorship Form on the Walkathon Day.

参加者请於2005年3月4日或之前，填妥报名表并沿虚线剪下，把报名表部分传真至2731-6363，或以简便回邮寄回本处；填妥之赞助表格则需於活动当日出示盖印。

Along the Victoria Embankment and across Westminster Bridge, or along the South Bank, or even out into Docklands.

劝你等到暮色降临后，再踏上一程&鬼魂之旅&——或是那令人毛孔悚然的&开膛手杰克之旅&。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐