查询词典 alloys

The effect of the formation enthalpies on disproportionation reaction of the alloys at high temperature hydrogenation is discussed and it is found that the greater the entropies of alloys are, the more favorable it is for the disproportionation reaction.

讨论了生成焓对高温氢化时合金发生歧化反应的影响，合金的生成焓愈大，对歧化反应愈有利。

The study of Magnesium alloys have taken more and more attention, especially the strengthen and elongate of Mg alloys.

镁合金材料的研究是当前人们关注的热点，特别是镁合金的强韧化问题。

It analyses the changeable TiO_2 content in chrome ore and the structural form,the balance of Ti,the reaction mechanism of Ti and its existence form in alloys,the affect factor of Ti content in alloys,and benefits and control methods during the process of smelting low titanium high carbon ferrochrome .

分析了低钛高碳铬铁生产过程中铬矿TiO_2含量变化与结构形式，冶炼过程中Ti的平衡、反应机理和在合金中的存在形式，合金含Ti量高低的影响因素，以及效益与控制方法。

The microstructure of ferromagnetics for Fe-Al alloys as well as the effects of alloy elements and heat treatment on the damping behavior and mechanical properties of Fe-Al based alloys have been investigated systematically by means of optical microscopy,scanning electron microscopy.

采用光学显微和扫描电子显微观察等方法，系统地研究了Fe-Al系铁磁性阻尼合金的微观组织，考察了合金元素、热处理工艺对合金阻尼性能和力学性能的影响，探讨了Fe-Al合金产生高阻尼特性的微观机制以及Fe-Al系高阻尼合金的同质和异质焊接性能。

A white, crystalline, brittle, highly diamagnetic metallic element used in alloys to form sharp castings for objects sensitive to high temperatures and in various low-melting alloys for fire-safety devices.

铋：白色、晶状、易碎、高度抗磁的金属元素，用于高温敏感物体的合金中，以铸成锋利物件，多种用于防火安全设施的低熔点合金。

Model XHR-150 is used to for hardness test of plastics, hard rubbers, fricative materials, synthetic resins, Al-alloys, Sn-alloys hard papers.

产品用途： XHR-150型塑料洛氏硬度计适用于塑料、硬橡胶、摩擦材料、合成树脂、铝锡合金、硬纸板等材料的硬度测定。

Model OE-XHR-150 is used to for hardness test of plastics, hard rubbers, fricative materials, synthetic resins, Al-alloys, Sn-alloys hard papers.

产品用途： OE-XHR-150型塑料洛氏硬度计适用于塑料、硬橡胶、摩擦材料、合成树脂、铝锡合金、硬纸板等材料的硬度测定。

Up to now, there is not so much information aboutthe basic aspects of fusible alloys, so it is quite necessary to investigate the design,phase diagram, properties of these alloys.

但目前对易熔合金的基础理论、成型工艺等方面，尚缺乏系统的研究。

Conglomeration microstructures in the alloys appear, W particles were sintered between each other mainly by way of solid sintering in the conglomerations, and liquid sintering between conglomeration and con- glomeration. Microstructure of sintered alloys is compact and homogeneous.

结果表明，机械活化能增大钨铜粉末的表面能和晶格畸变能，有效地促进烧结，改善烧结组织；烧结体中存在大量团絮状组织，团粒内部钨颗粒主要以固相方式烧结在一起，而团粒之间则以液相烧结为主。

Investigation was made of the sputtering rate in glow discharge lamp with re-lation to constituent of 25 different specimens of 6 binary systems, namely, Cr-Fe, Bi-Sb,Cu-Zn, Ag-Cu, Al-Zn and Cd-Sn, by measuring mass loss after each sputtering under con-stant Ar pressure and voltage applied. The correlation, in general, between sputtering rate andconcentration of constituent of these non-intermetallic binary alloys obeys the hyperbolic lawunder steady state, yet may be approximately regarded as linear only on certain special condi-tion if the two components of the alloys with similar sputtering rates.

在恒定气压和电压条件下，用测量溅射减量的方法，系统研究了Cr—Fe，Bi-Sb，Cu—Zn，Ag—Cu，Al-Zn和Cd—Sn六个系统的25个试样在辉光放电灯中溅射率与组分的关系结果表明；阴极溅射在稳态时，二元合金的溅射率与组元浓度的普遍关系是双曲线，只有在某些特殊情况下，两组元的溅射率相差不大时，可以近似看成线性关系。

As of Tuesday, Google's results were still censored in China.

截至周二，谷歌的搜索结果仍受中国审查。

In order to make the positive action increase and negative one decrease, the sub-forces of the social factors must be adjusted to form a centripetal force.

在这一过程中，人的主体性发挥是社会有机体健康发展的灵魂。