查询词典 alloy

Alloy of polyethylene of element of the methodological freeboard that make, titanium and sample of alloy of cobaltic chromic molybdenum, FITC of classics of cuticular grape coccus labels, the cuticular grape coccus that after sample of artificial and articulatory material is disinfected, vaccinal FITC labels, sample surface cent is slick surface and rough surface, every groups each 6 sample, brood the 24 orifice plate that contain bacterium and sample below 37 ℃ after Yo 30min, with fluorescent microscope observation, sample uses observation of scanning report lens.

方法制作超高分子聚乙烯、钛合金和钴铬钼合金试样，表皮葡萄球菌经FITC标记，人工关节材料试样消毒后接种FITC标记的表皮葡萄球菌，试样表面分为光滑表面和粗糙表面，每组各6个试样，将含有细菌和试样的24孔板在37℃下孵育30min后，用荧光显微镜观察，试样用扫描电镜观察。

In this thesis, it is studied that the Li2O-Al2O3-SiO2 system glass ceramics of high expansion which can be a match for the iron nickel alloy (485 alloy ) with 102×10-7/℃expansion coefficient, and influence of the change of every group compos...

本课题研究了能和膨胀系数为102×10-7/℃的铁镍合金(485合金)匹配封接的高膨胀Li2O—AL2O3—SiO2系统微晶玻璃，研究了各组份变化对微晶玻璃性能的影响。

As the density of Al and Cu was quite difference,it was apt to delaminate and restrain the process of alloy by wet milling.The case was improved when dry milling,though it would be some reunite with the time of ball-milling prolonging.(2)The best technique parameters of high energy ball milling to prepare metastable powders of Cu-Al alloy were;the addition of Al powders was 1% in quality,the powders of Cu-Al were completely alloyed after high energy ball milling for 20 h.

1提出采用高能球磨制备Cu-Al合金粉的有效方法，认为由于Cu和Al的密度相差比较大，采用以液态酒精为过程控制剂的湿磨时，容易发生分层，抑制了合金化，采用干磨时，以硬脂酸为过程控制剂，虽然随球磨时间的延长会发生轻微的团聚，但能达到良好的合金化效果。

After the oxidative polymerization of DMP,styrene was in-situ polymerized under the initiation of dibenzoyl peroxide and dicumyl peroxide,finally thermodynamically compatible PPO/PS alloy was prepared.When styrene content was 50 wt%,for the synthesized PPO/PS alloy the yield and the weight-average molecular weight were determined to be 95%and 1.7×10~5 for PPO,93%and 2.0×10~5 for PS,respectively.The influence of the concentration of DMP and catalyst,molar ratio of N/Cu, oxygen partial pressure,NaOH concentration and temperature on the initial polymerization rate(R_0) of DMP was studied.It was found that the initial polymerization rate of DMP increased with the concentration of DMP and catalyst. The initial polymerization rate increased with the molar ratio of N/Cu at first and then decreased.

通过测定DMP氧化聚合过程中氧气吸收量随时间的变化，研究了DMP和催化剂浓度、N/Cu摩尔比、氧气分压、氢氧化钠浓度及温度对水介质中DMP氧化聚合初始速率的影响，发现DMP氧化聚合初始速率与氧气分压的0.1次方成正比；DMP氧化聚合初始速率随DMP和催化剂浓度及温度的增加而增加；随氢氧化钠浓度和N/Cu摩尔比的增加DMP氧化聚合初始速率先增加后降低。

The phase transition characteristic of non-equilibrium TiNi alloy deformed by hot forge was studied with dilatometry. It was found that there are two kinds of completely different expansion curve when the alloy samples heating and cooling.

用膨胀法考察研究了热锻变形非平衡状态TiNi合金的相变特征，结果表明：热锻变形态TiNi合金有两类截然不同的膨胀曲线，第Ⅰ类在降温时膨胀，对应B2→M相变。

In the alloy of 9/1 Ni-to-Fe ratio, the fine β phase precipitates dispersively during aging which hardens the alloy.

同时机械铆接效应也起一定的作用；合理的工艺参数可获得高结合强度的合金镀层。

Second, the Zn in the alloy is electrochemically oxidized off the alloy to create porous A surface.

第一步，在ZnCl2-EMIC离子液体中将锌电镀在金属基板上，以形成一个含锌合金镀层。

The grains of 6063 aluminum alloy made of electrolytic low-titanium aluminum alloy are small equiaxed grains too.

本文介绍一种新的添加钛的晶粒细化方法，即电解加钛法，并研究了细化效果。

Experimental results show that rapid solidification technology can remarkably optimize Mg-Zn-Nd alloy's microstructure and property,there are three zones of fine grain zone,columnar grain zone and equiaxial grain zone in ribbon's solidification structure,which reserve structure character of cast-magnesium alloy.

结果表明：快速凝固技术可显著优化Mg-Zn-Nd合金的组织结构与性能；薄带的凝固组织分为细晶区、柱状晶区、等轴晶区三个区域，保留了铸态凝固组织的特性；快速凝固技术的细晶强化和固溶强化可明显改善Mg-Zn-Nd合金的强度与塑性。

The influences of Ce on the microstructure and mechanics performances of Ti-Fe-Mo-Mn-Nb-Zr alloys were studied and presented in this paper. The microstructure of no-Ce Ti-Fe-Mo-Mn-Nb-Zr alloy was thick, long and dendritic,and the microstructure of alloy was fined by Ce. With the increase in Ce wt%, the microstructure became equiaxial gradually.

研究了稀土 Ce对 Ti- Fe- Mo- Mn- Nb- Zr合金组织与力学性能影响，结果表明：不含 Ce的为粗大的长枝晶组织，加入 Ce后组织有所细化，并随 Ce量增加而逐渐等轴化，直至形成等轴晶；硬度方面随 Ce的加入有所降低；在 Ce含量较少时随 Ce的增加压缩强度也增加，但当 Ce含量增大一定量时，Ce增加降低了压缩强度。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。