查询词典 allowable value

Maximum allowable overprinter error detection range is 18 mm.

最大不准的套印不差错检测边界是18毫米。

In this paper, we analyzed the error of film thickness and refractive index caused by the optical control system, and also analysed the allowable error.

通过对光学监控系统引起的薄膜厚度和折射率的误差进行分析。提出膜系的允差分析。尽量减小由于监控设备引起的误差。

The result shows that the repeatability of the method is within the range of the allowable repeatability error.

利用ANTEK7000化学发光分析仪，采用直接进样的方式测定原油、常压渣油和减压渣油中的氮含量。

When it is impossible to eliminate tracking error completely, performance weighting function is selected to guarantee small tracking error which is allowable in project. This choice method of parameter is very simple.

在完全跟踪不可能实现的情况下，讨论性能权重函数的选取，保证了跟踪误差收敛于实际工程容许的范围内，且参数选择非常简单。

Sampling error or allowable error is conventionally accepted between 1% and 10%; however, it is suggested that sampling error should be carefully assessed in light of the nature of the derivation of the population proportion and other aspects of the initial data.

抽样误差或允许误差是接受常规的1 ％和10 ％，但是，有人建议，抽样误差应当认真评估根据的性质推导的人口比例和其他方面的初步数据。

Allowable error of pipe center...

管口中心的允许偏差？

Does an excellent job of handling "allowable" error conditions gracefully.

在优雅地处理"可允许的"错误条件方面做得很优秀。

Methods （1） Defining require for quality in the form of the "total allowable analytical error" for each test.

（1）每项试验以"允许总误差"形式确定质量要求。

The result shows that the repeatability of the method is within the range of the allowable repeatability error. The yield of recovery of standard sample is 95%~105%, and the consistency of results is better and the different of two results is less titan 84 in comparison with ASTM D 5762-95 dilution method.

阐述方法原理，考察方法的重复性在允许重复性误差范围内；标准样品的回收率在95%~105%；与ASTM D 5762-95的稀释法比较，结果一致性较好，两种结果的差值小于84个单位。

Allowable platform motion error allocation is an important part of system-wide allocation in SAR system. It is a necessary system design procedure to take into account error effects, error sources, and performance-limiting factors to determine more reasonable design.

摘要合成孔径雷达系统平台运动容差分配是系统要求分配的一个重要方面，它是系统设计中的必要步骤，通过考虑误差源、误差影响和性能极限等因素使得最终的设计方案更为合理。

The shaping method of noncircular part and the tool holder's radial motion characters in noncircular turning process are discussed in detail in the thesis.

论文详细研究了非圆零件的成型方法和加工过程中刀架的径向运动规律。

I have not really liked him,I do not like his this kind of disposition.

我没有真的喜欢他，我不喜欢他的这种性格。