查询词典 allowable error

Through the characteristic experiment to five PVC filmducts with different hole spacing,a series of design parameter was recom-mended under the allowable error(±10%)of hole discharge air volume per u-nit lengh.

通过在鸡舍环境下对五组不同孔口分布的带孔PVC风管的送风均匀性试验，推荐了在孔口气流一致性偏差允许范围内(±10％)带孔PVC风管的工程设计参数。

First, the uncertain ordered weighted averaging is used to aggregate the decision-maker's different preference information into the interval number comparison matrix. Then, the group's overall satisfaction membership function is defined based on the decision-making's allowable error. The maximal group consistency weight model is established.

采用UOWA算子将决策者的偏好信息集结为区间数互反判断矩阵和互补判断矩阵两种形式，结合决策者给出的允许偏差，定义群满意度隶属函数，建立求解群偏好一致程度最大化的权重模型。

Results: The imprecision of six diluent concentrations in duplicate was 2.68%, the best fit model was the cubic equation. The deviaton from linearity of the first concentration was 42.3%, exceeding the 5% clinical allowable error. DLs of the other concentratons were within limit.

结果：六个稀释浓度样本重复测定的不精密度为2.68%，三次多项式为最适拟合模型，第一个稀释浓度的非线性程度达到42.3%，超过5%的允许范围，为临床不可接受，其它五个稀释浓度的线性偏离均在允许范围内。

Examination found a number of major quality problems: First, part of the observed deformation and deformation measurements are not laying a solid reference point, deformation monitoring points do not comply with regulatory requirements; deformation observation, the calculation is not strictly enforce the state standards, such as the base network is not on a regular basis retest , no point will work in conjunction with the reference point for measurement, the standard of measurement stations and other allowable error overrun.

检查中发现了一些主要质量问题：一是部分变形观测与形变测量项目基准点埋设不稳固，变形监测点设置不符合规范要求；变形观测、计算未严格执行国家标准，如基准网未定期复测，未将工作基点与基准点进行联测，水准测量测站限差超限等。

Finally, allowable limit of the largest focusing error and the energy distribution of the light spot was given.

通过数值计算，分别得到了在小离焦量和大离焦量时光强沿光轴径向的分布曲线、中心光斑的大小以及在特定范围内总能量随离焦量的变化规律。

The result is evaluated using mean absolute error, maximum absolute error and minimum absolute error.

所选用的精度指标包括：绝对值平均误差、绝对值最大误差以及绝对值最小误差三种。

The dependent variables were absolute error, variable error, and error detection capability.

依变项为动作准确性、稳定度和错误侦察能力。

Through compared with the difference of the sampling inspection's OC curves between existent and nonexistent inspection error by utilizing grouping method, we get the conclusion that all the traditional methods are designed on the premise that there is none inspection error exist, so it would terribly depress the probability of acceptance and couldn't veritably reflect the quality of the lot for inspection, if the inspection error is exist when sampling inspecting.

同时通过对集团检验错误存在与否的抽样检验特征曲线的比较，指出：以往的集团抽样检验方案设计，都是在假设无检验误差前提下设计的，在抽样检验中，若存在检验错误，会严重影响抽样检验的接收概率，使抽样检验结果不能客观地反映检验批的质量。

And the temperature error could be divided into accidental error and systematic error.

其温度误差分为随机误差和系统误差两部分。

After the analytic model is set up and the error rate is derived, the system error performances of uncoded and Turbo coded DPIM are simulated and analyzed under weak turbulence channel, and the system error performances under Gaussian channel are simulated for comparison.

在建立分析模型和推导差错率的基础上，在弱湍流信道条件下仿真分析了Turbo码编码前后的系统差错性能，同时与高斯信道条件下的系统差错性能进行了比较。

The shaping method of noncircular part and the tool holder's radial motion characters in noncircular turning process are discussed in detail in the thesis.

论文详细研究了非圆零件的成型方法和加工过程中刀架的径向运动规律。

I have not really liked him,I do not like his this kind of disposition.

我没有真的喜欢他，我不喜欢他的这种性格。