查询词典 allowable error

The result shows that the repeatability of the method is within the range of the allowable repeatability error. The yield of recovery of standard sample is 95%~105%, and the consistency of results is better and the different of two results is less titan 84 in comparison with ASTM D 5762-95 dilution method.

阐述方法原理，考察方法的重复性在允许重复性误差范围内；标准样品的回收率在95%~105%；与ASTM D 5762-95的稀释法比较，结果一致性较好，两种结果的差值小于84个单位。

In the use of optical water level, due to eye fatigue, on-site allowable error index calculation and other reasons, accuracy and speed is difficult to meet our requirements, but generally require 6 people / groups: one person observation, 1 record, 2 Fu-foot, 2 lamps.

在使用光学水准仪时，由于眼睛疲劳，现场限差指标计算等原因，精度和速度很难满足我们的要求，而且一般需要6人/组：其中1人观测，1人记录，2人扶尺，2人照灯。

All kinds of the detected and analyzed has proved that the analyzer has high accuracy with the error within the allowable range compared with the result of chemical analysis method , what's more, it is so quick that it only takes just 15 min.

多种检测试验及实际分析应用证明，其检测准确度高，与化学分析法测试结果的误差值均在化学法的允许差之内；且检测速度快，从样品处理到检测结果仅需15min。

The study indicated that current and displacement stiffness are constant in the range of allowable engineering error. There is a linear range to the magnetic force. The simplified linear model meets the requirement of controller design. The more precise control precision is, the smaller linear range is.

研究表明，在工程误差允许范围内，位移刚度和电流刚度可视为定值，即此时电磁力方程在应用上存在较大的线性区间，因此简化的线性化模型完全可满足控制器设计的需要，且线性区间随着控制精度提高而减小。

The system breakdown voltage measurement and signal output two most voltage measurement part in the main circuit simulation, tie amplifier module, A / D conversion module, module; Sunplus microprocessor through data processing, in the range of allowable error voltage measurements show, and broadcast voice.

本系统分电压测量和信号产生输出两大部分，电压测量部分以模拟电路为主，配合放大模块、A/D转化模块、显示模块；通过凌阳单片机进行数据处理，在误差允许范围内显示测量电压值，并播报语音。

As for frame synchronizer, the recognizer of the frame pattern and its performance are analyzed in details. The probability of catching frame pattern upon one pass is deduced. Based on these, the relationship between optimum frame pattern length and the frame length , the allowable error tolerance and the channel errors, the protecting parameter α、βand the threshold level are derived. Consequently, a new type of adaptive frame synchronizer is presented.

对于帧同步器，对帧同步检出及其性能进行了详细分析，推导了帧同步一次通过捕获概率，导出了最佳帧同步码组长度与帧长之间的关系，误差门限与信道误码之间的关系，以及校核帧数α、保护帧数β与误差门限之间的关系，进而提出了一种新颖的自适应帧同步实施方案。

The test results of 20 blood samples detected on different hematological analyzers were analyzed by a q test which indicated that there were no statistical differences between blocks（P＞0.05）. The correlative coefficient was over 0.97 and the relative deviation was within the range of allowable error.

白细胞分类中，中性粒细胞和淋巴细胞在各比对仪器之间以及仪器与手工分类之间的相关性较好，而嗜酸粒细胞、嗜碱粒细胞和单核细胞，不论在各仪器还是仪器与手工分类之间，都存在较大的试验误差（P＜0.05，P＜0.01）。

This thesis proposes to use optimal method to search for the interpolation that matches with the allowable maximum range of chord error to build a curve of near field photolithographic fabrication.

同时本文提出最佳化搜寻合乎允许最大弦误差范围内之插值点方法，以建立近场光学微影加工之曲线。

This anteal analysed the the cadasteral surveying precision and evaluation by the way of analytic method and, strictly proved the formulae in relation to statistics method,and put forward the theory and method which can examine fortion of boundary point by allowable error,It is valuable in assessment of achievement quality of cadastre survey work developed extensitely at present.

文章分析了解析法地籍测量界址点精度检测与估计的实用方法，对实验统计方法中有关公式给出严密证明，提出利用允许误差对界址点进行检核的原理及方法。

First, the overall satisfaction membership function of the group decision making is defined based on the allowable error given by the decision-maker respectively. Following that, a weight model is suggested for finding the maximal degree of the group preference satisfaction. Based on the suggested model, the consistency degree of the group preference is defined. Then, an alternation approach is proposed to improve the judgment of the low consistency degree of the decision-maker.

基于决策者给出的允许偏差，定义了群决策满意度隶属函数，建立了求解群体偏好满意程度最大化的权重模型，提出了群体偏好一致性程度的衡量指标，研究了对一致性程度较差的决策者判断进行交互调整的方法。

The shaping method of noncircular part and the tool holder's radial motion characters in noncircular turning process are discussed in detail in the thesis.

论文详细研究了非圆零件的成型方法和加工过程中刀架的径向运动规律。

I have not really liked him,I do not like his this kind of disposition.

我没有真的喜欢他，我不喜欢他的这种性格。