查询词典 air pressure
- 与 air pressure 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
Density Functional Theory method was used to optimize the geometries of 209 PCDE molecules, 209 PBDE molecules and 75 PCDD molecules at the B3LYP/6-31G* level. Using computed structural parameters as theoretical descriptors, the forward stepwise multiple regression technique was adopted to obtain QSPR models of environmental partition properties for these POPs by using GQSARF 2.0 and SPSS12.0 for windows programs. The obtained QSPR models are as follows:(1) QSPR models for predicting subcooled liquid vapor pressure, n-octanol/water partition coefficients lgK_(ow and subcooled liquid water solubilities -lgS_(w,l of PCDEs, of which correlative coefficients (R~2) are 0.988, 0.958 and 0.959 and the root-mean-square-error of estimation are 0.134, 0.116 and 0.327 respectively.(2) QSPR models of lgPL and n-octanol/air partition coefficients lgK_(oa for PBDEs, which both contain three structural parameters. The values of R2 for the two models are both 0.997 while the values of RMSEE are 0.073 and 0.062 respectively.(3) QSPR models of lgKow and–lgS_ for PCDEs, which both have one variable (mean molecular polarizability,α). The values of R~2 for the two models are 0.978 and 0.866 and the values of RMSEE are 0.300 and 0.270 respectively.(4) The molecular structures of 24 substituted naphthaline compounds were optimized using Hartree-Fock and DFT methods at four different levels and the same means was used to obtain four three-parameter (EHOMO, q~+ andα) QSPR models of lgK_. The model at the HF/6-311G** level is the best one of which R2 is 0.9662 and RMSEE is 0.380.(5) QSPR study for environmental partition properties of PCDEs was also performed using position of Cl substitution method in which simple parameters of substitution position were taken as descriptors. The multiple linear regression was performed with GQSARF 2.0 and SSPS 12.0 for windows programs to obtain QSPR models of lgP_L, lgK_ and–lgS_ for PCDEs of which R~2 are 0.991, 0.983 and 0.965 and RMSEE are 0.311, 0.100 and 0.300 respectively.
采用密度泛函理论方法在B3LYP/6-31G*水平上对PCDEs、PBDEs和PCDDs的分子结构进行了全优化计算,以计算得到的量子化学参数作为理论描述符,采用GQSARF 2.0和SPSS 12.0 for windows统计程序进行正向逐步回归分析,建立了这些POPs的环境分配性质的QSPR模型:(1) PCDEs的过冷液体蒸汽压、正辛醇/水分配系数lgK_(ow和水溶解度-lgS_(w,l的QSPR模型,这3个QSPR模型的相关系数(R2)分别为0.988、0.958和0.959,估计的均方根误差分别为0.134、0.116和0.327;(2) PBDEs的lgPL和正辛醇/空气分配系数lgK_(oa的QSPR模型,这两个模型都包含三个分子结构参数,其R~2都为0.997,RSMEE分别为0.073和0.062;(3) PCDDs类化合物的lgK_和-lgS_w的QSPR模型,两个模型都只含一个变量,其R~2分别为0.978和0.866,RSMEE分别为0.300和0.270;(4)采用Hartree-Fock和DFT方法,在4种不同水平上优化计算了24个取代萘系列化合物的分子结构,采用上述同样的方法分别建立了四种水平上的三变量lgK_模型,通过比较得到,在HF/6-311G**水平计算得到的模型最好,R为0.966,RSMEE为0.380;(5)同时,采用氯原子取代位置方法对PCDEs的环境分配性质进行QSPR研究,建立了PCDEs的lgPL、lgK_和-lgS_的QSPR模型,其R~2分别为0.991、0.983和0.965,RSMEE分别为0.110、0.100和0.300。
-
Silica coating was prepared by atmospheric pressure chemical vapor deposition taking HP40 steel plate as substrate,tetraethyl orthosilicate as silica source,and air as carrier gas and diluent.
以正硅酸乙酯为硅源物质、空气为载气和稀释气,采用常压化学气相沉积法在HP40钢表面制备了SiO2涂层;采用扫描电子显微镜和能量色散能谱表征了SiO2涂层的组织结构和表面形貌;考察了在乙烯裂解的工艺条件下SiO2涂层的结焦抑制能力。
-
This research provided some laboratory evidences for elucidating molecular mechanism of the effects of high partial pressure of oxygen on immunity in signal transduction passway and the treatment and prevention of immunosuppression in air diving.
本课题为空气潜水引起免疫抑制的主要原因、防治以及为从信号转导途径揭示高分压氧影响免疫机能的分子机制奠定了一定的实验基础。
-
The history is important to the diagnosis of CICA.The key of saving life is the decompression peritoneocentesis in time.The local treatment of colorectal injury depends on routine of colorectal injury treatment.But if there are some conditions that affect the colorectal transit,the colon should be shortened properly to defecate facilely.Key words colorectal injuries compressed air abdominal pressure
病史对CICA的诊断重要;及时的腹穿减压是挽救生命的关键;压缩空气所致的大肠局部损伤可按常规处理,但如存在浆肌层广泛剥离等影响大肠传输功能时,应适当缩短结肠,使肠内容排出容易。
-
With the planeness better PS and imported the adoption of air-cushion rubber blanket, a printing plate cylinder and rubber roller pressure can be smaller, such as import Heidelberg four color press in 0.05mm to business card printing and membership card.
随着裂缝量较好的PS版和不入口气垫橡皮布的拔取,印版滚筒和橡皮滚筒之间的压辛可更小些,如不入口海德堡四色机在0.05mm即可制卡和会员卡制息。
-
Wet bulb temperature ; enthalpy ; saturated air ; atmospheric pressure ; psychrometric chart
湿球温度;焓;湿饱和空气;大气压;焓湿图
-
The measured values of Tnwb under all experimental conditions was greater than the psychrometric wet bulb temperature estimated by the ambient vapor pressure and air temperature in different combined conditions.
当热环境的气温大於皮肤温度并伴随有明显的辐射热源存在时,则风速愈大会造成自然湿球温度、黑球温度测值与综合温度热指数愈低而导致热压力评估的判断错误。
-
And the extreme centrifugal force from the enlarged higher impeller stops the solution as it entering the higher impellr. At the same time, the full solution in the chamber stops the air mixed with the solution in the chamber to go down. This way masterly eliminates both big problems of vertical sealless pump, overflow at high pressure and bubbles at big flow.
上部叶轮时,即受加大之背叶的强大阻力而无法上升,但上部叶轮所卷入液体中的空气,却受阻於水室中贮满的液体而无法下降,如此巧妙地排除了立式无轴封泵高压时溢流,或大流量时吸入空气的两大难题。
-
When pump starts, the lower impeller lifts the solution up step by step. And the extreme centrifugal force from the enlarged higher impeller stops the solution as it entering the higher impellr. At the same time, the full solution in the chamber stops the air mixed with the solution in the chamber to go down. This way masterly eliminates both big problems of vertical sealless pump, overflow at high pressure and bubbles at big flow.
塑宝SV泵剖面结构SV Super Series Analytical cross section SV泵剖面结构泵开始运转时,底部叶轮将液体逐步上推,待液体进入上部叶轮时,即受加大之背叶的强大阻力而无法上升,但上部叶轮所卷入液体中的空气,却受阻於水室中贮满的液体而无法下降,如此巧妙地排除了立式无轴封泵高压时溢流,或大流量时吸入空气的两大难题。
-
The water chamber takes the shape of tilting cube, in favor of uniform distribution of cooling water on tube plate surface. The tube bundle is divided into two groups of zygomorphy according to the bisection system and it has eight support clapboards. The siphonopore center of each clapboard increases a certain distance corresponding to that of two tube plates and the cooling tube takes the shape of arch. The two-way cooling water of bisection flows through the condenser in opposite direction so as to improve the distribution of heat load for tube bundle. Around the throat of condenser, the final stage low-pressure heater, air extraction tube, intake device of bypass exhaust and the like are deployed.
它的特点是:水室呈倾斜立方体形状,有利于冷却水流在管板面上均匀分布;由于采用对分制,管束相应地分为左、右对称的两组,并且管束设有八块支撑隔板,每块隔板的管孔中心相对于两端管板的管孔中心依次抬高一定的距离,以使冷却管呈拱形状;对分制的两路冷却水以相反方向流过凝汽器,从而改善管束的热负荷分布;在凝汽器喉部布置了末级低压加热器,抽汽管道及旁路排汽接受装置等。
- 推荐网络例句
-
This one mode pays close attention to network credence foundation of the businessman very much.
这一模式非常关注商人的网络信用基础。
-
Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.
扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。
-
There is no differences of cell proliferation vitality between labeled and unlabeled NSCs.
双标记神经干细胞的增殖、分化活力与未标记神经干细胞相比无改变。