查询词典 air pressure

At the same time, do not drop too low air temperature, because a larger temperature difference is often out of place, too vasoconstriction, but also easy to cause a sudden increase in blood pressure and other factors of instability.

同时，不要将空调温度降得过低，因为常常出入温差较大的地方，血管收缩过快，也容易突然造成血压升高等不稳定因素。

The pressure, temperature and humidity of air effect on flowrate of critical Venturi nozzles are analyzed.

此外，还对空气流经节气门的临界流量进行了定性与定量的试验研究。

Current various product lines are as follows: 3 static press Molding Line, 5 Air Impact lines, 6 Resin Sand lines, 2 Lipid Vulcanize Water Glass Sand lines, 10 Jolt-Squeeze Mechanical Molding lines, 3 Shell Molding lines with Resin Sand, 4 Sand Coated Iron Mould lines used for Ferrous Moulding, 11 investment casting lines, 5 Precision Casting of Lost Form lines, 27 Die Casting lines, 22 Gravity Casting of non-ferrous Metal lines and 16 Low Pressure Die Casting lines.

现有各种生产线构成如下：静压造型线3条，气冲生产线5条，树脂砂生产线6条，脂硬化水玻璃砂生产线2条，震压式机械造型生产线10条，壳型铸造生产线3条，黑色金属铁模覆砂生产线4条，熔模精密铸造生产线11条，消失模生产线5条，压铸生产线27条，有色金属重力铸造生产线22条，低压铸造生产线16条。

Static press Molding Line, 5 Air Impact lines, 6 Resin Sand lines, 2 Lipid Vulcanize Water Glass Sand lines, 10 Jolt-Squeeze Mechanical Molding lines, 3 Shell Molding lines with Resin Sand, 4 Sand Coated Iron Mould lines used for Ferrous Moulding, 11 investment casting lines, 5 Precision Casting of Lost Form lines, 27 Die Casting lines, 22 Gravity Casting of non-ferrous Metal lines and 16 Low Pressure Die Casting lines.

现有各种生产线构成如下：静压造型线3条，气冲生产线5条，树脂砂生产线6条，脂硬化水玻璃砂生产线2条，震压式机械造型生产线10条，壳型铸造生产线3条，黑色金属铁模覆砂生产线4条，熔模精密铸造生产线11条，消失模生产线5条，压铸生产线27条，有色金属重力铸造生产线22条，低压铸造生产线16条。

The illuminance in row of cold type wheat "Shaan 229" in row is 0.5~7.0 klx lower than that of warm type wheat "NR9405" in during milk-filling and burliness stage, the water-vapour pressure and the relative humidity are 30~l80Pa and 1%~10%higher than those of "NR9405", also the air temperature and soil temperature are higher while the upgrowth delay.

结果表明，在一定范围内，与暖型小麦"NR9405"相比，冷型小麦"陕229"灌浆结实期间的株间气温偏低0.5~2.3℃，0~0.2m土层温度偏低0.3~4.0℃，株间水汽压和相对湿度分别偏高 30~180 Pa和1%~10%，株间光照度偏小0.52~7.08 klx，且株间气温差及土壤温差随生育期推迟增大。

But, this piece of picture that uploads without party license is in while numerous website brings a hit, brought enormous pressure to this workingwoman however, face the risk that get the air even.

但是，这张未经当事人许可上传的图片在给众多网站带来点击率的同时，却给这位女工带来了巨大的压力，甚至面临被解雇的危险。

By using CFD method, it was available to get not only the distribution of pressure, velocity and eddy air, but also the aerostatic force coefficients of a box girder section.

用计算流体力学方法模拟了桥梁跨中断面周围的风场特征，不仅能得到流场的压力、速度和涡旋的分布，还提取了箱梁断面的三分力系数。

This paper analysis the feasibility of peaking spray attemperation system systematically against the problems of higher backing pressure and load limited in direct air-cooling system in summer.

本文针对直接空冷机组夏季高背压限负荷问题，系统分析了采用尖峰喷雾换热系统可行性。

Fan fan is apart from changeably, positive and negative turns, offer even air stream through all sorts of static state pressure.

风机扇子可变距、正反转，经过各类状态压力供应均和的气流。

The surface pressure-area per molecule isotherm of 0.001molL^(-1) arachidic acid chloroformic solution at the air/liquid interface of pure water has been measured, and dynamic domains morphology of AA monolayer has been investigated via Brewster angle microscopy.

测定了花生酸的氯仿溶液在二次蒸馏水气／夜界面的单分子膜的表面张力与单分子面积的等温线，用布儒斯特角显微镜原位监测了花生酸分子成膜过程中单分子膜区域形貌的动态变化。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。