查询词典 air pressure

It is embodied concretely:(1) With the adoption of grouting bolts, the cranny in wall rocks can be blocked up, the air can be isolated, the wall rocks can be prevented to be weatherized and make water, the strength of wall rocks can also be avoided to be lowered;(2) The lax broken wall rocks are commentated to a whole by liquid after they were grouted and the rock"s strength is increased, so the wall rocks become a part of the support structure by using itself and become a whole with the original rock, and the roadway is made to keep stable but not easy to be broken;(3) The spray layer wall are filled with liquid after grouting, the stress is avoided to be concentrated because the load could be evenly acted on the spray layer and the support;(4) The pressure acted on the plank can be delivered to the two sidepieces and then to the bottom by reinforcing the sidepiece; At the same time, the concentration degree of loads acted on the motherboard can be weaken because of the enlargement of the combination arch"s thickness, as result, the rock"s stress is lowered and the heaving is alleviated;(5) The common bolt is made to be fixed the whole length after grouting, the layers are connected to a integral whole and bear the weight of loads, so the support structure"s unity is increased.

具体体现在：(1)采用注浆锚杆注浆，可以利用浆液封堵围岩裂隙，隔绝空气，防止围岩风化，且能防止淋水和渗水，避免围岩被水浸湿而降低围岩的本身强度及造成的巷道变形。(2)注浆后浆液将松散破碎的围岩胶结成整体，提高了岩体强度，实现利用围岩本身作为支护结构的一部分，且与原岩形成一个整体，使巷道保持稳定而不易产生破坏；(3)注浆后使得喷层壁后充填密实，保证荷载能均匀地作用在喷层和支护上，避免出现应力集中点而首先破坏；(4)注浆后使作用在顶板上的压力能有效地传递到两帮，通过对帮的加固，又能把荷载传递到底板；同时由于组合拱厚度的加大，这样又能减小作用在底板上的荷载集中度，从而减小底板岩石中的应力，减轻底臌；(5)注浆加固后能使普通端锚锚杆实现全长锚固，它们共同将多层组合拱连成一体，共同承载，提高了支护结构的整体性。

The equipment, CENTAC model C66MX2 centrifugal air compressor package, with the capacity of 132m3/min., 2.2Bar discharge pressure unit, are complete package compressors, only single storey buildings are required.

这台设备：CENTAC型号C66MX2 离心式空气压缩机，流量132Nm3/min，排气压力为2.2Bar，是仅需单层布置的组装式压缩机组。

No. 26-Ⅰ is operated, and so the pressure signal which is put out only when the engine telegraph order is consistent with the position of the air distributor actuates the single-acting cylinder pos.

因此，阀26-Ⅳ机械连接到换向气缸26-Ⅰ工作，上位，如此压力信号被放出，只有当主机车令与空气分配器动作在单作用信号气缸17和三通阀29位置一致时。

Through lots of tests, the new technology of preparing the polymeric ferric aluminum silicate sulfate by using the waste-acid of Ti02-industriy and the coal fly ash has been designed. The highest Al-acid stripping rate can be achieved by the waste sulfate acid under boiling degree for 1. 5h when the mass ratio between NaCl and Coal Fly ash is 0. 05:1, as well as that between Coal Fly ash and Waste Acid ratio is 1:10. By means of the oxidation-polymerized reaction under 40-50*C and normal pressure, using NaNCkas catalyst and air as oxidation, the polymeric ferric aluminum sulfate can be obtained. The poly-silicic acid is polymerized with soluble glass in the optimum conditions of pH=5-6 and the concentration of Si02 is about 3%. The inorganic high molecule coagulant of PFASS is synthesized with the poly-silicic acid into the solution of polymeric ferric aluminum sulfate.

本论文通过大量的试验，研究开发出了用粉煤灰及钛白废酸制取聚合硫酸硅酸铁铝的新工艺，其最佳工艺条件为：于沸点温度，以NaCl为助溶剂(NaCl与粉煤灰质量比为0.05：1)，以钛白废酸浸取粉煤灰(固液比为1：10)中的铝1.5小时，最大浸取率可达40％；经过滤洗涤后，调节滤液pH至2.0左右，以NANO_2为催化剂(NaNO_2用量为滤液中FeSO_4·7H_2O量的3％)，空气为氧化剂，于40-50℃进行常压催化氧化反应，制取聚合硫酸铁铝，催化氧化时间为2小时；将工业水玻璃稀释至3％左右，调节其pH于5-6，室温下制备活性聚硅酸；将活性聚硅酸与聚合硫酸铁铝按照一定比例复合，经熟化，即制得新型无机高分子混凝剂PFASS。

Sound is a pressure wave in the air.

声音是在空气中传播的压力波。

Abrasive jet machining is a kind of special machining method in which gaseity-solid mixture is formed by mingling high-pressure air or other gas with abrasives. Applied by specially-designed nozzle, these particles impact and erode workpiece so as to remove materials.

磨料喷射加工是利用微细磨料与高压气体混合形成的高速气-固两相流，通过专门设计的喷嘴射向工件，依靠磨料的高速冲击和冲刷作用而实现去除工件表面材料的一种加工方法。

The sprue column gives a head pressure to squash the air pockets at the ends of the blades.

该浇道栏给出了头部的压力，壁球空气的口袋，在两端的叶片。

When you squeeze the bottle, the pressure inside it increases. That forces some water into the eyedropper, which decreases the volume of the air.

当你挤压瓶子时，瓶内的压力增加，迫使一些水流入滴管，因此减少了空气的体积。

The problem is mainly caused by primary air pipe resistance property variation,which caused the excessive opening of movable blades,the primary fan is working on the condition of higher wind pressure and lower flow.The approaches to reduce the speed stalling of primary fan and preventive measures are put forwa...

主要原因为一次风管阻力特性的变化，使一次风机动叶开度过大，一次风机工作点处在高风压区低流量的工况点，是造成一次风机失速的主要原因，提出了运行中减少一次风机失速机率的处理方法及预防措施。

Regarding the frequent occurrence of speed stalling of boiler axial flow primary fan in the operation of 600 mw unit in china,the cause of speed stalling was analyzed based on the actual measured data.the problem is mainly caused by primary air pipe resistance property variation,which caused the excessive opening of movable blades,the primary fan is working on the condition of higher wind pressure and lower flow.the approaches to reduce the speed stalling of primary fan and preventive measures are put forwa...

针对目前国内600 mw大容量机组锅炉轴流式一次风机运行中失速事故频繁发生的问题，在了解造成轴流式一次风机失速原理的基础上，根据实测数据对一次风机失速原因进行分析。主要原因为一次风管阻力特性的变化，使一次风机动叶开度过大，一次风机工作点处在高风压区低流量的工况点，是造成一次风机失速的主要原因，提出了运行中减少一次风机失速机率的处理方法及预防措施。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。