查询词典 air bag

Block bottom paper shopping bag line tube making machine equipment, We are top paper bag machinery, paper sack equipment, paper bag production line maker in China since 1998, our aim is to make good quality machinery at best price, our machinery integrates world latest technology and enjoys cheap cost of labor and natural source.

座底纸袋线管，使机器设备，我们是最优秀的纸袋，机械，造纸布包设备，纸袋生产线的制造商，在中国，自1998年以来，我们的目的是要取得良好的质量机械上的最佳价格，我们的机器整合了世界最新技术并得到廉价的劳动力成本和天然来源。

Designed to be used as a liner bag inside another sleeping bag to add additional warmth, the PrimaLiner can also be used as an ultra-light stand-alone sleeping bag.

设计的用途是可以作为另一个睡袋的内胆以增加温暖度，同时还能单独作为一个超轻的睡袋独立使用。

Relieves mammary gland pain during the period of the beginning of mastitis gets up , a hot-water bag is put in getting along in part pain, in every day 2 is inferior, every time 20 minutes , energy promoting blood circulation and removing blood stasis; The vein infuses fluid into unobstructed , using hot-water bag hot pack, to be OK smoothing; Long range buttock intramuscular injection penicillin and injectable solution, intramuscular injection part exchanges the rigid knot and partner pain red and swollen, use hot-water bag hot pack affected part , can urge drug-dip to admit, take precautions against or remove the tough packing.

缓解乳腺疼痛在乳腺炎初起时，把热水袋放在局部疼痛处，每天2次，每次20分钟，能活血化瘀；静脉输液不通畅，用热水袋热敷，即可通畅；长期臀部肌肉注射青霉素和针剂，肌肉注射局部易生硬结并伴疼痛红肿，用热水袋热敷患处，能促使药液吸收，预防或消除硬结块。

In recent years, bag filter material filter media and dust control automation to improve the performance and structure optimization, the bag filter technology to ensure the development of a large dry process cement kiln flue gas treatment using bag filter There is a growing trend.

近年来，袋式除尘器滤料材质的提高和清灰控制自动化与结构性能的优化，为袋式除尘器的发展提供了技术保证，大型干法水泥窑窑尾烟气处理采用袋式除尘器已渐成趋势。

Based on dynamic load calculation and the cooling and heating characteristic curve of the practical air/water heat pump residential central air conditioning, this paper calculates hiemal and aestival electric consumption and seasonal efficiency of air/water heat pump residential central air conditioning, and compares its economy with that of separate type room air conditioner .

在动态负荷计算的基础上，按实际运行的空气/水型户式空调机组的制热与制冷特性曲线，计算了该种户式中央空调系统冬夏季耗电量与季节效率HSPF及SEER，并在此基础上与采用分体式空调器方案作了经济性比较。结果表明，在具有典型夏热冬冷气候特点的湖南衡阳地区，住宅建筑空调采用空气/水热泵型户式中央空调系统是可行的

In the end author points out that air-to-water heat pump is worthy of being recommended in Taiyuan market. central air conditioning,air conditioning of variable refrigerant volume,air-line system,air-to-water heat pump

它具有普通分体空调和中央空调的双重优势，在价位的取向上主要是针对较高收入的工薪阶层、私营企业主、高级白领以及其他高收入人群，虽然目前价位相对普通空调要高，但随着我国市场经济的高速发展、人民生活水平的

The static model of torsion joint is based on that of bending joint. The effects of structure parameters inside air pressure, initial angle, rube average radius, rube shell thickness on the turning angle are analyzed and the following conclusions are drawn: the relationship between the angle of torsion joint and the inside air pressure is basically linear, the angle of torsion joint increases with the initial angle and rube average radius, the angle of torsion joint decreases while the rube shell thickness increases. The kinetic equation is built for torsion joint. Simulating experiment implies that the time of inflating and deflating process is extremely shorter than that of kinetic process. So the pneumatic process can be ignored in actual system design and control. The factors that affect the dynamic features of torsion joint, such as shell thickness of rubber tube, average radius, initial angle, connector's outlet area, moment of inertia and viscous damping coefficient, are analyzed and the following conclusions are drawn: the change of rube shell thickness has no effects on the dynamic process of FPA inside air pressure while greatly affects the turning angle of torsion joint; when the rube shell thickness is small, the torsion joint has a bigger turning angle, no overshoot and long risetime, when the shell thickness is big, the turning angle of torsion joint is small, but has high response speed, overshoot and low shock; when the rube average radius increases, the turning angle of torsion joint increases and the overshoot increases too; when the initial angle of torsion joint is big, the turning joint is big, the overshoot is small and shock is low, but the risetime is big; the connector's outlet area affects the dynamic process of FPA inside air pressure greatly, but has no effects on the dynamic process of turning angle; moment of inertia and viscous damping coefficient have no effects on the dynamic process of FPA inside air pressure, but affect the dynamic process of turning angle greatly.

在弯曲关节模型推导的基础上，建立扭转关节的静态模型，并分析了扭转关节内腔压力，初始转角，橡胶管平均半径，橡胶管壁厚等参数对关节转角的影响，得出扭转关节的转动角度与充入FPA内腔的压缩气体压力之间基本呈线性关系，扭转关节的转角随初始角度和橡胶管平均半径的增大而增大，扭转关节的转角随橡胶管壁厚的增大而减小的结论；建立了扭转关节的动力学方程，仿真实验表明FPA的充放气过程与扭转关节的动力学过程相比时间极短，在实际系统设计和控制过程中可以忽略不计；分析讨论橡胶管壁厚，平均半径，初始角度，气体节流口面积，转动惯量，粘性阻尼系数等因素对扭转关节动态特性的影响，得出橡胶管初始壁厚的变化对扭转关节FPA内腔压力的动态响应几乎没有影响而对关节转角的响应曲线影响比较明显，壁厚较小时，关节可以得到较大的转角，并且转角的响应曲线没有超调，但上升时间长，壁厚较大时，关节转角变小，响应加快，但是有超调和轻微振荡现象，橡胶管平均半径越大，得到的关节转角越大，但是转角响应的超调量也随之增大，FPA的初始角度越大，关节的转角越大，并且超调量减小，振荡减弱，但是上升时间增大，管接头出口面积的大小对关节FPA内腔压力的建立过程影响较大，但对关节转角的动态响应几乎没有影响，转动惯量和粘性阻尼系数对FPA内腔压力的动态过程几乎没有影响而对扭转关节转角有较大影响等结论。

The experiment results prove that the boiler coking is largely reduced and the temperature difference of two sides of horizontal gas-pass is very small, when the 330MW boiler operate, the pressure of primary hot air parison is controlled beyond 12.0～12.5KPa, the O2 content of air pheheater is controlled about 3.0%, the door of OFA is opened to 30%, the buffle of the inner secondary air sleeve is adjusted to the minimum, the outer secondary air swirling strength and the baffle of the outer secondary air sleeve is regulated to the maximum and the outlet temperature of pulvervised mill is kept in 70℃.

试验结果表明，330MW运行时，一次热风母管压力控制在12.0～12.5kPa以上、空气预热器实际氧量控制在3.0％左右、燃尽风门开至30％、内二次风量套筒挡板调整在最小、外二次旋流强度和外二次风套筒挡板调整到最大、磨煤机出口温度维持在70℃，此时锅炉结焦大幅度减轻，水平烟道两侧烟温差非常小。优化试验完成后，进行了单烧灵武烟煤对比，结果是：掺烧高灰熔点的银北煤后，炉膛结焦大幅度减轻，锅炉过热器减温水量较小，主蒸汽压力易提高，带负荷能力正常；再热器烟气挡板开度较大、减温水量较小；风机电耗较小。

Before the teaching activity, students' misconceptions of "air" concept mainly be, the student thinks the air isn't a kind of material, so the air isn't condensability, don't occupying space, and can't speaking out air current can be become common practice with form, its cause was that: the basic concept for air's quality was wrong and students always conducted incorrect judgment due to the ambiguity of literate meanings.

本研究的结果发现：学童在教学活动之前，有关「空气」的迷思概念主要是，学童认为空气不是一种物质，所以空气不可压缩，不占有空间，并无法说出空气流动可以形成风；其成因是：气体基本性质概念错误和常因字义不清而下判断错误。

Some parameters such as Indoor radiation heat transfer, convective heat transfer, MRT, OT, radiation heat transfer coefficient, convective heat transfer coefficient, and PMV-PPD were calculated under a steady condition. From the result, we can conclude, when operation under the combination system and worst-case test, if floor temperature is about 21℃, supply air temperature is 21℃, air velocity is 1m/s, the equlvalent coefficient of heat transfer between floor temperature and OT is 13.6w/m2k, where 5.68w/m2k is equlvalent coefficient of radiant heat transfer, 9.48w/m2k is convective heat transfer coefficient. And when air velocity is higher, supply air temperature is lower, the radiant heat transfer between floor and others is lower. In the whole experiment, the floor temperature was keeping above the indoor air dew point, and condensation was not appeared.

通过分析计算，在复合式系统运行中，最不利室外环境下，当地面温度维持在21℃左右，送风温度21℃，送风风速1m/s，此时地板对作用温度的当量综合换热系数为13.6w/m2k，其中当量辐射换热系数为5.68w/m2k，对流换热系数为9.48w/m2k，并且送风速度越高、送风温度越低，地板与其他壁面的辐射换热量有一定程度的降低，但总供冷量增加；在整个实验中地板温度始终高于地板上层空气的露点温度，并未发现有结露现象；室内空气温度梯度能满足0.1m-1.1m的温差小于3℃的要求，并且适当提高送风温度可以进一步提高人体的热舒适性。

The work of this paper is as follows: 1. Looking back the progressing history of the linear motor, introducing the features of the elevator driven by linear induction motor, radicating the topic of this paper "the digital frequency variable control of the elevator bi-side direct driven by linear induction motor". The research of this paper covers the conventional VVVF control, space vector based VVVF control, vector control and DTC.

本文主要开展了以下几个方面的工作： 1 回顾了直线电机发展历史，电机的驱动技术演变，特别是针对直线电机的驱动，简要介绍了直线感应电机驱动电梯的优点和不同结构类型，对传统的v／f控制，基于空间矢量法的v／f控制，矢量控制，和基于电压空间矢量的直接转矩控制进行了比较，确立了本课题的研究主题：直线感应电机双边直推式驱动电梯的全数字变频控制。

The article combines with the treatment of a superficial civil air defense work to introduce how the grouting method to improve the performance of the backfill soil.

文章从治理漂浮人防工事的角度提出了注浆技术在改善回填土性质方面的应用，并详细阐述了注浆技术的施工流程。