查询词典 admissible deformation

The results show that BFRC has favorable impact compressive strength and deformation;,and the impact compressive strength and deformation of BFRC is relational with strain rate and fibre volume content; with strain rate increasing, impact compressure strength and deformation enhance; the impact compressure strength of BFRC is better when the fibre volume content is 0.1%, and the deformation performance of BFRC is better when the fibre volume content is 0.3%.

研究结果表明，BFRC具有良好的冲击压缩强度和变形性能，且其冲击压缩强度和变形与应变率和纤维掺量有关；BFRC的冲击压缩强度和变形随应变率的增大而增加；纤维掺量为0.1%的冲击压缩强度较高，纤维掺量为0.3%时的变形性能较好。

The total effect of the load of the water mass on statical deformation consists of the statical elastic deformation in rock medium resulting from the water load, the deformation of the gravitational equipotential surface caused by the water mass, and that resulting from elastic deformation.

水体质量荷载的静力学形变总效应包括：荷载引起的地基岩石介质的静态弹性形变，质量引起的重力等位面形变以及静态弹性形变所引起的重力等位面形变。

The research results show that stiffness ratio of superstructure and ratio of damping and stiffness in isolated story have great influence on local deformation of structure. It can reduce the local deformation and increase entirety of structure effectively through rational laying rubber bearing and adjusting distribution of stiffness and damping in isolated story. The specific conclusion of the paper is that local deformation of isolated structure becomes minimality when translational stiffness ratio of superstructure is consistent with stiffness ratio of isolated story; and it also can reduce local deformation of minor structure by reducing damping ratio of isolated story properly.

本文研究表明，上部结构的刚度比及隔震层的刚度和阻尼比对结构的局部变形有着很大影响，通过橡胶垫的合理布置，调整隔震层的刚度和阻尼分布，能有效的减小结构的局部变形，提高结构的整体性，从而使隔震效果得以确保；本文的具体结论是，当上部结构的侧移刚度比与隔震垫刚度比一致或相近时，隔震结构的局部变形最小；适当减小子结构的隔震层阻尼比可减小该子结构的局部变形。

As for coseismic deformation of Chi-Chi earthquake, the footwall of Chelungpu Fault moved southeastwards 0.3-1.5 m, and the value was increasing toward the fault; the hanging wall moved northwestwards 1.4-7.0 m, but the value was smaller south of the Choshui River. After the Chi-Chi earthquake, the hanging wall of Chelungpu Fault was still moving west-northwestwards and kept uplifting, while the footwall gradually changed direction from ESE to WSW or even WNW, clockwise resuming to inter-seismic deformation pattern. It is interesting to notice that despite the largest coseismic deformation in the northernmost segment of Chelungpu Fault, the post-seismic deformation peaked around the epicenter of Chi-Chi earthquake.

集集地震之同震变形，在车笼埔断层下盘向东南方向位移0.30~1.5 m，且越靠近断层位移量越大；车笼埔断层上盘则向西北方向大幅位移约1.4~7.0 m，浊水溪以南的位移量较小；集集地震以后之震后变形型态，以车笼埔断层为分界，上盘在震后向西北西方向位移的型态仍与同震时相同，下盘由同震时一致性的向东南东方向，逐步向西北西或西南西方向位移，亦即在车笼埔断层下盘有逐步依顺时针方向回归至震间的滑移型态；另就位移速率而言，虽然同震变形最大地区在车笼埔断层北端，但其震后的变形量最大地区，却集中於震央位置附近；就地震循环而言，震后的6年期间仍处於地层压密重整阶段，尚未回归至该区震间阶段的位移状态。

The research results imply that the regional tectonic stress field has resulted in deformation and flow of upper mantle material with clockwise rotation,and make the alignment of upper mantle peridotite lattice parallel to the direction of material deformation. The deformation of the crust and upper mantle is possibly vertically coherent deformation.

研究表明青藏高原东北缘上地幔物质在区域构造应力场的作用下，发生了顺时针旋转的形变以至流动，使得上地幔中橄榄岩的晶格排列方向平行于物质形变或流动方向，上地幔变形和上覆地壳变形可能存在垂直连贯变形特征。

It was shown that the 3D deformation in the tunnel at soft rock was obvious at F7 fault and phyllite section, with the characteristics of large deformation and longitudinal displacement developing in the opposite direction of work face and being stable at a distance about 2.0 times of tunnel diameter from the work face. And the 3D displacement of tunnels at F7 fault zone developed in an uneven symmetrical way, while there was good consistency for 3D deformation at slate section. Furthermore, there was a mutally verifying relationship between 3D deformation and ground stress distribution of tunnel region.

结果表明，F7断层和千枚岩地段软岩隧道三维位移十分明显，具有隧道大变形特性，其纵向位移背离开挖面方向发展并在相距开挖面约2.0倍洞径时趋于稳定状态；F7断层地段隧道三维位移呈不均匀对称地发展变化，而板岩地段三维位移变化的一致性较好；隧道三维变形规律与隧道区域地应力场的分布存在相互印证关系。

The Huade Group underwent at least two phases of deformation:the early phase of deformation gave rise to ENE-trending synclinorium and the late phase was marked by tectonic superimposition,forming NNW-trending folds. The main phase of deformation likely occurred in ~2.0 Ga B.P.The deformation of the Huade Group is related to a Paleoproterozoic orogenic event along the northern margin of the North China Craton, which has great significance for the study of accretion and breakup of the North China Craton.

化德群经历了两期构造变形，早期为北东东走向的复式向斜，晚期又遭受了构造叠加，形成了北北西向褶皱构造，其主期变形可能发生在2.0 Ga左右，它的褶皱造山是华北克拉通在古元古代向北增生的体现，这对研究华北克拉通的增生，裂解具有重要意义。

The fracture mechanism of totally austenite TWIP steel (steel 5#) is: the moving of dislocations is blocked by twin boundary during deformation. Micro-voids nucleate at boundary of deformation twins by the interaction between deformation twins and dislocations. Micro-voids are formation, growth, coalescence and break by the stress concentration during deformation.

全奥氏体的TWIP钢（如5＃钢）的断裂机制为：形变过程中位错的运动受孪晶界的阻碍，形变孪晶与位错的交互作用使微孔形核于孪晶界处，应力集中使微孔长大、聚合直至材料发生断裂。

Since the lengths of the line segments and the angles between line segments are treated as representation parameters, it is convenient to construct energy function and to deal with displacement and length constraints. Based on this advantage, a parametrical model for human body is proposed, which can easily produce human body models with different feature sizes. The above method is just suitable for polylines. Therefore, a generic deformation method for both discrete curves and surfaces is presented. The energy function is constructed by analyzing the relationship of the points before and after deformation. Together with the displacement constraints, the deformation problem is converted to a convex quadratic programming. A necessary condition for constraint points and a sufficient condition for the uniqueness of solution are given. The proposed method can be combined with skeleton-driven animation to control the deformation.

将线段长度与线段之间的角度作为表示参数，既有利于能量函数的构造，又便于处理位移约束和长度内蕴约束条件，利用这一优势，将其应用于三维人体的参数化建模，可以方便地产生具有不同特征尺寸参数的人体模型，由于这种方法只适用于折线变形，具有较大局限性，因此，本文进一步提出一种较通用的离散曲线曲面变形方法，通过分析变形前后的位置关系来构造能量函数，再加上位移约束条件，将变形问题转化为一个凸二次规划问题，并且给出了约束点应满足的必要条件及模型解唯一的充分条件，这种方法还可以与骨架驱动变形的思想相结合，能更好的控制变形。

It is found that thrusting deformation in the accretionary prism is accommodated not only by deformation within largescale thrusting zones, but also by deformation along secondary thrusts and potentially more importantly along corescale structures such as microfaults and deformation bands.

发现逆冲变形不是只在大尺度的逆冲断层面上进行，而是弥散分布在主逆冲断层面、次级逆冲断层面以及断层面之间的更小的尺度上。

The use of the web to spread fears that flicking the switch on the LHC could create a Black Hole that could swallow up the Earth particularly concerned him, he said.

他说，使用互联网散布恐慌说启动LHC会生成一个可能吞噬地球的黑洞的做法让他感到忧虑。

Not a single word have I written down.

我一个字也没有写下来。